Question about Toyota Sequoia
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Look in the fuse box on the driver's side of the vehicle on the outboard side of the dash under the triangular cover which snaps off and on. This panel is not visible when the door is closed. If you have your owner's manual, look on page 5-104. This is where the fuses and relay/circuit breaker descriptions, layout, and specifications begin. This section runs to page 5-111.
You are going to check fuse number IGN3, a red plastic, stab-in miniature 10Amp fuse. It has an "S"-shaped element visible through the side of the fuse body. If the element is broken or burned, replace this fuse. DO NOT use a replacement fuse of ANY other rating; use an identical 10Amp fuse ONLY.
You are also going to look for the "Center Instrument Panel Fuse Block," located under the instrument panel, to the left of the steering column. You are going to check the device labeled "30A CB Seat." This is driver and passenger seat module circuit breaker. This circuit breaker is an automatic resetting device, replacement is necessary only if there is no other problem, and it will not reset.
If only the driver seat is affect, the problem is not the CB Seat; check the wire harness and connector under the seat. There is almost no clearance under the seat, and it may needs be removed to check this. There are four 14mm or 15mm bolts, one at each outboard corner of the seat, the front ones under snap-on plastic covers, which anchor the seat to the vehicle. These bolts are installed with an anti-seize anchoring compound which make them difficult to remove, but aside from elbow grease, there is no other trick to removing them.
Good luck, and if I have helped you, please remember to comment/vote.
Posted on Feb 21, 2010
Could be any number of items related to the seat
power motor circuit
Start by removing & testing the switches
If modules are involved,then it will be beyond
your ability to diagnose ,without a trouble chart
Check any fuses that apply
If a fuse is blown,replacing it won't
likely fix the issue,only blow again
Posted on May 23, 2011
have a look to see if its coiled in twisted as you pull the belt out if the buckle doesn't line straight to the female end well its probely retracted in twisted to repair pull the belt out all the way and then realign the belt its quite hard to do so take your time hope this helps.
Posted on Jun 03, 2011
The fuses are generally located in a panel under the drivers side of the dash. while you are under there. take a look under the drivers seat and you'll see the wires for the power to the seat. I have known firends who've unplugged their power options accidentally while shoving such as a flashlight under there, Just thought it may be helpful to think about, in the case that your fuses are all good.
Hope this helps
Good Luck and Happy Motoring
Posted on Jun 12, 2011
Tips for a great answer:
Dec 29, 2015 | 2003 Chevrolet Avalanche
Apr 18, 2013 | 2006 Chevrolet Tahoe
Sep 18, 2012 | 2003 Ford Expedition
Sep 10, 2012 | 2003 Toyota Sequoia
Aug 24, 2012 | 2003 Toyota Sequoia
Feb 13, 2012 | Jaguar XJ8 Cars & Trucks
Nov 14, 2011 | 2000 Subaru Outback
Jul 06, 2009 | 2003 Toyota Sequoia
382 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: