Question about 1998 Chevrolet S-10 Pickup

Open Question

How do I replace the brake lines on 1998 chevy s10 truck?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 21 Answers

SOURCE: replacing a blower motor 1998 chevy 1500

pull glove box out blower is mounted behind it

Posted on Jan 05, 2009

Ad
  • 82 Answers

SOURCE: 1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks

have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.

Posted on Mar 11, 2009

  • 6982 Answers

SOURCE: How do you replace the brake lines for a 1996 Chevy S10 Blazer

You have the best diagram right on your car! follow the original lines to replace them. (you can change routing a little with no problems, just make sure they dont interfere with anything and that they are secure so they don't rub through and fail again!

Posted on Mar 14, 2009

  • 1779 Answers

SOURCE: 1998 chevy s10- brake pedal goes to the floor-

Did you put fresh fluid in the master cylinder? I really think you still have air in the lines. To bleed manually, start with the bleeder the greatest distance from the master cylinder, car running, helper pushing down about half way on brake pedal and releasing 3 times, on 3rd time, holding pedal down to half way depressed point while you open the bleeder valve. Repeat until you are sure all air has been flushed out. Check master cyl reservoir level often, because if it gets low and you **** air into the system, you have to start all over again. Go to wheel next greatest distance from master cyl, repeat above, working your way to wheel closest to master cyl last.

Posted on Apr 12, 2009

wracefans24
  • 1985 Answers

SOURCE: need a wiring diagram for a chevy s10. brake

your power starts at the brake light fuse,check with a test light,then proceed to stop light switch on brake pedal under dash,one wire will be hot when when you check it with your test light, the other won't be until you press down the brake pedal then the power flows through to the second wire,if no power to second wire replace switch,if you have power remove tail light bulbs and check for power in side socket.

Posted on Nov 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

87 chevy s10 brakes


Front or rear, they're both very easy to change if you go to YouTube you can get a step by step video on both.

Jul 02, 2016 | Cars & Trucks

1 Answer

Want to know if a 1998 motor from a s10 will fit in a 1999 s10


once you have all the parts for the swap it should be a direct bolt in. its the v6 right?

Feb 14, 2014 | 1999 Chevrolet S-10 Pickup

1 Answer

1998 Chevy S10 Pickup - Emergency Brake is stuck. How do I repair?


Your emergency break has a cable. I would say the cable is broke, in the lock position. I don't know the specifics, but the cable is probably broke.

Feb 17, 2011 | 1998 Chevrolet S-10 Pickup

1 Answer

Where is the starter on a chevy s10 1998


http://www.ehow.com/how_6114322_replace-starter-chevy-s10.html Just replaced on my 96 a month ago this should help Mine was under the driver side of the truck

Nov 05, 2010 | 1998 Chevrolet S-10 Pickup

1 Answer

Where to find.a proportioning valve for a 1998 chevy s10 four wheel drive 4.3 v6


It should be on the frame below the master cylinder. Just follow your brake lines off of the master to a block with a wire plug.

Oct 18, 2010 | 1998 Chevrolet S-10 Pickup

2 Answers

Brake pedal on my 98 chevy s10 is soft


1988 chevy r 3500 1 ton changed out driver front brake caliper
brakes are soft peddle goes to the floor tried to bleed but no brake fluid will come please help

Apr 14, 2010 | 1988 Chevrolet C1500

2 Answers

I have a 1998 chevy s10 it has a good brake pedal with the engine off but with it running the pedal go'es to the floor and you can hear air at brake booster


Check for fluid leaks and your brakes. If you see no leaks and your brakes are in good shape replace the brake master cylinder and bleed the system. The air you hear is because the pedal went to the floor. If the booster goes bad the pedal will get so hard you can hardly push it at all. I think you will find if this happened suddenly either you have a major leak or the master cylinder went bad.

Sep 29, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks


have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.

Mar 11, 2009 | 1997 Chevrolet S-10 Pickup

2 Answers

Repairing a brake booster on a 1997 chevy s10


Remove the vaccum operated brake booster pump and replace it with a new one

Jul 20, 2008 | Chevrolet Chevy Cars & Trucks

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...