Question about 1998 Land Rover Discovery
Tire balance, or missmounted tires beads; check for a correct concentrical assembly.
Posted on Dec 31, 2012
Possable tire balance if it only does it at high speeds
Posted on Oct 25, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
with great difficulty,first you have to disconnect battery to stop air bag accidently going off ,then remove the air bab ,two clips underneath steering wheel ,very difficult without the right tools ,then the big nut and maybe evan a steering wheel puller.Whats the fault that necessatates removing the steering wheel in the first place?
Posted on Sep 10, 2009
The discovery is as previously mentioned permanent four wheel drive.However the difflock/range lever in most suffers from lack of use and siezes all i had to do when i bought mine was plenty of WD40 and patience as i don't think it had been in low range or difflock from the day it was built.don't try to force it just spray it and let it soak then try keep doing this and it should free up if not it may be the selector grubscrew has worked loose just threadlock it and screw it back in.
Posted on Feb 16, 2010
No need for a diagram, to drain the oil, there's a drain plug on the bottom of the transfer box, under the handbrake drum. To fill, the fill plug is about in line with the centre of the handbrake drum and to the left. I think both plugs are 1/2" square. Fill to overflow with Texaco Multi-Gear 75W/90R. Takes about 2L or so.
Posted on Feb 25, 2010
There is a little more to it than that, but not a tough job if you have patience. You will need to remove both 'doors' on the dash-one glovebox, one fuse access panel. on US models, you will need to remove the pass side airbag as well, then 2 bolts that hold a set of relays under the airbag, then 5 bolts that hold a support bracket (also under the pass side airbag-behind glovebox.
Then under the dash at teh outside near the doors, remove 2 sets of 10mm bolts. after than remove 2 sets of 10mm bolts near where the bottom of the dash touches the tranny tunnel. obviously all the center console needs to be removed, and the center panel of the dash, as there are several sets of screws that hold that to the back of the dash.
be patient, take lots of photos of how it goes together, and where the wiring is(was), and this is pretty easy.
Posted on Jun 10, 2010
Tips for a great answer:
Nov 04, 2014 | 1999 Land Rover Discovery
Nov 08, 2012 | 2002 Land Rover Discovery Series II
Apr 02, 2012 | 1997 Land Rover Discovery
Nov 23, 2010 | 2002 Land Rover Discovery Series II
Nov 11, 2010 | 2002 Land Rover Discovery Series II
Jan 20, 2010 | 2002 Land Rover Freelander
Dec 08, 2009 | 2002 Land Rover Discovery Series II
Jan 22, 2009 | 2002 Land Rover Discovery Series II
May 01, 2017 | 1998 Land Rover Discovery
153 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: