Question about 1998 Dodge Ram 2500 2WD

Open Question

1998 dodge ram 1500 headlights stopped working

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

hotrodtod38
  • 141 Answers

SOURCE: 96 Dodge Ram 1500 wiring diagram for headlights.

hope this will work

Posted on Feb 17, 2009

suterman
  • 158 Answers

SOURCE: I need the location of MAF sensor in a 1998 Dodge

Your vehicle dose not have a maf sensor. They used a map sensor it is on the engine located under the front of the breater where it attaches to the engine.

Posted on Jul 02, 2009

  • 1 Answer

SOURCE: 1998 dodge ram 1500 v85.2 towing capacity?

according to the owners amnual the max towing weight for a 1999 ram 1500 quad cab wit automatic transmission is 7600 lb.
with either 5.2 or 5.9 v8. for a reg cab it is 8000 lb.

Posted on Jul 23, 2009

  • 412 Answers

SOURCE: 98 dodge 1500 ram speedometer not working sender

ABS LIGHT ON AS WELL?IF SO..I WOULD LOOK AT ABS SENSOR IN REAR DIFFERENTIAL..GETS SPEED SIGNAL FROM THIS SENSOR AS WELL..USES ONE IN TRANS FOR TRANS SHIFTING

Posted on Aug 31, 2009

  • 593 Answers

SOURCE: Remove headlight assembly from a 2001 Dodge Ram

On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.

Posted on Apr 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 dodge ram 1500 dash lights wont work


Walker Muffler - Aluminized Steel Direct OE Replacement 1998-2001 Dodge Ram 1500.-------------------------------------------------------------------------------------
SLIM HID XENON light

Jan 10, 2013 | 1998 Dodge Ram 1500 4WD

1 Answer

I have a 1998 Dodge Ram 1500 ext cab 2wheel drive. The headlights work on Low, but when I switch them to High I have no headlights. All other lights work fine and the bulbs appear to be fine.


It would be either the headlight switch or the headlight relay. Try the relay first, it is easier to replace and less costly than the switch.

Mar 15, 2011 | Dodge Ram 1500 Cars & Trucks

1 Answer

Dodge 98 1500 pull headlight knob headlights do not brighten (stays in daylight running mode) - hi-beams work fine


you need a new headlight switch. depending on where you go to get the switch it will be anywhere from 60 to 80 bucks. very easy to install. i had this problem about 3 weeks ago. good luck

Apr 13, 2010 | 1998 Dodge Ram 1500 4WD

1 Answer

1998 dodge ram 1500 2wd 5.9 eng. how to change


just drop the transmission pan to drain it and the filter is right there in the valve body,DON'T mess the band adjustment,they are only to stop the planetary gears so you can go into reverse,there is no such thing as adjusting bands! that went out with the fifties!

Jan 09, 2010 | 1998 Dodge Ram 1500 4WD

2 Answers

I have '99 dodge 1500 p/u and the low beams don't work.


its probably the muliti function switch on top the steering column

Dec 30, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

1998 dodge ram 1500 Cruise control , speed


Look under the hood to check and make sure there is two steel wire cables connected to the throttle body. i had the same problem on my 02 dodge ram, turns out that just one of the cables came loose

Sep 08, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

Heat blower only works on high speed


replace fan speed reostat,generally high spd. does not go thru the reostat-full 12v service..kev-mn.

Dec 10, 2008 | 1998 Dodge Ram 1500 4WD

1 Answer

1998 ram 1500 ext cab 4x4


Just remove the instrument panel bezel, not the dash, very simple job.

Oct 14, 2008 | 1998 Dodge Ram 1500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...