Question about Oldsmobile Cars & Trucks

1 Answer

'97 oldsmobile has no gauges, will not come out of park, will not start after replacing starter

It did start one time only, now it just cranks. is there theft protection?

Posted by on

  • btcstore17 Oct 26, 2012

    input this URL: -------http://www.b2cstore.us/ ----- you can find many cheap and high stuff Believe you will love it. WE ACCEPT CREDIT CARD /WESTERN UNION PAYMENT YOU MUST NOT MISS IT!!!

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Oldsmobile Master
  • 75,066 Answers

I thank you left the fusible links off at the starter, they power up all of this stuff.

Posted on Oct 25, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ignition problems

maybe the crankshaft senor that happened to mine it was cracked almost in half

Posted on Jul 17, 2008

  • 2 Answers

SOURCE: I have ford ranger 2003,

You gatta find out if it has any type of theft system and most likely if it does then disconnect it because the computer for it may have malfuntioned and by u disconneting it will deactivate the security for the constint turning over and not starting... so figure that out first...

Posted on Jan 28, 2009

  • 1 Answer

SOURCE: 1997 ford expedition wont stay running?

sounds like its the IDEL AIR CONTROL motor is stuck tap {pretty hard} on side of it with hammer if it starts and runs replace control motor.

Posted on Jun 15, 2009

  • 1 Answer

SOURCE: car cranks but wont start

ck oners manul or call dealer ck part

Posted on Jul 30, 2009

  • 101 Answers

SOURCE: 1994 buick park ave, wont crank over,

Pass key is the security system which disables the car if it is stolen. You need the remote or a key with a chip to start the car. go to a dealer, prove ownership with registration and they will be able to help you out

Posted on Sep 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Van wont start, and i replace the starter. you can hear the fuel pump when you turn the key, and it has sparks


Just because you hear the fuel pump run does not mean you have correct pressure at the injectors. Use test gauge to make sure. Have you run compression test to make sure timing belt has not broken?

Oct 03, 2016 | 2002 Oldsmobile Silhouette

1 Answer

Turn key on gauges move but wont start noting on key but tilt and trim works


How long since a tune-up?
Are there any applicable trouble codes?
Are you saying it cranks good but won't start or the starter motor won't even crank? If the problem is the latter, have to make sure battery has a full charge, battery connections all good. Then check voltage and ground circuits for the starter motor. Any testing at the starter, make sure tranny is in park or neutral and functional parking brake is set. Safety is your responsibility.

Of course if it cranks good but won't start, that is another issue. Usually with gasoline engine, check spark--proper fuel pressure and fuel injector pulse. Also, you may need to check cylinder compression.
What is year--make--model?

May 02, 2016 | Cars & Trucks

1 Answer

Any suggestions on one that will not start


If your saying the starter motor won't crank? Make sure battery has a full charge and connections all good. Check starter wiring circuits. I'd have to make sure security system doesn't have a problem?
If there is a starter relay, on load side of relay, one terminal is hot all the time, If you use jumper wire between the proper two terminals, on load side of relay, the starter should crank. If you try that, make sure tranny is in park or neutral and functional parking brake is set. With automotive relays, they have two sides, coil/control side and the other side is switch/load side that carries voltage to starter. Even if we get starter motor to crank, if security system is involved, it still won't start.
If you have proper voltage and ground at the starter motor and no starter action, I'd have to check starter motor.

Mar 24, 2016 | 2001 Oldsmobile Silhouette

1 Answer

2004 Envoy XUV doesn't always crank.


I want to see if i catch your drift ! When you turn the key in the ignition switch to start , nothing happens ? Have you tried moving the gear slector to the neutral position to see if it starts then ? Park neutral safety switch problem , maybe .
Here is a description of how it works or how it's suppose to work .
Circuit Description (ECM/PCM Controlled)
Moving the ignition switch to the START position sends a 12-volt signal to the engine control module (ECM)/powertrain control module (PCM) Crank Request circuit. The ECM/PCM verifies that the transmission is in the PARK or NEUTRAL position. With the transmission in Park, voltage flows through the Park/Neutral position switch and feeds the starter relay coil. The PCM then grounds the control circuit of the starter relay. When the starter relay is energized it allows battery positive voltage to the starter solenoid S terminal. On some vehicles the starter will continue to crank the engine with the key released until it starts or the crank command has timed out to prevent excessive heat build up in the starter circuitry or the ECM/PCM receives an engine run flag.
Circuit Description (BCM Controlled)
Moving the ignition to the START position signals the body control module (BCM) that engine crank has been requested. The BCM verifies that theft is not active and sends a serial data message to the powertrain control module (PCM) requesting engine start. The BCM also energizes the RUN/CRANK RELAY. When the RUN/CRANK RELAY switch side closes, and the vehicle is in Park or Neutral or with the clutch is fully depressed, if equipped, supplies voltage to the starter relay coil. The PCM verifies the transmission is in Park or Neutral and the clutch is fully depressed, if equipped. The PCM will then ground the control circuit of the starter relay, closing the switch supplying voltage to the starter solenoid. On some vehicles the starter will continue to crank the engine with the key released until it starts of the crank command has timed out to prevent excessive heat build up in the starter circuitry or the PCM receives an engine run flag.

May 13, 2017 | 2004 GMC Envoy

2 Answers

How to replace ecm on oldsmobile alero


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.



From start to end troubleshooting these problems I suggest you to check the help link below and follow its procedure: -----



Click the link :----




CAR NO START: ENGINE NOT TURNING OVER:
http://alltypesofpartsreplacing.blogspot.com/2012/11/car-no-start-engine-not-turning-over.html


-------
These will help.
Thanks.

Dec 05, 2012 | Oldsmobile Alero Cars & Trucks

1 Answer

1995 Oldsmobile Aurora will start sometimes and other times it won't, I replaced the starter and still the same.


If the engine cranks but won't start, the battery and starter are out of the picture.
When it won't start, someone will need to check fuel pressure and for spark at the plugs to proceed.

Sep 21, 2012 | 1995 Oldsmobile Aurora

1 Answer

Jeep stalls gauges don't work windows and locks and radio don't work


when you state it wouldn't crank, do you mean the starter won't engage or that it just spins over and doesn't start? if no gauges or no starter engagement, then check the battery, battery connections,and the starter for excessive amperage draw. if the starter spins and the engine won't start, then check crankshaft position sensor first. the crank sensor is a more common failure than the distributor or any of the other things you mentioned.

Jun 14, 2012 | 1998 Jeep Grand Cherokee

1 Answer

Will not crank, but battery and starter are ok ?


Neutral safety switch? Try shifting out of park and into neutral. Is anything clicking (like a solenoid) and just the starter does not crank over? Maybe starter solenoid.

Jan 03, 2012 | 2005 Chevrolet Silverado

2 Answers

2001 oldsmobile silhouette will not crank after.........


does the temp gauge or light come on? is the car over heating? .... oh and a starter can test fine when its cold, but the heat soak from the engine and exhaust affect it's performance drastically. it sounds like you need a new starter.

May 28, 2010 | 1995 Oldsmobile Silhouette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...