Question about 2004 GMC Yukon

1 Answer

Where is the knock senser on a 2004 yukon xl & how do I replace it

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,101 Answers

It is located under the intake manifold and there are 2 of them

Posted on Oct 31, 2012


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 438 Answers

SOURCE: where is locate the knock sensor in 2004 yukon xl

There are 2 or them and they are under the intake manifold. The manifold has to be removed to replace them.

Posted on Oct 10, 2009

Testimonial: "TANK YOU +++++++++++++++++++++"

  • 1 Answer

SOURCE: location of fuse box/panel for 2004 yukon denali xl

There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.

The ohter is under the dash and above the pedals, this one is much tougher to access.

Your Owner's Manual should tell you where the fuses are that you need to access.

Posted on Oct 20, 2008

SOURCE: u-joint repalcement for 2001 yukon xl

Mark your drive shaft coincidenly with the rear axle and tranny. Remove drive shaft. Press out the old u joints and press in the new. You will need a torch for heat and a lot of patience. Have fun!

Posted on Jun 20, 2009

  • 3 Answers

SOURCE: I have a 2004 Yukon XL 2500. And have a flat tire.

contact the dealership where you purchased the vehicle

Posted on Nov 29, 2009

  • 176 Answers

SOURCE: 2004 Yukon XL Denali fuel gauge fluctuations

Your sending unit for the guage is part of your fuel pump in the tank. But first try your fuel pump relay, may be working intermittenly when you hit a bump or something. Or possibly a loose wire somewhere along the way. Much less expensive (worth a look).

Posted on Dec 18, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the knock senser on a 2002 lincon ls

Hello Antwan Davis,

It appears to be inside & (b'twix) the heads on top of the engine...

I remember seeing connections for two on MY 2004 Navigator...
(I'm getting pretty old... )

Most folks get "knock" issues by thinking they can get away with "REGULAR" gas...

Simple answer:
They Can't...!!

Simple test... buy some "LEAD FREE" octane booster...
add the recommended amount to your tank...

If the "KNOCK" goes away...You don't have to worry about deeper DAMAGE ...

It is very distinctive looking...

Check out the link below ... Hope THIS HELPS
(OH BY THE WAY... it is far cheaper to run he recommended octane than to buy these terribly cute OCTANE boosters.

Go to Bing homepage

Jul 21, 2016 | 2000 Lincoln LS

1 Answer

Will a 2001 yukon denali radiator fit in a 2004 yukon denali xl?

Yes, as long as the engine is of similar size, you shouldn't have any problems fitting the radiator from a 2001 Yukon to a 2004 Yukon XL model. There are a couple of things to be aware of. The radiator should have the same connections on it as the one you are replacing for best fit, but are not required. If a mechanic is doing the work, they shouldn't have any issue resolving any concerns like auto to manual transmission differences...but playing it safe and getting the replacement from a like vehicle is best.

Jan 03, 2016 | Cars & Trucks

1 Answer

2007 denali

Hi,on most vichles you undo the wire that leads to it then unsrew the senser anti clock wise and replace it with a new one.
good luck hope this helped.

Oct 29, 2013 | 2007 GMC Yukon XL Denali

1 Answer

Yukon 2003 do not acelerate I just set a used motor on my yukon and it crancks but do not acelerate. is the same if I give gas. (It has electronis throttle boby)

Could be a number of things but first make sure you throttle positioning senser is connected as well as you mep senser and egr

Oct 24, 2011 | 2003 GMC Yukon XL

1 Answer

Where is the o2 senser, bank 1,senser 2. on a 2003 yukon denali. thanks bill

bank 1 is where number 1 cylinder is, on v6 or v8 engines. it is the sensor on bank 1 behind convertor.

Jul 20, 2010 | 2003 GMC Yukon XL

1 Answer

I have an engine code PO332 knock sensor 2 circuit low imput bank 2 what is this problem .the car is a 2001 gmc yukon xl .

The most likely cause of your code is a bad rear knock sensor. You should check the knock sensor wiring harness for corrosion. But if that checks out the sensor will have to be replaced. The knock sensor is under the intake manifold, although it's not too difficult to remove. Both knock sensors should be replaced along with the wiring harness, just because of labor involved in gaining access to the sensors. You could try clearing the code, it may stay off for a long time.

May 23, 2010 | 2001 GMC Yukon XL

1 Answer

I have a 2005 GMC Yukon XL and the speeometer works off and on. Is it the fuse, if so where is it located at?

No its the speedo senser that is faulty change it.Its located at the output shaft end on gearbox.

Nov 18, 2009 | 2005 GMC Yukon Xl Denali

1 Answer

Where is locate the knock sensor in 2004 yukon xl

There are 2 or them and they are under the intake manifold. The manifold has to be removed to replace them.

Oct 10, 2009 | 2000 GMC Yukon XL

1 Answer

Loud engine noise or knocking when AC on

Have your air compressor for your air tested. Sounds like its bad.

Aug 26, 2009 | 2003 GMC Yukon XL

Not finding what you are looking for?
2004 GMC Yukon Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides