Question about Cars & Trucks

Open Question

1994 Mazda rustler wiring harness I need a copy

I need to redo my wiring on the ford/Mazda rustler bakkie can anyone help

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 1010 Answers

SOURCE: Need wiring harness for 1993 626 with 2.0/5 speed manual

If i were you i would advising with a dealer or mechanic.

Posted on Jun 17, 2008

  • 33 Answers

SOURCE: need wiring diagram for 2008 ford crown victoria


You can purchase the wiring diagram for $5.99 from the following site: You can also purchase a wiring diagram book from the following link:

Hope this helps,


Posted on Mar 23, 2009

  • 78971 Answers

SOURCE: Need a stereo wiring diagram for 1994 Ford Tempo.

1994 Ford Tempo Car Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Green/Yellow
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Red or Black
Car Radio Illumination Wire: N/A
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 6 1/2′
Car Audio Front Speakers Location: Doors
Left Front Speaker Positive Wire (+): Orange/Green
Left Front Speaker Negative Wire (-): Black/White
Right Front Speaker Positive Wire (+): White/Green
Right Front Speaker Negative Wire (-): Black/White
Car Audio Rear Speakers Size: 5′ x 7′
Car Audio Rear Speakers Location: Rear Deck
Left Rear Speaker Positive Wire (+): Pink/Green
Left Rear Speaker Negative Wire (-): Pink/Blue
Right Rear Speaker Positive Wire (+): Pink/Blue
Right Rear Speaker Negative Wire (-): Green/Orange

Posted on Mar 25, 2009

  • 90 Answers

SOURCE: setting the idling and airflowmeter on the 160i rustler Bakkie 97

first check the sparking plugs because some cylnders may not working propably . then chek the oxygen sensor

Posted on May 31, 2009

  • 2 Answers


I have a 1991 honda accord radio problem can you HELPme

Posted on Jun 21, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My Mazda Rustler 160i 1998 Bakkies fuel injectors don't open,What is the problem

First, test fuel pressure as injectors will not open if pressure is low.

Aug 01, 2016 | Mazda Cars & Trucks

1 Answer

What's your question?my mazda rustler 1600 carb bakkie mist when I start it and has a ping sound like a tappet when I rev has no power when I drive it.can't even drive up a small hill

check the ignition timing as I suspect that it is too far advanced
also check the carby for correct air fuel ratio
( float level)
pinging or detonation ( correct definition) is cause by spontaneous combustion of the fuel mixture that is on the lean side or spark too far advanced
it is damaging to the motor with sever enough with burnt valves and melted piston crowns as a result

Jul 23, 2016 | Mazda Cars & Trucks

1 Answer

Have found exposed and burnt wiring on left side of car. 1994 escort station wagon. radio is out and now left blinker and brake light. Is it worth trying to repair myself?

Hi, If you think the car is still worthy of redoing the wires, I would say go ahead.
But you might have to get a new wiring harness for it. I would have a pro install it.
Good luck.

Sep 23, 2011 | 1994 Ford Escort

1 Answer

Fuel does not come from the tank on amazda rustler bakkie 160i 2001 model hence the car cannot start

Either your fuel pump has died, make sure you check all fuses and wiring for shorts, or the screen on the pump is clogged and needs to be cleaned. Most likely the pump needs replaced and the t ank will have to be lowered to acces the pump.

Mar 31, 2011 | Mazda MPV Cars & Trucks

2 Answers

I have replace the clutch on my rustler but it

Bleed the hydraulic system. Check the hydraulic lines, it could be swelling, Did you change the pilot bearing as well? If it was removed and not replaced, there will be a hard vibration.

Feb 18, 2010 | 1989 Mazda 323

1 Answer

Setting the idling and airflowmeter on the 160i rustler Bakkie 97

first check the sparking plugs because some cylnders may not working propably . then chek the oxygen sensor

May 31, 2009 | Mazda 323 Cars & Trucks

2 Answers

1997 mazda rustler 160i

sounds like a problem with the air flow system. There should be a MAP sensor that needs to be cleaned. It may only need an air filter as sometimes bugs and dirt can build up inside the housing. Of course if it is a fuel problem and there is no fuel filter and anything is able to get through to the motor you may be giving your injectors a dirty beating that they don't deserve. Get a fuel filter on stat. If you've put new spark plugs and rotor on did you hapent to look at the distibutors points? They should have at least been cleaned and look nice and shiny. Did you gap those plug to specification? There are quite a few things that can cause your particular problems... Wires play big rolls also....

Jun 24, 2008 | Mazda 323 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13632 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides