Question about 2001 Nissan Maxima

1 Answer

2001 maxima 5sp won't go in gear when car started

Goes in gear when car turned off

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There is a black hose with a metal like hose attach on each end, right above you manual gear box. It can be seen a little from above but better from under neath the car engine on the right hand side. check to see if the hose look wet from oil like substance, if thats the case you found the problem. If not check your "Master cylinder or Slave cylinder mite be back. I have the same problem, when the fluid leaks the clutch is unable to build the pressure needed to out the car into a gear. Hope this helps. (>:

Posted on Dec 15, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
MrScary66613
  • 1990 Answers

SOURCE: 2001 Nissan Maxima SE-rattling noise for 4 min after start

This only happens when the Car is Cold???? It is the Exhaust Manifold. You need to Replace the Exhaust Manifold Gasket and check the Rest for Tightness.

Posted on Jan 20, 2009

  • 100 Answers

SOURCE: 2001 nissian maxima se low idle

adjust the idling, if too low then it can't sustain the power needed to keep the engine running when it engages.

Posted on Apr 24, 2009

  • 295 Answers

SOURCE: Gear Shift gets stuck on Maxima 2001

The gear shift electrical relay or module inside it is not reading the signal to release. You need to have the electronic relay or module repaired or the gear shift assembly replaced.

Posted on Jul 16, 2009

pippall
  • 1486 Answers

SOURCE: Nissan Maxima 2001 panic alarm goes off every 30 min

Replace the baterry to deactivate it.Thats the only way your going to do it.

Posted on Aug 04, 2009

  • 228 Answers

SOURCE: 2000 nissan maxima won't fire

sounds like it might be flooded. Try and remove the fuel pump fuse from the fuse block that is just in front of your left knee. While it is out crank the car and see if it wants to start and hold down the gas pedal all the way and then relase it and back and forth and once you get it to run have the fuse ready in your hand and in front of the spot to install it. and then keep the rpm's up with the gas pedal until the smoke clears out behind the car.

Posted on Jul 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car won't start just click


Have you checked to see if you can turn the crank with a wrench ?
And are the cables good from the battery to the starter ?

Jun 20, 2013 | 2001 Oldsmobile Alero

5 Answers

1996 nissan maxima won't start, battery is charged but engine does't crank when I turn key


first will be starter try to tap starter if start is a starter problem.sometimes charged is not good is weak.try to boost.Battery connection.

Feb 27, 2013 | 1996 Nissan Maxima

1 Answer

My 1999 nissan maxima 5 speed won't shift from 1st to second gear.


If it goes into other gears correctly, then the issue is likely a synchromesh problem with that particular gear, and the gearbox may have to be stripped.
You may try changing the gear oil first though, as this can often fix the issue without having to spend too much money on unnecessary repairs.

Nov 16, 2012 | 1999 Nissan Maxima

1 Answer

The transmission was repaired and after it got install it won't start up . It's a windstar 2001. Gas was checked and the line sends it the injectors have juice but it doesn't start . If I


Possible solution will be check all your map sensor if they are plug in probabilty who ever put the transmission did not conect everything may broke a vacum line from the map sensor or you could have a bad ring gear if you trany was replace did they replace fly wheel also?

Nov 01, 2012 | 2001 Ford Windstar

1 Answer

1996 villager vg30e distributor won't turn, gear inside engine does not turn


You have defective camshaft drive timing belt (also runs the distributor). Pull the front cover off the engine and take a look. This is a free running engine and the broken belt will cause no damage to the engine valves in this make, it is a different story in other models like the Maxima.

Oct 18, 2012 | Cars & Trucks

1 Answer

Why won't 2002 maxima seat go forward or backward? Can hear the motor and nothing stuck on track


I would say the cables or rods that go from the motor to the gears are broke or stripped.

Aug 08, 2012 | 2002 Nissan Maxima

1 Answer

2001 Saturn manual stick shift just popped and started wobbling loosely while i was shifting from 1st to 2nd. My clutch works but, the stick shift won't go into any gear


sounds like your washers/bearings/spacers finally degraded. To make sure, pop off the little flexy cover. You will see a linkage that goes straight into the transmission. If the bearings there (the little white plastic ones) look eaten up, that's most likely your problem.

Jun 27, 2011 | 2001 Saturn SC

1 Answer

Just started to pull away from a stop in 1st and


sounds as though your input shaft broke, this would cause a loud clunk, cause it to feel as though in gear, and cause no pull.

Oct 26, 2009 | 1988 Nissan Maxima

Not finding what you are looking for?
2001 Nissan Maxima Logo

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...