Question about Nissan Almera

Open Question

My nissan almera dont have pulse in injector's.what i must do?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75797 Answers

SOURCE: nissan almera ecu light

disconnect the battery negative cable for 5 minutes

Posted on Mar 05, 2010

  • 383 Answers

SOURCE: Little to no injector pulse only when starter is engaged

95-97 Maximas had a problem where condensation from the A/C would accumulate in the a/c evaporator case from the drain becoming restricted or blocked, When this would occur, condensation would drip onto the ECM and a problem would develop with misfire and/or starting. I would look at the ECM where the harness connects to it for corrosion problems. If you find it, there is a chemical spray which can be used to clean the terminals and/or you can clean them, although it is time consuming and difficult to due because of how small the terminals are. After things are cleaned up, lightly coat the connections with a dielectric grease. This will prevent electrolysis.I believe you can buy these at Radio shack and possibly at an automotive parts supplier.
Also a drop in voltage during the cranking phase will cause a weak spark. Your ignition is what pulses the injectors. It takes a minimum of 9.6 volts, but ideally you want at least 10.5 or more during the cranking phase if you want to get a spark worth anything. Check the voltage on the primary side of the coil while cranking the engine.
I'll watch to see if things work out for you, let me know. ....mybunkey

Posted on Apr 18, 2009

  • 1 Answer

SOURCE: nissan almera problems side light

heater blowing cold air only

Posted on Jan 04, 2010

cansmo
  • 2431 Answers

SOURCE: 99 nissan pathfinder , no spark , no pulse from injectors why?????

The ECM need power and ground,in the engine fuse jubnction box is the ECM fuse this is a 7.5 amp fuse make sure its not blown

Posted on Apr 13, 2012

  • 6 Answers

SOURCE: no injector pulse

what vehicle? injector pulse controlled by computer. the computer recieves a pulse from crank angle sensor, or distributor pick up, etc.
then controls injector pulse. Mass air flow on some vehicles determines spray pattern

Posted on Jun 29, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My almera 1.6 2004 model coils not recieving power.


ok, i will try and help you as much as i can. first you should be getting 12 volts a pulse and a ground( negative ). if you're getting the 12 volts and the grounds but no pulse the the car has 2 sensors, one is the cam and the other is the crank. those sensors provide pulse to one for the injectors and the crank is for the coil packs. you can test for pulse by using a noid light or the normal test light. just connect the test light to 12 volts terminal and have someone crank over the engine. if you don't get a low flickering light then you neeed to change the sensor

Oct 17, 2014 | Nissan Almera Cars & Trucks

1 Answer

99 nissan pathfinder , no spark , no pulse from injectors why?????


The ECM need power and ground,in the engine fuse jubnction box is the ECM fuse this is a 7.5 amp fuse make sure its not blown

Apr 13, 2012 | Cars & Trucks

1 Answer

Injector pump gave trouble on nissan almera so i got working injector pump fitted to Nissan almera 2.2tdi it was running perfect when i got the car back but after about 15 miles the engine light comes on...


Not the EGR. Pump is definitely out of time and too much fuel makes it smoke like that and you lose power because the engine is flooding with fuel and it just cant burn it quick enough. Makes sense, huh.

Jun 13, 2017 | Nissan Almera Cars & Trucks

2 Answers

2002 nissan sentra it wont start i got fire on the spark plugs bu


Injector pulse comes from Cam sensor, If you have a BAd CAMSHAFT sensor you will not get injector pulse, replace sensor and that should solve your problem. Good Luck and thanks for using FIX YA

Jan 20, 2009 | 2002 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

182 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...