Question about Cars & Trucks
Changed the unit flasher, hazard switch and all fuses are good. i can hear the signal lights when i turn it on in left or right position and the lights come on outside but they dont blink. also the hazards wont come on at all but if i turn the signal light left or right while the hazard switch is depressed the clicking noise gets faster. I have no signal or hazard lights that come on in my dashboard at all. please someone help.
If the 15A HAZARD fuse in the passenger compartment fuse box is OK, power is getting to the hazard function of the flasher unit. Pressing the hzard switch should cause the hazard lights to flash. HOWEVER, there is an electronic time and warning indication system module connected to to the hazard switch lead and that may be affecting things. If the 10A TURN fuse is OK, power is applied to the turn switch (with the engine in START or RUN) and you state you can select a right or left turn. HOWEVER, the RED/WHT and RED/BLU outputs from the flasher unit connect directly to the front and rear turn lamps and the instrument cluster turn indicators so you are not getting any flasher output. Again, that electronic time & warning indication system module could be affecting things
Posted on Oct 26, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is a conector box on the left side of your steering wheel on the colum loosen it and check your wires I bet when you just loosen the block they will start working,I hope this helps you
Posted on Oct 08, 2009
Did you only check the fuse in your fusebox inside the car under the dash on the drivers side? Depending on what you drive there should be another fusebox that is up front on that side. make sure all the wires are tight there too
Posted on Feb 18, 2009
yes it is the same. the problem is most likely the turn signal switch which is located on the steering column. be sure to check all fuses, relays, and bulbs first. keep me posted thanks
Posted on Jan 31, 2009
replace the turn signal switch it self, mine did the same thing with the left turn signal, put in fuse and it will continue to flash... went to junk yard pulled one out of a 97 avenger just like mine, swapped them out and now it works fine. looked to be like some corrosion... to repace: 3 screws under columb, 2 screws on side of signal switch (black plastic side). unplug and replace
Posted on Jun 26, 2009
I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!
Posted on Oct 11, 2009
Tips for a great answer:
Jan 02, 2016 | Kia Cars & Trucks
Nov 03, 2015 | Kia Cars & Trucks
Jun 05, 2017 | 2001 Kia Sportage
Mar 20, 2014 | 2002 Kia Sportage
Nov 21, 2013 | 2000 Kia Sportage
Jan 27, 2011 | 2001 Kia Sportage
Aug 04, 2010 | 2002 Kia Sportage
Apr 04, 2010 | 2006 Kia Sportage
878 people viewed this question
Usually answered in minutes!