Question about 1995 Oldsmobile Cutlass Supreme

1 Answer

Replacing oil pump in 95 Cutlass 3.1L

I need to replace the oil pump in the car. Any hints on what all needs to be done. So far I have removed all pan bolts, removed torque bars and on front one the bracket and air compressor. Un-did nuts on rear motor mount. front motor mount removed bottom nuts. I also removed the front exhaust manifold. I though I could get the engine to move but nit yet. Any help would be greatly appreciated.

Posted by on

  • 1 more comment 
  • bdsnyder Jan 03, 2009

    Do I need to remove any of the drive train? on either side? Thanks so much

  • bdsnyder Jan 04, 2009

    Hello again,

    Do I have to lower the suspension to clear? I have the pan loose and engine up but cant seem to get it past the suspension on the front and transmission drivelineon the back side.

    The info you gave me the other day all workd though.

  • Anonymous Mar 30, 2009

    How much oil do you put in a 1995 Cutlass Supreme when changing the oil and oil filter?



×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

YOU WILL HAVE TO REMOVE THE EXHAUST PIPE IN THE REAR.IT HITS THE FLOOR PAN.ALSO REMOVE THE TWO DOG BONE MOUNTS ON TOP IF THIS ONE HAS THEM

Posted on Jan 03, 2009

  • ROBERTW74 Jan 03, 2009

    ONCE YOU HAVE ALL THAT OFF JUST RAISE THE ENGINE.YOU ALSO HAVE SIX BOLTS THAT GO IN THE SIDES OF THE PAN.THREE ON FRONT AND THREE IN BACK.IT WILL COME OUT WITHOUT ANY DRIVE TRAIN REMOVAL

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil pan gasket and front crank seal replacement on 2000 dodge 2500 van 5.2l


Drain coolant,pull radiator,fan shroud off.Need a fan tool to get that off.Need to pull ac,alt,ps and brackets off. to expose front of engine. Need crank pulley puller. Once that's done the timing cover can be removed. Hint,spring for a new timing set. loosen engine mounts and lift engine at bell-housing remove oil pan bolts.and reverse.Might as well replace oil pump if you intend to keep the van.

Oct 17, 2013 | 1998 Dodge Ram 1500 4WD

4 Answers

How much will it cost to replace the oil pump in a 2005 dodge neon


An oil pump for a Dodge Ram 2010 3500 cost: $111.20!!!
In this age of high gas prices, drivers who care about gas consumption are taking an interest in the Dodge Neon and buying top quality parts. When contemplating sturdy build and long lasting performance you want a stylish car from Dodge. For hardworking quality and styling from a vehicle, car lovers can believe in Dodge.

If an issue develops or a component needs to be replaced, don\'t economize with a second-rate part. A Dodge Neon is worth genuine OEM and aftermarket parts to function at top efficiency. When you wisely choose a trustworthy, historic Dodge, there\'s no doubt you\'ll get superb style. For decades Dodge has engineered heavy-duty and reliable cars that car buyers can count on to get the job done. For eye-catching style with tons of power car enthusiast turn to Dodge for their sporty vehicle needs. To maintain the resale value and luxury you bought with your Dodge Neon, it\'s important to select only the most reliable high-value car parts. Frugal people just need a sensible vehicle like the Dodge Neon. The Dodge Neon is a vehicle engineered for high performance and it requires the best quality auto parts. Excellent horsepower and automotive performance are derived from great parts and accessories.

The Dodge Neon Oil Pan is fitted to the bottom of the motor and encloses the sump which retains oil as well as the oil pump. Your Dodge Neon Oil Pan is used as a receptacle for the oil. Your vehicle\'s Dodge Neon Oil Pan retains oil in reserve and is frequently made from steel or aluminum and has an oil pan gasket to stop leaks. Your car or truck\'s Dodge Neon Oil Pan is bolted on the underside of the car or truck and supports the oil pump unit. Dodge Neon Oil Pans are important to lubrication and if they are old, your car\'s motor will definitely sustain damage. The Dodge in your carport was made using care and skill; it should have replacement components of the same high level of value. One website which makes finding affordable parts easy is PartsGeek.


18256-01144165-1085557.jpgThey are available for the following Dodge Neon years: 2005, 2004, 2003, 2002, 2001, 2000, 1999, 1998, 1997, 1996, 1995, 05, 04, 03, 02, 01, 00, 99, 98, 97, 96, 95. This part is also sometimes called Dodge Neon Engine Pan.

We stock these Oil Pan brands for the Dodge Neon: Mopar, Dorman and Replacement.



Nov 19, 2011 | 2005 Dodge Neon

1 Answer

How do i change the oil pump on a 1992 cutlass ciera


YOU NEED TO REMOVE OIL PAN TO REPLACE OIL PAN.

Jun 22, 2011 | 1992 Oldsmobile Cutlass Ciera

1 Answer

I think I have to replace my oil pump on my 1996 olds cutlass supreme ,how do I find the oil pump


the oil pump is inside the engine. Inorder to get to it you will need to drop the a frame and then remove the oil pan. Its not a easy job at all and its my reccomendation that you take it to a shop.

Dec 29, 2010 | 1996 Oldsmobile Cutlass Supreme Coupe

1 Answer

How do i change the oil filter on a 1991 cutlass calais? any special tools?


YOU NEED 4.5 QUARTS OF OIL WITH NEW OIL FILTER.YOU NEED OIL FILTER WRENCH YOU NEED WRENCH TO REMOVE OIL DRAIN PLUG.YOU NEED A DRAIN PAN CATCH OLD OIL.NEED LATEX GLOVES TO KEEP GETTING OIL ON HANDS.OIL DOES CAUSE SKIN CANCER.NOW YOU CRANK CAR UP LET IT IDLE 5 MINUTES TO LOOSEN UP OIL AND SLUDGE.TURN OFF ENGINE.SAFELY RAISE SUPPORT VECHICLE ON LEVEL SOLID GROUND USING JACK STAND.PLACE DRAIN PAN UNDER OIL PAN THEN REMOVE OIL DRAIN PLUG LET OIL DRAIN OUT UNTIL IT STOP DRIPPING. PUT OIL DRAIN PLUG BACK IN OIL PAN. THEN SLIDE DRAIN PAN UNDER OIL FILTER REMOVE OIL FILTER LET OIL DRAIN UNTIL IT STOP DRIPPING.TAKE CLEAN PAPER TOWEL WIPE OIL FILTER SEAL SURFACE MAKE SURE NO DIRT ON SURFACE.TAKE NEW OIL FILTER POUR NEW OIL IN FILTER UNTIL ITS ALMOST AT TOP THEN.RUB CLEAN OIL ON NEW OIL FILTER SEAL.THEN PUT NEW OIL FILTER IN PLACE HAND TIGHTEN IT.POUR 4 QUARTS NEW OIL IN ENGINE CRANK CASE USING A FUNNEL.WHEN DONE.CRANK THE ENGINE CHECK FOR LEAKS AT OIL FILTER AND OIL DRAIN PLUG.IF ALL IS GOOD JOB WELL DONE.

Aug 11, 2010 | 1991 Oldsmobile Cutlass Calais

1 Answer

Need to replace gasket on the external oil pump, 95 tauras 3.8 v6


I owned a 95 Taurus for several years and done my own maint. I never heard of an external oil pump. The pump is in the oil pan and runs off the cam shaft. To replace it you have to pull the oil pan. After that it is fairly easy. Take out the bolts and it will come out. There are no springs to worry about.If you were talking about some other pump let me know.

Jan 24, 2010 | 1995 Ford Taurus

1 Answer

Need to replace water pump-do I need to remove motor mounts or am I looking at it wrong? Shortguts/hints?


Well if you have small hands..you dont need to remove that front mount, but it's probaly best you do, so you have more room to work on it..and if you do remove it, make sure you have a jack with a wood block underneath the oil pan, so that the engine wont drop to far down..and you can raise it up a little if you want to....Goodluck..

Dec 04, 2009 | 1998 Buick Park Avenue

2 Answers

How to change oil pump


drain oil and filter remove.
Drop oil pan under engine.
Un bolt oil pump and re install new pump fill new oil and filter and gasket , cap , start engine test for leaks shut down re check oil level.
Vitally

Sep 10, 2009 | 1998 Oldsmobile Cutlass

2 Answers

Need to replace the oil pump on a 95 park avenue


You shouldn't have to for head gaskets, makes it easier but not necessary.
For oil pan, you may have too. Depending on how much room there is between pan and crossmember and if pan is in tranny. Some cars the oil pan is 1/4" behind tranny but don't think that is the deal on your car.

You can go to auzone.com and register for free. and you will have an AWESOME Full Free Online Repair Manual with everything you could need plus much more!

Aug 26, 2009 | 1995 Buick Park Avenue

1 Answer

Replacing oil pump on 92 4x4 isuzu trooper


undo engine mounts jack engine up as far as it will go

Nov 19, 2008 | 1992 Isuzu Trooper

Not finding what you are looking for?
1995 Oldsmobile Cutlass Supreme Logo

681 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...