Question about 1997 Buick LeSabre
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Warm up engine, jack up car, use jack stands, get pan to catch used oil, craw under remove drain plug from oil pan let drain, take filter wrench loosen oil filter, screw off, clean off mating surface put layer of new oil on gasget of new filter and spin on hand tighten only, put drain plug back in and tighten, fill engine with new oil, start up and chk. for leaks and level on dip stick and your done.
Posted on Jul 14, 2009
SOURCE: 2001Buick LeSabre parking light
On top of the headlight housing are two large knurled black plastic knobs.Unscrew them counter-clockwise.Now the whole headlight housing may be removed. Set it on the bumper and you'll have easy access to the marker light.
Posted on Nov 12, 2009
GM vehicles are fmaous for this warning. I had the same problem in my GM vehicle and had to replace the EVAP vent solenoid. Are you getting a DTC yet or just the tighten gas cap message? INspect the fuel cap to make sure it is not damaged and is installed properly. If it's damaged replace it. If all is good on the cap just wait for the DTC to show up but most likely you'll need to replace that solenoid.
Posted on Dec 22, 2009
Testimonial: "very helpful"
This sounds like it may be a problem with the passII security sys.
First check the two fuses in the fuse block, #1A and #2E the block is
located under the left side of dash. They may be marked as vehicle anti
theft system(vats)#1A. Fuse #2E may be marked vats/air bags.If these
are good, locate the anti theft relay located above the fuse block.
There will be a yellow wire and a purple wire on each side of the relay,
you wan't to jump the yel wire(A2) to the ppl wire(C1) one of the yellow
wires will run from the relay back up the steering colum. This wire is C1
the ppl wire on the other side of the relay is A2 jump these two wires
and this will bypass the relay. If the car still won't start the problem is
most likely in the colum, either the chip in the key or the resistor in
the ign. lock. You can start the car by locating the purple wire under
the hood in the harness with the blk plastic cover, that runs accross the
firewall. In the same bundle of wires there should be a slightly thicker
red wire, with the key in the on pos. take a sharp knife and cut into
the 2 wires at the same time to make a connection. This will turn the
starter and start the car. If you need to take it to get the key and lock
checked. Hope this helps.
Posted on Mar 06, 2010
Tips for a great answer:
Feb 05, 2016 | 2001 Buick LeSabre
Oct 25, 2012 | 1997 Buick LeSabre
Jan 23, 2011 | 2001 Buick LeSabre
Jul 16, 2010 | 2004 Buick LeSabre
Feb 21, 2009 | 1997 Buick LeSabre
Jan 25, 2009 | 2001 Buick LeSabre
Dec 09, 2008 | 2001 Buick LeSabre
66 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: