Question about 2002 Mazda 626
What are the steps on how to set the clock for a 2002 Mazda 626? Also, the LED display fades in and out. If I push on the display it comes in, but does not stay. Would a good "smack" work or is it a bulb issue?
You can find that info in the owner's manual. You can buy a used on ebay if you check back often.
Posted on Oct 25, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
06 MAZ 3 check the fuse marked ROOM15a ,,under the hood in the corner of the fuse panel, PULL IT OUT and change it whether blown or not ,,,,,should fix it ,,,,,,,,if the display is not bad
Posted on Jan 24, 2009
On my Mazda I did the following:
- Pulled off the electrical connector socket from the back of the headlight housing.
- Pried off the rubber boot on the back side of the headlamp assembly.
- Removed the wire bracket surrounding bulb by removing the screw that held it in place, although it may be possible to remove the bulb without removing the bracket.
- Extract the bulb from the headlight assembly.
Reassembly was just the revrese of the above steps.
Posted on Feb 08, 2009
This symptom is often a sign the player is nearing its end of useful
life. But, sometimes it is merely due to a collection of dust, dirt or
a foreign object lodged in the mechanism. Sometimes it is a logic
error inside the electronic memories.
So, there are a number of possibilities.
Here is what I would do:
ONE: Do NOT force it or use tools to pull the disc out.
TWO: If you can find the wires that supply the 12 volts to the unit, pull that wire so there is no power to the unit whatsoever for at least 30 seconds. That will reset the electronics inside the player.
THREE: IF you cannot find the wires, or if they are too hard to get to, you can pull the plus cable off the battery; raise the hood and with a wrench loosen the bolt holding the plus cable onto the battery terminal. Pull it off for at least 30 seconds or longer, then put it back on. This will perform a hard reset as in TWO.
FOUR: If still no removal try this technique:
If it is not an expensive unit you may find it a superior investment to purchase a new player rather than pay a tech to repair it. (In the worst case the unit must be pulled, cover removed and disc manually removed; then you may find out there are damages or defective circuits awaiting further repairs; probably looking at a charge of $75 or more if you go to a service shop).
Let's hope the ideas above kick it out and it returns to normal useage.
Posted on Jun 26, 2008
The Tail Lights Are Accessed From The Inside Of The Trunk There Will Either Be A Panel Immediately Behind Where The Light Is Or Carpet. Remove It And It Will Give You Access To The Rear Of The Bolts Just Grab Twist And Pull And The Light Will Come Out.
Posted on Jan 26, 2009
Tips for a great answer:
Oct 13, 2016 | 2002 Mazda 626
Nov 30, 2013 | Cars & Trucks
Sep 01, 2012 | 2001 Mazda Protege
Jun 09, 2010 | 2002 Mazda 626
Mar 22, 2010 | 2005 Pontiac Grand Am
Oct 03, 2009 | 2005 Pontiac Grand Am
Jun 27, 2009 | 1993 Mazda MX-6
382 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: