Question about 1996 Dodge Ram 1500 Club Cab

1 Answer

Parked truck,came back out- wouldn't start.

It was suggested-oxygen sensor...got it home-won't start again.more than one sensor?

Posted by on

  • buzz_krause Jan 06, 2009

    right you are my friend.ignition wires-melted.looking into,a short...i'll most likely replace the power distribution center.tank you tank you.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 36 Answers

The oxygen sensor would not be related to a no start problem as it does not log any info to the computer until the exhaust temp reaches a set parameter. You need to start with the basics when diagnosing a no start condition, fuel, and ignition.

Posted on Jan 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Sometimes my 2008 sonata won't start back up after turning off engine, I have to wait at least 20-45 minutes for it to start back up. I hear 1 click when I turn the key and everything else seems to...


Sounds like it could be a similar issue to what I just went through. My car wouldn't start on two separate occasions after I had refilled my tank. First time happened a little over a month ago, the starter would crank, and crank, but no signs of life in the engine. Tested the spark plugs, I was getting spark, but the ****** wouldn't start.
Had it towed to the dealership, and they said after 4 long attempts, they got it to start. I took it home, and the next morning I couldn't start it again. Towed it back a second time, and it started right up for them. Drove it back home again and a a month later things started acting up again.
A few days ago the wife pulled the car out of the garage, where the car was level, stopped the car on our slanted driveway and when she came back to start it just minutes later, it hesitated, but did turn over. I filled up the tank and the very next morning, I could not start my car again.
Called for a tow from AAA, and the driver said "let me try something". Pulled out a hammer, and wacked the bottom of my gas tank 4 or 5 times. The tow guy gets in, tuns the ignition to engage the fuel pump (didn't turn the key all the way), he does this about 4 times, then the very next turn of the key it starts right up. The driver said it sounded like a bad fuel pump.
I drive the car back to the dealership (this is the third time) and talk to the same guy I had dealt with all along. He calls me later in the day to tell me they finally got it to not start and were able to isolate the problem to the fuel pump sensor. They replaced the fuel pump assembly and I was off and running.
Hope this helps!

Jun 12, 2011 | Hyundai Sonata Cars & Trucks

1 Answer

Hello. My 1997 Chevy Tahoe refuses to start. The problems began with a bad fuel pump. I changed. It worked. The fuel pump died again. I changed it again and it has been working. I parked it for two weeks....


Now you have a good battery & a starter that turns over the motor

Have you cycled the key on & off with a fuel pressure gauge on the
fuel rail?

Do you have a fuel filter that isn't over 3 or 4 years old?

Have you checked for spark while cranking ? Use an old plug on the wires,
if you have ignition wires,don't ground the wire without resistance

If you removed the ducting & MAF Sensor it won't start

Tell us what you checked & exactly how that was done.

Jun 09, 2011 | 1997 Chevrolet Tahoe

1 Answer

I have a 2006 Pontiac GT G6 Coup. When we first bought it back in Nov. 2010, it was fine. After a month or two, the clock would reset almost everytime the car was started, radio stations would NOT get...


sounds like a problem with the ignition barrel.the wiring is loose or the connectors are loose or the barrel is faulty,unless thse are all run from the onboard computer.

May 31, 2011 | 2006 Pontiac G6

2 Answers

My 88 Oldsmobile Cutlass Ciera is running rich and


The Oxygen sensor is very suspect. it is easy to damage on install, even with the correct tool.

Put the old one back in and test the car...

Jan 31, 2010 | 1990 Oldsmobile Cutlass Ciera

1 Answer

Wont Crnk


did ya get it goin???? havent heard from you???????

Oct 26, 2008 | 1995 Jeep Cherokee

1 Answer

Wont Crank


It's probably one of these:

1.NSS- (Neutral Safety Switch)
2.CPS- (Crankshaft Position Sensor)

**Look here-
CPS 1/2 way down..
http://www.lunghd.com/Tech_Articles/Engine/Basic_Sensors_Diagnostics.htm

**And here-
NSS.. .
http://www.cherokee-jeep.com/1-2swremov.htm

Oct 24, 2008 | 1995 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...