Question about 2002 Jeep Grand Cherokee

1 Answer

Removing an alternator from a 2002 jeep grand cherokee

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 444 Answers

Only thing i can suggest for you to do is to get a repair manaul from somewhere ,With step buy step instuctions in it. It is to ******* here to try to (Explain) To a person how to do it, Because of the way the vehicles are design in the last 15 years. Get a chilton repair manual for it, They are verry good with there details on how to do stuff on vehicles,

Posted on Oct 25, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2002 jeep cherokee laredo

the only problem that vehicle has is with cooling fans is relay/module or electrical harness to module that burns up located behind and under right front headlamp assy must remove headlamp to access relay/module that is what powers up fan motor module assy.

Posted on Aug 10, 2008

  • 1596 Answers

SOURCE: 1995 Jeep Grand Cherokee - Removing serpentine belt

Faceing the Engine The Tentioner is on the LEFT side next Pulley Down from the Alternator , Use A Box end 6 point Wrench to Turn Tentioner To the Right (CLOCKWISE) to Loosen the Belt, Take A Good Look at it If there is No Belt Diagram to Remember the Way It is Routed if thats all you need then you R on your way. Good luck !

Posted on Feb 05, 2009

  • 114 Answers

SOURCE: 2002 wj jeep grand cherokee p1756

The governor pressure sensor is the most likley cause however an inspection of fluid or debris in trans pan would be a good idea to make sure there's nothing excessive in it. Attached is a list of possible causes however the senor would be the most common.

POSSIBLE CAUSES

  • Powertrain control module
  • 5 volt supply circuit open
  • Check transmission fluid level and condition
  • GOV press sensor signal circuit shorted to voltage
  • GOV press sensor signal circuit shorted to sensor ground
  • GOV press sensor signal circuit shorted to ground
  • GOV pressure sensor signal circuit open
  • Sensor ground circuit open
  • GOV press sensor signal circuit shorted to voltage inside transmission
  • 5 volt supply circuit open inside transmission
  • Intermittent governor pressure solenoid
  • Internal transmission problem
  • Oil burnt or oil pan has excessive debris
  • Other transmission DTC'S
  • GOV press sensor signal circuit shorted to sensor ground inside transmission
  • Valve body
  • GOV press sensor signal circuit shorted to ground inside transmission
  • GOV press sensor signal circuit open inside transmission
  • GOV press sensor ground circuit open inside transmission
  • Governor pressure sensor (high)

Posted on Mar 26, 2009

  • 2 Answers

SOURCE: How do I remove the plastic headlight covers to clean them?

Remove the screw on top of the lamp assembly. The lamp assemble come off as one unit. There are three contact clips that hold the lamp on. They may be frozen fast. Try spraying oil to loosen before removing lamp assembly. To remove the lamp, push down on the top of the lamp, this should loosen the top pin from the holder,then try to pull the assembly straight out. It takes some tugging and pulling if the light assembly has been in for a few years. In fact the clips may snap off and need to be replaced before putting in a new lamp assembly. Good Luck

Ed

Posted on May 06, 2009

  • 90 Answers

SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE

remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly

Posted on Jul 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 Jeep Grand Cherokee Laredo - Unibody Frame or not?


i would in all honesty scrap this vehicle as i would not feel safe driving it again ,

Jul 15, 2010 | 2002 Jeep Grand Cherokee

1 Answer

The rear differential leak on my 2002 Jeep Grand Cherokee


If your talking about the cover then yes it is very easy to accomplish.

Sep 21, 2009 | 2002 Jeep Grand Cherokee

1 Answer

I need to drain my radiator on a 2002 jeep grand cherokee


On many of these, the drain is on the right front of the radiator, sometimes requiring removal of a small panel in the grille or the entire grille. The ones I've serviced, after geting to the drain I've found that it dosen't turn. It is far easier to ignore the drain altogether and remove the lower hose at the radiator. Don't do this on a hot engine unless you like hot antifreeze baths! (I don't)
Good luck

Mar 21, 2009 | 2002 Jeep Grand Cherokee

2 Answers

Setting timing on a 2002 jeep grand cherokee


You cannot set timing on the car.
The distributor cannot be moved.

Sep 25, 2008 | 2002 Jeep Grand Cherokee

1 Answer

Alternator and belt tension


I removed the alternator for my 2002 Jeep Grand Cherokee. I started by removing the belt, by placing a 1/2" ratchet in the groove on the belt tension pulley. Once the belt was removed I removed the two bolts holding the alternator in place and the wiring. The alternator bracket held the alternator tightly, it took a little persuasion with a heavy hammer and a piece of wood. The wood protected the alternator from damage. I also, had to remove the battery box and top radiator hose to get enough room to hammer the alternator out of the bracket. Putting the new one in also, took lite taps with a hammer to place it in the bracket.

Jun 15, 2008 | 2002 Jeep Grand Cherokee

Not finding what you are looking for?
2002 Jeep Grand Cherokee Logo

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...