Question about 2000 Mercury Grand Marquis

Open Question

How to adjust shift cable on a marcury marquis

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Shifting cable has rested on Transmission, how do you replace the whole shifting cable from Transmission to shifter in car,


You have to pull the steering column down to replace that end of the cable.

Hope this helps.

Apr 29, 2015 | 1996 Mercury Grand Marquis

1 Answer

My 1991 Grand Marquis will NOT go into park, it keeps rolling what can I do?


Could be a problem with the key lock cylinder.
You could disconnect the shift cable and try shifting the lever on the transmission. That would tell you if it is a shift lever problem or something inside the trans.

Mar 07, 2015 | 1991 Mercury Grand Marquis

1 Answer

2001 Grand Marquis LS will not turn the ignition on in "P" only on "N" what can I do to fix this?


Replace or adjust the neutral safety switch at the base of the steering column.

Feb 23, 2015 | 2001 Mercury Grand Marquis LS

1 Answer

Atv won,t shift into reverse


2004 Mercury Grand Marquis is not an ATV. Reverse on some ATV's has a knob on the handlebar attached to a cable that sometimes goes out of rig. (the cable prevents shifting down past neutral unless pulled)

Jan 16, 2014 | 2004 Mercury Grand Marquis

2 Answers

Shifting lever is sloppy and can't get it into park. Play around with it to start car . Is there an adjustment for the cable on the transmission?


There is an adjustmant but that is not the problem.The problem is the two bolts that hold the shift cable bracket to the steering column.They are #30 torqx and a little hard to get to, you will need to get under the dash and wiggle the shifter to identify the shift cable and baracket.Tighten the two bolts and all should be good.

Feb 19, 2011 | 1996 Mercury Grand Marquis

1 Answer

How do I adjust the linkage on my 1995 Mercury Grand Marquis shifter is sloppy


The bolts loosen up on the bracket that holds the shifter shaft to the cable. Look up from the floor board and look above the steering column in the shift cable area. Wiggle the shifter and you should see the problem. Tighten the bolts with a torx bit.

Jun 14, 2010 | 1995 Mercury Grand Marquis

1 Answer

Just put in new transmission in and car still want drive


check fluid level make sure manual shift cable is hook up or adjusted right.

Jul 06, 2009 | 1994 Mercury Grand Marquis

1 Answer

Only got 1st gear and reverse (Automatic Transmission Problems)


when was last transmission service done? and that means changing the transmission fluid, and the filter and also have someone check the transmission linkage adjustment and this normally shows up when it is hard to change gears and also check the transmission fluid level

Jan 05, 2009 | 1986 Mercury Marquis

Not finding what you are looking for?
2000 Mercury Grand Marquis Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...