Question about 1994 Jeep Cherokee

Open Question

None of the dash gauges work on my 1994 jeep

Took my jeep to get heater fixed. They hooked up an on off swith to the fan motor(which they replaced) and now the dash gauges don't work

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1071 Answers

SOURCE: none of the dash gauges work on my 99 jeep Cherokee

remove the cluster clean contacts with dielectric spray then apply dielectric grease to connectors and reinstall if this doesnt help you need a cluster

Posted on Aug 05, 2009

  • 645 Answers

SOURCE: ac/heater fan switch problem on a 2006 jeep commander

next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just pull it out and replace.

Posted on Feb 13, 2010

Testimonial: "This info was very helpful but need a little more info of where the fan motor is located. I will post another question to find that info."

  • 306 Answers

SOURCE: 2001 Jeep Wrangler heater blower stopped working

Yes I would go with the switch, BUT, does it have a resistor bank? That is, how does it reduce the speed? Many systems use resistors to lower the speed. Burnt or bad connections can cause this as well.
You can test the blower motor by connecting direct power from a source like the cigarette lighter if you are handy.
Most of the time the lower speeds konk out but the high speed continues to work this is the resistor bank that goes out.

Posted on Mar 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Remove gauge cluster from 1994 eagle vision


I do not think that this is your problem ,if you smelled some wires burning you had a short under the dash or something , I very rarelly seen clusters go bad find your short first , this may also be why your lights are not working right either

Jan 01, 2013 | 1994 Eagle Vision

1 Answer

1994 ford thunderbird no power at heater blower motor control module


I've had the same problem with my 1994 Cougar XR7. It wasn't the module control. It wasn't the fan. It was a bleepin' inline fuse; a 30. Changed the fuse and everything was working fine. That's after I had purchased a new fan motor and electronic control module. None of the book or web pages I have read mentioned that fuse, which for some reason, Ford didn't put in the fuse box with the others. So, check your inline fuse, it may be just that. And it is located past the fuse box under the dash. It'll be the same thing for the T-Bird.

Dec 04, 2011 | 1994 Ford Thunderbird

1 Answer

None of my gauges work on my dash board.... the gas hand,the speedometer.....none of it and my gas hand is stuck at 3/4 of a tank how do i fix it???


GM had gauge cluster problems from 2000-2005. Bad stepper motors. On those units you have to replace the cluster or rebuild it with new stepper motors. Dealership fixed mine for $150.00

Jan 06, 2011 | 2000 Chevrolet Impala

1 Answer

I have a 1994 honda accord lx..heater fan was makin funny noises for a while..then stopped working..started working and stopped again..Is it hard to replace..could it be a fuse..I;m a girl..could I do it...


The heater fan is on the right side floor board under the dash. It is a little tough to do but not extremely hard. If the blower was making noise, it could be something in the heater housing. If it is starting and stopping it is probably the blower motor. When replacing the blower motor you may have to remove the fan from the motor depending on where you buy a new one. The fans (usually made of plastic) break very easy. If you attempt this, be very careful in removing the fan.

Under the dash on the right side you will have to lay on the floor and look up. There may be a lower dash panel to remove. The motor is just below the glovebox. Removed the wire, remove the bolts/screws attaching the blower to the housing. Remove the blower.

Dec 29, 2010 | 1994 Honda Accord

1 Answer

I have a 1994 plymouth sundance when the fan is turned on the temp, and fuel gauge peg out (read maximum) the volt gauge reads zero. Also both green arrow turn singal indicators on the dash light up. ...


this car is obd 1 so your would need to have a scanner that connects to OBD1, the caonnection ie under the dash, but is diffrent from the newer cars with OBDII, this problem sounds like a bad feed due to a short maybe in the blower resistor or the heater controls, i would start with the resistor then work my way to controls take a good look at the fan switch, hope this helps.

Sep 13, 2010 | 1994 Plymouth Sundance

1 Answer

None of the dash gauges work on my 99 jeep Cherokee


remove the cluster clean contacts with dielectric spray then apply dielectric grease to connectors and reinstall if this doesnt help you need a cluster

Aug 05, 2009 | 1999 Jeep Cherokee

1 Answer

1994 Lincoln town car/ no fan control on ac and heat


I aasume you mean blower motor for heater/a/c system.

Does it work on hgih speed only? If yes, replace resister.

Is this manual a/c or electronic?

Here is circuit for manual. check these three fuses first. 1, 17 & 10 in fues panel behind dash or kick panel by driver's knee.

0ecd810.gif
If you have electronic, you may have a bad "blower motor speed controller". Get used at car-part.com. page with asterisk is lowest price. New at tascafordparts.com

Jun 16, 2009 | 1994 Lincoln Town Car

2 Answers

Gauges on dash not working


to fix the motors to gauges need to be replaced each gauge has one i got mine on ebay is the only fix cost for all motors 35.00 dollars

Apr 21, 2009 | 2004 Chevrolet TrailBlazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...