Question about 2002 Dodge Intrepid

Open Question

2002 Dodge Intrepid Radiator hose diagrams

Need a digram of the Lower Radiator Hose. I have a leak. When I put water in the resevoir, it run out at the bottom of the engine somewhere. I can't tell where it is coming from.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 77202 Answers

SOURCE: how to repair the housing the upper radiator hose

it is not safe to repair this part, if it fails and you loose your coolant the engine is ruined very quickly from overheating, replace it.

Posted on Jul 25, 2009

Ad
motor1258
  • 6674 Answers

SOURCE: 2004 dodge intrepid running hot. i change the

Did you start engine when cool, radiator cap off, and heater on when you refilled system after thermostat change? I will normally allow coolant to circulate with cap off for at least, 2 or 3 times rad fan comes on & off, before I will put rad cap back on, and always make sure heater is on when doing it, and top up rad as needed while doing it. Are you 100% sure thermostat is in correct? Water pump may be bad, but I'd check everything else good first. Just looking in rad while engine running from cool & watching temperature gauge, for thermostat to open, which should show more flow in rad. What was original problem anyway?

Posted on Aug 23, 2009

  • 7353 Answers

SOURCE: 2002 dodge 1500 Changed radiator, thermostat, and hoses. No heat

Why was radiator replaced?Did it have heat before ? If it was plugged, the heater core may also be plugged. Try flushing it with a water hose in both directions. I dont know why the botton radiator hose would be cold, the radiator should be a uniform temp and the air coming through the radiator should be HOT, when the engine is at operating temp. What condition was the old coolant? if it was rusty, the water pump may have lower flow than normal.

Posted on Nov 19, 2009

  • 38 Answers

SOURCE: which hose do I need to replace on my 1996 dodge intrepid

I dont know what its called, but i know what you're talking about, but you'll probably have to cut if off of the head, as it melts to it. These deteriorate quickly, and need replaced. You will have to purchase it from a dealership as parts stores dont carry it. Or try a junk yard, but chances are its as bad as the one you already have. Dont let them give you straight heater hose either, it will kink, some tard gave me some said it'd work, after 10 minutes of telling him it would kink, and taking it home and tryin it, it kinked. Bad idea.

Posted on Jun 14, 2010

  • 514 Answers

SOURCE: i have a 2002 dodge

cooling fan turn on? if it doesn't check the relays, temp. sensor, is the water pump working ok?

Posted on Apr 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a diagram that shows me exactly where the thermostat in a 2002 dodge intrepid with a 2.7 engine is/ in otherwords show me what it looks like in the car


on most vehicles you follow the TOP radiator hose to locate the thermostat ,, But on the 2.7 is at the motor at the Lower hose, I'll try and find you a picture or diagram , here is a step by step link that tells you how to replace it, http://www.fixya.com/cars/t1324836-2004_dodge_stratus_2_7_thermostat

Sep 24, 2011 | Dodge Intrepid Cars & Trucks

2 Answers

2001 kia sportage is over heating but has no leaks. the radiator has been flushed but is very rusty inside. The water is rusty inside the radiator. We have checked the resevoir, it is fine. the water...


Rusty is from running a bad or no mix of coolant. (PH level is off) You may have a water pump that has corroded impellers, and can't move the coolant as well any more. I would start by making sure to flush the engine block again, and make sure you flush water through every possible hose, and where you can get at it.

Jun 14, 2010 | 2001 Kia Sportage

1 Answer

Water leaking from on top of front ingine box


your radiator hose is broken and thats where the leak is coming from pls. change the rad. hose/ fill in colant and start the car.

Apr 07, 2010 | 2002 Dodge Intrepid

3 Answers

Where is the thermostat located on a 2002 intrepid 2.7L


Just follow the lower radiator hose out of the radiator to the thermostat housing.There will also be a heater hose on the housing.You have to remove the dipstick tube and plug the hole so coolant does not get into the oil pan.You also have to raise and support the motor and remove the left engine mount,generator support strut,generator electrical plug,and the transaxle dipstick tube bracket bolt,and the thermostat housing and thermostat.Hope this helps.Good luck.

Dec 28, 2009 | 2002 Dodge Intrepid

1 Answer

How do I do a coolant flush on a 2002 Dodge Intrepid with a 2.7L engine?


well they have a machine but drain coolant as good as possiable with pit **** on radiator and unhook lower coolant hose put back together and fill withh same color coolant 50/50 mix

Oct 18, 2009 | 2002 Dodge Intrepid

1 Answer

What is the quickest way to change a thermostat on a 2003 dodge intrepid


Hello Kalel6877...the "quickest" way is let a shop put it on a hoist and do it...but if you want to tackle this one i'll walk you through it.
Raise your Dodge Intrepid with a jack and lower onto jack stands, or use wheel ramps. Set parking brake and/or chock wheels
Disconnect the negative cable from the battery. Open the drain plug at the bottom of the radiator and drain the coolant into a suitable container.
On Intrepids with 2.7L engines, follow the lower radiator hose to the thermostat housing. Loosen the hose clamp at the end of the radiator hose with a screwdriver and pull the hose off the thermostat housing.
Unbolt the two bolts holding the thermostat housing cover on and pull off the cover. On 2.7L Intrepid engines, it is easier to gain access to the thermostat housing behind the alrernator by working from beneath the engine.
Note the position of the old thermostat and remove. Install the new thermostat with the spring-side facing into the engine. Clean any old gasket residue from inside the thermostat housing cover. Install the new thermostat gasket.
Reinstall the thermostat housing cover and tighten bolts to 105 inch/pounds. Reattach the radiator hose and tighten the hose clamp. Refill the radiator with reserve or new coolant. Reattach the negative battery cable.
Start your Dodge Intrepid and allow it to run with the heater on high until it reaches normal operating temperature. Check radiator hose for leaks and tighten the hose clamp to stop any leaks, if necessary.
Thats about it...jack her down and pat yourself on the back.
Good luck..i hope this helps...please take time to rate me a fixya.

Jul 18, 2009 | 2003 Dodge Intrepid

1 Answer

1997 dodge intrepid running hot!


check first if you are loosing water or cooling fluids on your radiator. There may be a leak or the radiator cap may no longer prevent the steam from escaping. check the radiator fans if they are turning. You can check the fan if it is working by removing the temp sensor at the lower radiator hose. The fan should turn on by then.

Jun 22, 2009 | 1997 Dodge Intrepid

2 Answers

Overheating


Hi. I have put together a guide to help you with this replacement of the thermostat.


Step1 Raise your DodgeIntrepid with a jack and lower onto jack stands, or use wheel ramps.Disconnect the negative cable from the battery. Open the drain plug atthe bottom of the radiator and drain the coolant into a suitablecontainer. Reuse the coolant if relatively new and clean. Step2Follow the upper radiator hose to the thermostat housing in all enginetypes except the 2.7L. In Intrepids with 2.7L engines, follow the lowerradiator hose to the thermostat housing. Loosen the hose clamp at theend of the radiator hose with a screwdriver and pull the hose off thethermostat housing. Step3Unbolt the two bolts holding the thermostat housing cover on and pulloff the cover. In 2.7L Intrepid engines, it is easier to gain access tothe thermostat housing behind the alternator by working from beneath the engine. Step4Note the position of the old thermostat and remove. Install the newthermostat with the spring-side facing into the engine. Clean any oldgasket residue from inside the thermostat housing cover. Install thenew thermostat gasket. Step5Reinstall the thermostat housing cover and tighten bolts to 105inch/pounds. Reattach the radiator hose and tighten the hose clamp.Refill the radiator with reserve or new coolant. Reattach the negativebattery cable. Step6 Start your DodgeIntrepid and allow it to run with the heater on high until it reachesnormal operating temperature. Check radiator hose for leaks and tightenthe hose clamp to stop any leaks, if necessary.

  • Removethe alternator drive belt and bolts holding the alternator in place andset the alternator aside for easiest access to the thermostat in DodgeIntrepid 2.7L engines, if desired.
  • Don't drain the coolant from your Dodge Intrepid while the engine is hot.
Please rate and god bless.

Mar 26, 2009 | 2000 Dodge Intrepid

1 Answer

Upper Radiator Hose on 02 Dodge Intrepid 3.5L


you should only have to remove the plastic filter holder and the hose is right there on top of the motor.the plastic breather/filter cover is the only thing you should have to remove to get to the hose

Jan 18, 2009 | 2002 Dodge Intrepid

Not finding what you are looking for?
2002 Dodge Intrepid Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...