Question about 1999 Jeep Grand Cherokee
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the foremost part of teh dash is a couple of inches wide and length of the dash. Take a panel prybar ( usually plastic ). I use a kitchen spatula to lift it up. that's all there is too it!
Posted on Jul 31, 2009
There are two parts to it, a voltage resistor, and the EL panel itself.
You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.
There are a total of 6 flat screws, and 3 self tapping screws you have removed.
Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.
Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.
Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.
Re-install everything in the opposite order.
Posted on Oct 11, 2009
Use a dime to split the unit in half. The battery should be visible. If not pull the rubber buttons and circuit board. Remove and Replace battery and snap bact together.
Posted on Feb 10, 2010
Testimonial: "very helpful"
Tips for a great answer:
Unlock all of the Jeep Grand Cherokee's doors and open the driver's side door. Keeping the door open, lock it using the manual lock on the door itself.
Put the manual key into the ignition and switch it to the "On" or "Run" position, whichever applicable, without starting the engine.
Point the remote at the receiver (located by the little bulb on the car ceiling) and hold down the "Lock" button for up to 5 seconds.
When the driver's side door unlocks, you know the remote has been programmed correctly. If you are only programming one remote, jump to the next step. If not, manually re-lock the driver's side door and repeat steps 5 and 6 using each remote you would like to program and then continue.
Turn the key to the "Off" position and turn the ignition on immediately. This must be done within 20 seconds of programming the last remote. You're finished!
Feb 11, 2013 | 1996 Jeep Grand Cherokee
Jun 01, 2012 | 1999 Jeep Grand Cherokee
Jan 17, 2012 | 1998 Jeep Grand Cherokee
Aug 16, 2010 | 1999 Jeep Grand Cherokee
May 10, 2010 | 1999 Pontiac Grand Am GT
Apr 09, 2009 | 2000 Jeep Grand Cherokee
Mar 14, 2009 | 1999 Jeep Grand Cherokee
Jan 20, 2009 | 1995 Jeep Grand Cherokee
Aug 16, 2008 | 1999 Jeep Grand Cherokee
37 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: