Question about 1998 Chevrolet C1500

1 Answer

I have a 2008 chevy suburban. My dash brake light just came on and it beeped the whole time while driving down the road about 2 miles and then back. would stop when vehicle stopped but then started again when driving. Brake fluid is full. Any ideas?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Contributor
  • 25 Answers

Brake light indicater indicates low brake fluid or loss of brake control. Check fluid level.

Posted on Oct 27, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 12 Answers

SOURCE: 2002 Suburban ABS System Brake Light

I have had this same problem on two difference vehicles both of which are suburbans.

The solution is simple.
Remove the engine cover.
Locate a small ground wire that is bolted to the top rear of the engine block on the passenger side.
Remove the bolt, clean surfaces and replace.

This should solve your problem.

I know it seems too easy but it works.

Posted on Mar 02, 2009

emissionwiz
  • 76649 Answers

SOURCE: All brake lights went out on 2004 Chevy Tahoe

the most common cause of this is either a sticking 4 way flasher switch or the turn signal switch itself.

Posted on Apr 07, 2009

  • 1 Answer

SOURCE: 2004 Chevy Impala Brake Problem

I did a complet brake job on my 2004 Chevrolet Impala about two weeks ago, and i still have warning light on. Thw system is working great. So how do I turn off the warning Lights, Traction off light, Brake light, and in warning center Low brake fuild?

Posted on Sep 04, 2009

  • 61 Answers

SOURCE: abs light stays on 1995 chevy pickup

Probably want to check abs sensors on the back side of the wheels. Did you have a abs light on before the brakes where done?

Posted on Feb 04, 2010

  • 12650 Answers

SOURCE: I have a 2008 chevy impala. The car suddenly

ur vehicle is in limp mode[ a safe mode ] which will get u home trying not to cause any damage to engine --theirs a few reasons the vehicle will do this-low oil pressure-transmission problem-have vehicle scanned most auto stores such as auto zone / advanced auto [check ur local area]do this service for free the code gives u a start point towards resolving ur problem

Posted on May 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Chevy impala makes a light beeping sound while I am driving but there is nothing on the dash that warns of a problem. It beeps lightly the whole time I am driving.


that is weird, could be a squeak in your hvac fan, see if it changes with speed of fan, usually a beep is accompanied by a light on the dash as well

Feb 18, 2014 | 2005 Chevrolet Impala

2 Answers

2008 chevy silverado cruise control will not work. once in a great while it comes to life. Brake fluid is full. I'm stumped. It seems like a loose connection but can not narrow it down. One time I was...


having same problem. narrowed it down to brake light switch. going down road and cruise wont set, messed with brake pedal and it will arm have even put foot under pedal and lifted a little and it would arm. have a switch coming to replace.

Sep 09, 2010 | 2008 Chevrolet Silverado 2500HD 2WD

1 Answer

How do I reset the service brakes soon light on a 2008 chevy suburban


{: ) It depends on how serious the fault is. It could be the wirings. However you can at least try these steps. The most important is to check for proper brake fluid level, and carefully inspect for brake fluid leaks. Check also your brake lights if working properly. Also check the parking brakes if the light responds as you engage or disengage the park brake lever.

Aug 27, 2010 | 2008 Chevrolet Suburban

1 Answer

Hello all, I have a 2001 Chevy Suburban 5.3L with 133,000 miles on it. It starts up fine, I put it in drive, it doesn't move, put it in reverse, it backs up, put it back in drive and away we go. The rest...


trannsmission solienoids may be sticking, try some tranx, you can get at the parts store. this stuff is great. it might take a day or two but it works. for the other truck, did you have the front brakes checked, they can bind up, when you back up it frees them up.also, but not probable for 2001 check the brake hoses, they can collapse from the inside, not letting your brakes release all the way good luck

Jun 14, 2010 | 2001 Chevrolet Suburban

1 Answer

92 Chevy Suburban Electrical Fuel System


Check fuel flter at fuel pick-up intank (looks like a small wire sock). Remove fuel filter and fitting at fuel rail. Blow out fuel lines w/about 35lbs air press. Ck electrical @ relay - should be 4 connectors - one is key on hot/one is always hot/one is ground and last is hot to fuel pump. Good Luck

May 03, 2009 | 2002 Chevrolet Suburban

1 Answer

1996 chevy suburban brake lights not working what could it be


Under the dash near the top of the brake pedal on the back side is a switch with 1 or 2 wire connector, it might be stuck in, or you might need a new one.

Mar 13, 2009 | 1996 Chevrolet Suburban

1 Answer

Brake lights won't turn off


sounds like it is a brake light switch located at the brake peddle. test the switch and if it is faulty replace it.

Dec 13, 2008 | 2004 Kia Amanti

1 Answer

I have a 2004 kia amanti and when I was driving I accidently hit the emergency brake and when I notice the light was on I pulled over about a mile down the road. I release the brake and went home, but I...


Hitting the emergency brake's has nothing to with the brake lights on the back of the vehicle , you had to have this problem before an just didn't notice . Are all the brake lights lit ? High mount lamps too.. ? The regular one's are controlled by a BCM - body computer .

Apr 30, 2017 | Kia Amanti Cars & Trucks

1 Answer

1999 Ford Expedition 5.4 V8 Blinking Dash Lights While Driving


sounds like an earth connection ,but where ,,,,back of dash,,,battery earth,,,ECU earth point ,,try putting a drop of oil on the earth points with a conventional oil can no sprays of crappy fish oil other than that you would have to wait for it to happen again in front of a mechinic to find it,.or trade it in for a nice europeon size car with a an engine under 1600cc .5litres is a bit obscene in this day and age and price of petrol

Nov 20, 2008 | 1999 Ford Expedition

Not finding what you are looking for?
1998 Chevrolet C1500 Logo

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...