Question about 2003 Lincoln Navigator

Open Question

Where is body control module located on 2003 lincoln navigator

Posted by Anonymous on

  • 2 more comments 
  • sndscientist
    sndscientist Jan 31, 2013

    i also need help finding the BCM. not the liftgate actuator, not the EEC not the air ride. i need to find the BCM

  • sndscientist
    sndscientist Jan 31, 2013

    i also need help finding the BCM. not the liftgate actuator, not the EEC not the air ride. i need to find the BCM

  • sndscientist
    sndscientist Jan 31, 2013

    i also need help finding the BCM. not the liftgate actuator, not the EEC not the air ride. i need to find the BCM

  • sndscientist
    sndscientist Jan 31, 2013

    i also need help finding the BCM. not the liftgate actuator, not the EEC not the air ride. i need to find the BCM

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4369 Answers

SOURCE: 2003 where is the modules for the liftgate in a 2003 lincoln Nav

tascafordparts.com for discount.

The liftgate actuator and remote control are in the liftgate.
The module is in the left rear quarter trim panel.


SECTION 501-03: Body Closures 2003 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION Power Liftgate Module Removal and Installation
NOTE: Prior to removal of the power liftgate module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new power liftgate module once installed. For additional information, refer to Section 418-01 .

  1. Remove the rear quarter trim panel. For additional information, refer to Section 501-05 .
  1. Remove the power liftgate module.
    1. Disconnect the electrical connectors.
    1. Remove the bolts.
89dd4de.gif
  1. NOTE: Once the new power liftgate module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new power liftgate module. For additional information, refer to Section 418-01 .

-----------------------------------------------------------------------------------------

Principles of Operation
The power liftgate is controlled by the power liftgate module.
The power liftgate module receives inputs from:
  • glass position switch (determines the ajar status of the liftgate glass).
  • forkbolt switch (determines the primary position of the latch).
  • detent switch (determines the secondary position of the latch).
  • home switch (determines the power cinch status).
  • power liftgate control switch (activates the power liftgate from the interior of vehicle).
  • pinch strip switches (determines if an obstacle is detected between the pinch strip and liftgate).
  • instrument cluster module (activates and sets the options for the power liftgate).
  • optical sensor (determines the direction, travel speed and obstacle detection of the liftgate).
  • UBP serial communication link.
The power liftgate module sends outputs to:
  • liftgate motors.
  • power cinching latch system.
  • liftgate chime module.
  • body security module
------------------------------------------------------------------------------------

The liftgate consists of the following components:
  • liftgate window glass latch
  • door lock actuator (power liftgate only)
  • liftgate latch
  • liftgate handle
  • liftgate latch remote control (power liftgate only)
  • liftgate ajar switch
  • chime module (power liftgate only)
  • -------------------------------------------------

Posted on Apr 19, 2009

emissionwiz
  • 75108 Answers

SOURCE: HOW TO REMOVE A HEATER CORE IN A 2003 LINCOLN NAVIGATOR

U must remove the entire dash assembly and then the heater core housing which is part of the air distribution box, time to do the job 10-15 hours.

Posted on Dec 01, 2008

chrischronic
  • 235 Answers

SOURCE: Air suspension pump on 2003 lincoln navigator

the little orange or red ring around the air hose whare it goes in compressor, must be pushed in while pulling out on air line. a small flathead screwdriver works fine

Posted on Apr 24, 2009

  • 1 Answer

SOURCE: 2003 Lincoln Navigator stumbles/bucking under mild acceleration

I have a 2003 Nav with the exact same problem. I've found it diminishes when taken out of overdrive. Also it's intermittent but more towards bucking. Sorry to post this under solutions.

Posted on Nov 06, 2009

  • 234 Answers

SOURCE: fusebox location of a 2003 lincoln navigator

it is located in the right side front passsengers kick panel, down where your feet rest. there will be door to swing out of the way toward the seat and then a cover behind that

Posted on Nov 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

White are the door locksrelay located for 2003 linlcond navegator


There is no separate relay for the door locks, it is part of the BSM (body security module) module.

Dec 29, 2016 | 2003 Lincoln Navigator

1 Answer

What's the fuse number for the heater in a 2003 Lincoln Navigator? The display won't come on nor will the heat/ac. Thx


Located in the central junction box . Fuse F1.13 10amp. CJB - under right side of dash .

F1.8 10 Electronic Automatic Temperature Control (EATC) module (19980), Exterior

rear view mirror, left, Exterior rear view mirror, right

F1.5 7.5 Powertrain Control Module (PCM) (12A650), Deactivator switch, Third row

folding seat relay, left, Third row folding seat relay, right, Power lift gate

module, Brake pedal position switch (13480), Sunload sensor (19E663),

Clock (15000), Function selector switch assembly, front, Electronic Automatic

Temperature Control (EATC) module (19980). Don't think you have a fuse problem ! More then likely the HVAC control module is bad , they do go bad
Don't




Jan 05, 2016 | Lincoln Cars & Trucks

1 Answer

I need an Air Suspension Module for a 2003-2006 Lincoln Navigator....Anyone got a clue where to find one...other than the dealership??..


I changed one recently on about same year navigator
I found one at a local salvage yard pretty cheap
I Also cut harness off of donor vehicle cause the one I was repairing also had melted connector at module
The module is located behind from bumper on pass side

Apr 06, 2014 | 2006 Lincoln Navigator

1 Answer

Where is the body control Module located in 2010 Lincoln Navigator


Under dash board on driverside or passenger side ..Hope this Help's u...

Jun 25, 2013 | 2010 Lincoln Navigator

1 Answer

What causes the left side seat not to heat up in a 2003 lincoln navigator


Make sure you first check every fuse in the car and under the hood.If every fuse is good then its either the seat heater control module located under each seat,or burned out heating elements.The mirrors could be a faulty switch.

Feb 05, 2012 | 2003 Lincoln Navigator

1 Answer

Wheres the air ride compressor relay located


The 2003 Navigator COMPRESSOR module is located under the dash on drivers side above the parking brake pedal.

Read more: http://wiki.answers.com/Q/Where_is_the_air_ride_suspension_relay_on_a_2003_lincoln_navigator_located#ixzz1AWFpFFoj

Jan 09, 2011 | 2003 Lincoln Navigator

1 Answer

2003 Lincoln Navigator: The air suspension is gone and I need to know which relay controls the module.


Go to ebay motors and check out the air suspension compressor for the navigator, Mine is starting to go as well, runs all the time and getting noisy. I talked to an expert that says they are easy to change out yourself.

Nov 04, 2010 | 2003 Lincoln Navigator

1 Answer

Where is the airsuspension relay and module located on a 2003 lincoln navigator


the relay is by the water tank on top of the air pump and the relay is under the dash drivers side close to the upper brake pedal hope that helps

Sep 07, 2009 | 2003 Lincoln Navigator

2 Answers

2003 where is the modules for the liftgate in a 2003 lincoln Nav


tascafordparts.com for discount.

The liftgate actuator and remote control are in the liftgate.
The module is in the left rear quarter trim panel.


SECTION 501-03: Body Closures 2003 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION Power Liftgate Module Removal and Installation
NOTE: Prior to removal of the power liftgate module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new power liftgate module once installed. For additional information, refer to Section 418-01 .
  1. Remove the rear quarter trim panel. For additional information, refer to Section 501-05 .
  1. Remove the power liftgate module.
    1. Disconnect the electrical connectors.
    1. Remove the bolts.
89dd4de.gif
  1. NOTE: Once the new power liftgate module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new power liftgate module. For additional information, refer to Section 418-01 .

-----------------------------------------------------------------------------------------

Principles of Operation
The power liftgate is controlled by the power liftgate module.
The power liftgate module receives inputs from:
  • glass position switch (determines the ajar status of the liftgate glass).
  • forkbolt switch (determines the primary position of the latch).
  • detent switch (determines the secondary position of the latch).
  • home switch (determines the power cinch status).
  • power liftgate control switch (activates the power liftgate from the interior of vehicle).
  • pinch strip switches (determines if an obstacle is detected between the pinch strip and liftgate).
  • instrument cluster module (activates and sets the options for the power liftgate).
  • optical sensor (determines the direction, travel speed and obstacle detection of the liftgate).
  • UBP serial communication link.
The power liftgate module sends outputs to:
  • liftgate motors.
  • power cinching latch system.
  • liftgate chime module.
  • body security module
------------------------------------------------------------------------------------

The liftgate consists of the following components:
  • liftgate window glass latch
  • door lock actuator (power liftgate only)
  • liftgate latch
  • liftgate handle
  • liftgate latch remote control (power liftgate only)
  • liftgate ajar switch
  • chime module (power liftgate only)
  • -------------------------------------------------

Apr 14, 2009 | 2003 Lincoln Navigator

2 Answers

Wiring got wet now power seats, dome lights, radio, rear ac work intermittently


There is a Technical Service Bulletin which indicates that moisture on or in certain wiring harnesses and electrical components will cause the GEM (Generic Electronic Module) to FAIL. Look up: Gem problem on Navigators.

Sep 13, 2008 | 2003 Lincoln Navigator

Not finding what you are looking for?
2003 Lincoln Navigator Logo

Related Topics:

706 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

fordexpert

Level 3 Expert

5471 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...