Question about 2005 Kia Sedona

1 Answer

2005 KIA SEDONA OUTPUT SHAFT SEAL

I replaced the CV joints in my 2005 kia sedona and when I removed the drivers side joint a bit of trans fluid ran out. I installed the new CV joint and replaced some trans fluid. Everything is running good but I notice that it's leaking trans fluid now. Should I have replaced any seals when I did the replacement of the CV joints?

Posted by on

  • 2 more comments 
  • Phil Nov 02, 2012

    Thanks for your help John. It did have a retaining clip and I used a rubber mallet to help it in. It was leaking around the seal that the axle goes through into the transmission. I have since then removed the sea/shim and now I'm having trouble finding the part. Any suggetions would be appreciated.

  • Phil Nov 02, 2012

    here is a picture of the part and it's locationhttp://www.flickr.com/photos/89570680@N06/with/8147664727/#photo_8147664727

  • Phil Nov 02, 2012

    for the above link you'll have to copy the whole thing or it won't work.

  • Hi Phil, Unfortunately I can't help you with the problem of finding the oil seal. I have no idea where you are in the world and unless you live in Zambia (in the event you're not familiar with the name, it's in Africa) I would suggest you look closely at the seal and copy the part number. If you know of a company specialising in the supply of bearings, they would be your best bet for the supply of a replacement. Regards John

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Kia Master
  • 2,122 Answers

Hi Phil, On the Spyder end of the shaft that fits into the gearbox there is a retaining clip. Did you knock it in securely? If you did then a seal may have become damaged when making the replacement. That will need replacement. Regards John

Posted on Oct 27, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 2005 kia sedona ECU replacement

It's located at the passenger side behind the air conditioner plastic duct (inner firewall)

Posted on Sep 24, 2008

  • 1986 Answers

SOURCE: kia sedona outside door handle replacement

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to get to remove the bolts securing the outer handle on

Posted on Sep 15, 2009

  • 145 Answers

SOURCE: roaring in front end of 2004 kia sedona.

most likely a wheel bearing. to determine which one, lift up the car so wheels are in the air. grab onto the strut spring, and spin the wheel. You should fell roughness in your hand on the wheel that is bad, the good wheel will fell smooth.

Posted on Sep 17, 2009

rogrrabbit
  • 986 Answers

SOURCE: kia sedona steering wheel binds

yes look there and also inspect your track bar, tierod ends, pitman arm ball joint. Have someone turn your steering wheel while you look. the bind or looseness should be evedent. Its a big sysytem to cover.

Posted on May 21, 2010

  • 382 Answers

SOURCE: need to replace water pump in2005 kia sedona

The kia sedona water pump is an internal pump and needs to be replaced with timing belt service. if it is leaking, then you need to change the timing belt as well. probably not something you want to do in the back yard and will run you between 400 and 600 depending on your location and shop.
Visit my Blog

Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you replace the top center dash storage compartment?


Kia Sedona Car & Truck Interior Consoles & Parts ' eBay

www.ebay.com/sch/Kia-Sedona-Car-Truck...Consoles.../i.html
eBayShop from the world's largest selection and best deals for Kia Sedona Car & Truck ...2002 2003 2004 2005 KIA SEDONA CENTER CONSOLE FOLDING TRAY TAN ....Overhead Console 02-05 Kia Sedona with Map Lights Clock and Storage ...

Center Console Removal - '05 Sedona - Kia Forum

www.kia-forums.com/...sedona.../30338-center-console-removal-05-sed...
Nov 11, 2005 - 5 posts - ‎4 authors I need to remove the center console in my 2005 Sedona so I can remove the stereo. ... address lol) so I have to pull the stereo and probably replace it. .... the right side of the pannel, as well as the hazard switch at the top of the ...

Oct 16, 2015 | 2002 Kia Sedona

1 Answer

Removing a Kia Sedona cv boot


the procedure is to remove the axle from the vehicle and fit the proper boot
however as it is a costly procedure , there are replacement boots available from reputable auto spares shops that after the old boot has been cut off , will clip around the cv joint and seal together
there will be fitting instructions in the package and if you follow them to the letter , the replacement boot is as good as a genuine one

Aug 12, 2015 | 2005 Kia Sedona

1 Answer

I cant remove the metal end and spline inside of my kia sedona


Try to get a pry bar or large screwdriver between the CV housing and the transmission case. A little force may be required, but you have to pop the housing out of the transmission. A c-clip in a groove on the splined shaft is holding the shaft in, and must be popped outward, for the housing and shaft to be removed.

Nov 25, 2013 | 2003 Kia Sedona

1 Answer

How to split the outer cv joint to replace the rubber boot


lose the central nut of your wheel first,remove the brake caliber loose two bolts holding your suspension arm in one peace and the lower arm bolt and loose the steering arm ball joint pull the hub up and the shaft out is one peace ,loose rubber boot clean housing and look in side you have sir clip with two holes one on etch site remove it with sir clip players grease the joint fit the new boot good luck.

Sep 09, 2012 | 2004 Kia Sedona

1 Answer

When i turn my wheel to the left only my front right tire makes a nosie


if its a clicking sound only when turning then it sounds like a bad cv joint that needs replacing.replacing the complete half shaft is the best way to fix this.if its a squealing noise then the front end components should be checked and possibly the alignment.

Jun 22, 2011 | 2005 Kia Sedona

4 Answers

I am having tremendous difficulty turning the steering wheel - checked the power steering fluid and it is full -- what else could it be?? Thank you. Cathy Beadnell cathy_beadnell@doh.state.fl.us


This is a known problem and has been increasingly noted by sedona owners. Steering shaft becomes corroded making vehicle steer hard. They say due to salt but if you live anywhere it snows you cant avoid it.

Model/Build Years: KIA / SEDONA 2002-2005
Service Bulletin Number : TSB-019 NHTSA Item Number : 10027724 Summary Description : KIA: INCREASED STEERING EFFORT. IN AREAS WHERE HEAVY ROAD SALT USE OCCURS, INCREASED STEERING EFFORT AND NOISE (FROM STEERING INTERMEDIATE SHAFT) FOR SOME SEDONA. *PE

Jan 13, 2011 | 2004 Kia Sedona

1 Answer

I recently changed the cv axle on right hand side of my 04 kia sedona, the cv axle went into like a mid bearing and had a small shaft from there into the transmission. that seal at the transmission is...


The seal you need is called a transmission/transaxle output shaft seal. The 2 best things to do, either get the number off the original seal and have it matched at a local autoparts store or go to Kia/Hyundai. they will know the proper seal. Be sure to install the seal evenly into the trans or it may leak again. If you need anything further, please let me know.

Nov 23, 2010 | 2004 Kia Sedona

1 Answer

My sedona shakes when we press the gas pedal down, but stops when we let off the gas. We recently had the belts replaced and the problem started just after this. could this be a cv joint problem or...


most likely mount problem either trans. mnt or motor mount. if in gear holding brake in drive or reverse motor moves bad motor mount.. hope this helps!!

Aug 16, 2010 | 2005 Kia Sedona

1 Answer

Cv joint kit


first check the balljoint was tightened properly when the new CV was fitted, otherwise you have to have the balljoint changed, ask the MOT place for a quote.

Apr 01, 2010 | 2002 Kia Sedona

1 Answer

Same Problem here... Kia sedona 2002


Several items can contribute to the shaking of the front end. Bad tires, any slack in the hubs, a bad CV joint, worn tie rods, ball joints. I would first check out the tires and then proceed to searching for components that have worn and have slack in them. Replace as necessary.

Jul 13, 2009 | 2004 Kia Sedona

Not finding what you are looking for?
2005 Kia Sedona Logo

325 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...