Question about 2004 Cadillac CTS

1 Answer

Brake lights the brake lights went out can i fix them myself or do i have to take the car in to the shop?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Cadillac Master
  • 1,779 Answers

1st check the bulbs, but if they went out at the same time it's probably the brake light switch that needs to be replaced.

Posted on Jan 03, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My brakes paedal went to the floor and the brake light came on with I P on the top. The pedal is very soft. I filled the master cycl. and pump the brakes they cam up but a few seconds later they were soft...

Well, the fluid sounds like it is going somewhere. Look on the ground.
Could be a line that blew, or a hydraulic brake component that is leaking.

I would leave it up to a brake service professional to repair this problem, which is beyond just adding fluid to the master cylinder.

Brake systems can be complicated to repair properly when the pedal gets to the point of going to the floor and the brake light going on which is always a bad sign of impending bills to repair either with parts or with brake expertise.

If you have more specific questions on the braking system I would be happy to answer.

Feb 01, 2011 | 1998 Chevrolet C1500

1 Answer

I went over a deep pot hole with my front left tire and now my ISB light and traction off light are on. I also had a grinding sound when I pressed the brakes, although it's not all the time. What could it...

just remove front brakes and see if abs or brake sensor is bad or bent. the grinding may be worn down brakes. or something is bent. yes you can do this, just take it slow.

Jan 27, 2011 | 2001 Buick LeSabre

1 Answer

Speedometer quit

The speed control sensor is disconnected it is located on the transmission. I think someone did not connect a harness or it came loose or it is damaged

Mar 23, 2010 | 1991 Nissan 300ZX

1 Answer

Car skids often, after brake repair

There are wheel speed sensors on each eheel that are needing adjustment. Probably disturbed or not set on brake when brakes were done. Suggest you take to any brake shop and have them checked. and adjusted. The cost should be minimal, but ask first.

May 22, 2009 | 1995 Chevrolet Caprice

1 Answer

Speedometer,mileage does'nt work,abs,traction,brake lights r on

no it does not; this is a massive short in the electrical system and, requires the services of an auto electrician like myself.
take the car in to an ASE certified auto electrical shop and, stop spending money on temporary fixes
the technicians can read the schematics and, fix your car right

Apr 29, 2009 | 2000 Lincoln LS

1 Answer

ABS light is on

Check your codes in the onboard computer

Mar 16, 2009 | 2001 Chevrolet Blazer

1 Answer

Brake lights???

cut the wires use the wire connector and reconnect to each other its a simple walmart has a set for 10 bucks to do this and put electrical tape around the wiring 2 seperate wire 2 seperate connectors/ Please rate my response thank you very much

Jan 16, 2009 | 2000 Chevrolet Tahoe

1 Answer

Brake lights went out?

really depends on what is going on anything can be fixed without taking it to the shop first check all fuses the check bulbs

Jan 03, 2009 | 2004 Cadillac CTS

2 Answers

Turn Signals and Highbeams don't work

I just had this happen to me. The computer flashed "ABS system failure" and my steering wheel controls went out, and the wipers, and turn signals/high beams. The really weird thing is that some of the dash went out (i.e. the temperature went out, but the clock didn't).

I figured this was a computer problem, so I just pulled the fuses (the ones under the hood) and put them back in. The computer still flashes "ABS System Failure" but the car runs perfect.

Jul 15, 2008 | 2000 Volvo S80

Not finding what you are looking for?
2004 Cadillac CTS Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

68970 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides