Question about Ford Mustang

Open Question

2007 ford mustang blower motor does not come on,,replaced motor resistor and heat and air control panel...??

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76118 Answers

SOURCE: blower motor resistor

It is under the hood in the heater case (passenger side), the right side of the case near the firewall as you face the engine.

Posted on Sep 02, 2008

Ad
  • 5 Answers

SOURCE: 1999 KIA Sportage, 2WD. No heat, fan, A/C

did you check the switch to the control cluster ? incase you dont know what im talkin about the switch that turns it on and off and adjusts speed? if its not that then do you have a blown fuse becouse the blower moter has an independant fuse some times in the fuse box there may be 2 1 in the car and the other under the hood try that let me know if its fixed

Posted on Dec 13, 2008

MacGyver911
  • 42 Answers

SOURCE: Where is the blower motor resistor on a 2003 Chevy Malibu

Remove the shroud below glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the purple/black power connector to it - - you'll need this extra room to work with. 2 more screws, same size, 6.5mm on mine, 7or 8mm on some others, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage - up to $400, what a sham.

Posted on Mar 19, 2009

  • 316 Answers

SOURCE: blower motor resistor

The blower motor resistor is located near the blower motor. It is held in place by 2 screws, and has a wire clip connected to it. Very simple fix.

I hope this helps you, and I wish you luck on your repair.

Posted on May 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 mustang blower motor resistor location


The blower motor resistor can be accessed from below the RH side of the instrument panel.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the 2 blower motor resistor screws.
  1. Remove the blower motor resistor.
  1. To install, reverse the removal procedure.

Feb 21, 2015 | 2005 Ford Mustang V6

1 Answer

I cant find the heater resistor in my 2007 ford freestyle. have the glovebox out already


Do you manual or automatic heating control ? manual has resistor ,automatic has blower motor speed controller ! You did not need to pull glove box. You have to pull the lower panel under glove box .
  1. Remove the RH lower instrument panel insulator.
  1. Disconnect the blower motor speed control electrical connector.
  1. Remove the 2 blower motor speed control screws.
  1. Remove the blower motor speed control.
  1. To install, reverse the removal procedure.

Feb 14, 2015 | Ford Cars & Trucks

1 Answer

96 mustang blower works sometimes


look for the blower motor resistor under the dash on the passenger side, in the air duct you should see a plug with about 5 wires connected to the resistor.

Feb 14, 2015 | 1996 Ford Mustang

1 Answer

2007 ford freestar their is no blower operation resistor board is okay replaced blower


you may have to have the GEM module checked out as I believe it controls heater control operation.

Aug 29, 2014 | 2007 Ford Freestar Limited Minivan

1 Answer

How to test blower motor switch 1995 mustang


check the connections at the rear of the control panel . check for power at resistor there is a blower relay

Jun 30, 2012 | 1995 Ford Mustang

1 Answer

Heater switch replacment


Hello! it's my job to make things as easy for the customer as possible...Therefore I must ask why you want to replace the heater switch? Is it because you have lost one or two of the switch speeds? Your vehicle is noted for loss of the Blower Motor Resistor...
Changing the Heater switch means removal of the Climate Control Assembly which is not the easiest of jobs...I've included the process...But are you sure the blower resistor is OK? If you have lost 1,2, or all blower motor speeds it's more than likely the Resistor pack. And a lot easier to change...
Guru...saailer


Remove climate control:





12_26_2011_2_15_09_am.gif
  1. Remove the instrument cluster finish panel...
  1. Remove the 3 climate control assembly screws...
  1. Disconnect the climate control assembly vacuum connector...
  1. Disconnect the 5 climate control assembly electrical connectors...
  1. Remove the climate control assembly..
Removal of blower motor Switch:
  1. Remove the climate control assembly.
  1. Remove the blower motor switch knob.
  1. Remove the blower motor switch.
    1. Remove the screw.
    1. Remove the blower motor switch.

Removal of blower motor Resistor:


12_26_2011_2_22_49_am.gif
Blower Resistor is under the battery tray...

MOTORCRAFT Part # YH1698 ...cost $25

12_26_2011_2_28_50_am.jpg

Guru...saailer

Dec 22, 2011 | 2007 Ford Econoline

2 Answers

Heat and air condition only blow when the control is turned up to high position. And I even tryed replace the control panel.


this problem is caused by the blower motor speed control resistor, it is located near the blower motor, the resistor end goes into the air duct for cooling, replace this p[art and the problem will be solved. See pitcure below, the part is about $13



67a2d30.jpg

Sep 23, 2010 | 1996 Dodge Caravan

1 Answer

Rear cooling and heating blower motor does not work


its not in the headliner. its under the side panel in the rear on drivers side. you half to remove the panel on the inside just above the rear tire. since the moter runs sometime i would replace the blower motor resistor first cause these are known for going bad and its in the same area as the blower motor. this resistor controls the fan speeds and if its gone bad the fan dont run right. plus its alot cheaper than blower motor. once you have replaced the resistor you can turn the fan on and see if its a fixya before putting the panel back in place.

Apr 24, 2009 | 2001 Ford Windstar

1 Answer

I have a 2000 ford E350 van with front and rear air. the front blower motor runs at low speed, The front blower still runs on low even when the knob is set on medium or high. I do not know where the...


it's either the blower motor switch or blower motor resister. Resistor ?Heater Blower Motor Switch Removal Remove the battery (10655) ; refer to Section 414-01 . Remove the battery tray. Remove the screws. Remove the battery tray. Disconnect the heater blower motor switch resistor connector. Remove the heater blower motor switch resistor (18591). Remove the two screws. Remove the heater blower motor switch resistor. ----------------------------------- Switches Removal Disconnect the battery ground cable. Remove the center trim panel; refer to Section 501-12 . Remove the control assembly. Remove the screws. Remove the control assembly. Remove the A/C-heater function selector switch knob. Disconnect the vacuum harness connector. Disconnect the A/C-heater function selector switch connector. Remove the A/C-heater function selector switch. Remove the screw. Remove the A/C-heater function selector switch. Remove the temperature control switch knob. Disconnect the temperature control switch connector. Remove the temperature control switch. Remove the screw. Remove the temperature control switch. Remove the heater blower motor switch knob. Disconnect the heater blower motor switch connector. Remove the heater blower motor switch (18578). Remove the screw. Remove the heater blower motor switch. ----------------------------

Mar 31, 2009 | 2007 Ford E-350 Super Duty Length XLT

1 Answer

5 amp fuse in passengers fuse panel keeps blowing


It also feeds the overhead console.Suspect that is were your problem is.

Feb 07, 2009 | 2005 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

318 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...