Question about 2006 Scion xB

Open Question

How do you install rocker panels on 2006 scion xb ?

Rocker panels

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 255 Answers

SOURCE: scion xb wont start

Hi.. Yes i fix my problem by disconecting the neutral suitch and reconecting it ,,they get dirty with time and dont make contact ,Is a good idea to disconect and clean as many contacts as you can and put some special grease on them to prevent other problems ...

Posted on Jul 29, 2008

  • 1201 Answers

SOURCE: Warning lights won't go off.

You need to have a code scanner hooked to the car to find out why the lights are on, if there is an auto zone or advanced auto near you, go there and ask them if they can hook one up, or call around to see who can do it.

Posted on Jun 01, 2009

  • 38 Answers

SOURCE: How do I install alt. belt on 2005 scion xb?

I just looked at my '04 xB. It looks very straight forward.
loosen the bolt that holds the alternator to the bracket.
carefully slide the alt to the bottom. (Also be aware of the plug and wires on the alt.They should never hold the weight of the alternator. You dont want them breaking prematurely.)
Pull the belt off, remove the belt from the crank shaft pulley.

Do the reverse, and you will have replaced the belt.

Make sure to check the belt in about a week or so.
New belts will stretch over time. Make sure you keep the tension tight enough to work correctly, but not so tight that the alernator shaft is warped.
I usually place the new belt on both pulleys and give a good "medium" pull on the alt while tightening. Find the middle of the belt and squeeze them together, depending on the type and length of the belt, there should be about 1/4" of flex on both sides.

Posted on Jun 29, 2009

  • 1 Answer

SOURCE: 2006 scion xb 100,000 mile what kind of maintenance do i need??

I would recommend getting the transmission serviced, and the antifreeze changed.

Posted on Aug 10, 2009

  • 336 Answers

SOURCE: 2005 scion xb speaker size? dash doors rear panel

Front Door: 6-1/2", Back Panel: 6-1/2" theres no list for dash speakers. I hope this helps

Posted on Aug 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Remote starter only allows my starter to turn over twice; needs at least 3 with my key. How to adjust to have it starter run longer on remote?


I know you are looking to have the remote starter run a third time but I would say you need to look at your Fuel Pressure Regulator on the Scion. Sounds like it is not holding fuel pressure at the fuel rail and that is why it requires a third Crank

Jan 05, 2016 | 2006 Scion xB

1 Answer

2006 scion xb ac not getting cold


Hi do you know were is the neutral switch located on a 2006 scion cb

Apr 07, 2012 | 2006 Scion xB

2 Answers

Can't find the jack?


My Scion 2006 has it under the Driver's seat.

Apr 03, 2010 | 2006 Scion xB

1 Answer

How to replace tail light housing


for the most part you open the rear hatch and remove the panel and then you can see the small nuts or screws you need to remove to get it out try these websites www.autozone.com and www.alldatadiy.com if all fails stop by your local Scion dealership in the parts department and they will print you out a some pictures and diagrams wish you the best of luck Michigan.

Nov 13, 2009 | 2006 Scion xB

1 Answer

Driver's side door lock not responding to keyless remote or to interior switch - 2004 Scion xB


I had that issue with my scion xb. When I installed my audio system somehow the vibrations loosened the button wires clip . I removed the door panel and clicked it back in, also it could be a dead solenoid or disconnected door wire that goes from the 'noid to the door lock pin.

Aug 03, 2009 | 2005 Scion xB

2 Answers

2006 scion xb 100,000 mile what kind of maintenance do i need??


I would recommend getting the transmission serviced, and the antifreeze changed.

Jul 30, 2009 | 2006 Scion xB

1 Answer

How can i change the taillight len of a scion xb 2006?


their are 2 bolts in the qtr panel then slide out need step by step instructions go to collisionrepairadvice.com

Apr 11, 2009 | 2006 Scion xB

2 Answers

Drain plug for the transmission fuild on a Scion xb 2006


Automatic or manual? No need to change either until 100k.

Nov 18, 2008 | 2006 Scion xB

2 Answers

Fuse box


The fuse box is located just above and to the right of the hood latch release. There's that little cubby there. Put your finger in the hole and pull back toward yourself and down slightly. It should just pop out. Fuse panel is behind there.

Aug 03, 2008 | 2006 Scion xB

Not finding what you are looking for?
2006 Scion xB Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Scion Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Brad Brown

Level 3 Expert

15451 Answers

Are you a Scion Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...