Question about 2004 Fiat Stilo 1.9

1 Answer

04 stilo stops when hot

Car starts ok and when it get to working tempature it stops and will not restart until tempature cools down. on the dash a message come up loose connection

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Fiat Master
  • 75,842 Answers

The following are the general instructions on the start of diagnosing any electronically controlled engine or transmission problem.

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems can and do cause many drive-ability related problem such as rough idle and other symptoms.

Posted on Oct 26, 2012

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 136 Answers

SOURCE: PROBLEM GETTING INTO FIRST GEAR,

It could be tranny fluid, or your tranny may be screwed
change the fluid and filter and see what that does.

thanks.

Posted on Oct 16, 2008

steve_e_uk
  • 1675 Answers

SOURCE: MY Fiat stilo windshield wippers front and back

try changing the wiper relay in the fues box, it might be u/s and sending wrong signal to motors hope this helps

Posted on Feb 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Air runs until car runs a distance and engine is shut down. when restart air is not cool?


Well of course not. When you shut the car down, all water circulation stops so engine heat goes way up. This means the radiator gets hot too, and therefore so does the AC condensor. It takes time for all these things to cool back down when you start it back up.

Jul 14, 2015 | Cars & Trucks

1 Answer

Megane Electronic fault


You can check this diagnostic fault code at Autozone and fix the problem

Apr 14, 2014 | 2000 Renault 181

1 Answer

Toyota celica problems


I have a celica 94 st204 that runs perfectly until it gets hot it then starts jerking and then stops and I am unable to restart it until it cools down for 15 minutes then it runs great again .

Jan 03, 2014 | Cars & Trucks

1 Answer

Water tempature gauge shows hot when car is cool ;and hasn't been driven


It sounds like the temp sender may be bad. This is the sensor that sends a signal to the gauge on the dash (as opposed to the engine coolant temperature (ECT) sensor that goes to the ECU instead.) It is located on the bottom front of the thermostat housing (which you will find if you follow the large hose from the top right of the radiator.)

Before replacing, make sure the connection is clean and secure, then check the wiring for any obvious failures.

Jan 13, 2013 | 2002 Ford ZX2

1 Answer

I have a 04 Kia Sedona, the tempature gauge on the dash panel keeps going up and down, Meaning that while im driving it stays down but once i stop it starts to go up to the hot line. I have checked and...


I am facing the same problem still no answer yet . registered mechanic only know to ask us to change the engine head which I do not think is the problem.

Aug 12, 2011 | 2004 Kia Sedona

1 Answer

Chevy Silverado: While the truck is running and the AC is on cool the tempature will go to HOT and I have to stop the truck and turn it off, turn it back on again and then the tempature returns to cool. ...


You condensation problem because the fan that cools the condenser will not run or runs poorly if that works and electrical checks if it can be used clucht fan fan problem clucht that the fan does not spin fast enough to adequately remove the heat .. .

Jun 26, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

04 model renault megaine convertable just stops while driving,restarts ok then just stops.when its running runs fine.is intermitant and can fail when its hot or cold no warning lights on dash and no fault...


It may be an intermittent loss of signal from either the crankshaft or camshaft sensors, the ignition system, or the ecu itself. Usually these kinds of problems require driving with a scanner hooked up and recording any failure on the fly. Good luck!

Oct 13, 2009 | 2004 Renault 181

1 Answer

AC cools then blows hot air, tempature needle goes up & down


Sounds like the thermostat is trying to stick,and is causing the engine to over heat,therefore condenser is not cooling the freon down enough to cool.Have the thermostat changed and the cooling system bled out,this is most likely the cause.

Aug 29, 2009 | 2005 Lincoln LS

Not finding what you are looking for?
2004 Fiat Stilo 1.9 Logo

232 people viewed this question

Ask a Question

Usually answered in minutes!

Top Fiat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75842 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Fiat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...