Question about Toyota Corolla

Open Question

Yaris bogs down

Wont rev clanly from cold until over 3000 rpm very hesitant pulling away once going seams fine whilst reving. ticks over and starts fine holds back a bit when blipping throttle when warm

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76649 Answers

SOURCE: not reving high on cold start

Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

Posted on Feb 06, 2009

Ad
  • 6 Answers

SOURCE: 2000 nissan xterra hesitating when engine is warm

We are having the same problem. We are right now changing the crankshaft position sensor along with the intake and manifold gaskets.

Posted on May 14, 2009

  • 5 Answers

SOURCE: 2500 to 3000 rpm idle

Change your Thottle positioning Sensor. My 93 lesabre did the same thing and i changed the TPS and it stopped.

Posted on Jun 25, 2009

  • 3640 Answers

SOURCE: saab 9-5 need to give alittle throttle for cold engine start

the idle air control valve may be bad or just needs cleaned out. idle air control valve acts the same as a choke. if it is messing up it will cause engine not to run right.

Posted on Jan 27, 2010

alicantecoli
  • 22219 Answers

SOURCE: Engine idle problem. Range Rover 4.6 HSE 1998 Have

sorry but you have tried everything i would have done except that i would have checked the engine breather pipes for deterioation like perished or soft and collapsing .you would be surprised how often this is the main cause of this sort of problem

Posted on Aug 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 sunfire 2.2 not reving over 3k rpm while driving


probably in limp mode
have the fault codes read to determine the fault

Apr 11, 2017 | Cars & Trucks

1 Answer

When I start my 1996 Honda accord the engine seems to sputter rpm gauge revs up on its own and spits and sputters as I'm driving down the road


My sputtering & stalling 1993 Honda Accord - YouTube

? 2:12
https://www.youtube.com/watch?v=Ki2H9aq8Xis
Jun 23, 2011 - Uploaded by mdpbfly
My sputtering & stalling 1993 Honda Accord ... 1996 Acura Integra, hesitation accelerating & misfire. ... 1993 Honda Accord Start Up and Review 2.2 L 4-Cylinder ... SIR B16A Engine sputter/ power loss at higher RPM - Duration: 1:14. by ... 1994 Honda Civic Check Engine Light Code Retrieval Tutorial ...

All comments on How To Solve Honda Idle Problems ...

https://www.youtube.com/all_comments?v=L788jKEVblY
What should I do if once I turn on my Ac my idle drops as if it's gonna die, and .... to a complete stop the rpms start going up and the car accelerates on its own. ... Honda Accord LX, and my Honda just started sputtering in idle. check engine .... My cousin replaced my radiator on my 90 civic and since then my temp gauge is ...

Acceleration Bog/Sputter/Hesitation - Honda-Tech

honda-tech.com/honda-accord.../acceleration-bog-sputter-hesitation-279...
Jun 11, 2010 - 1990 Honda Accord Ex F22 209000 miles, recent alternator change When I ... When I take off from a stoplight I get a little hesitation/bogging/sputteringfeeling until about 2,000 RPM then ... My 1999 Accord had a similar problem (F18B2engine). ... It only lasted a second or so before it would actually rev up.


Dec 28, 2015 | Honda Cars & Trucks

1 Answer

2002 jaguar xj8 when I drive it won't go over 3000rpm


Jaguar wont rev 3000 rpm Questions & Answers - Fixya

www.fixya.com > Forum > Tags > wont rev 3000 rpm
1998 Jaguar XJ8 won't rev over 3000 rpm ... Wont go beyong 3000 Revs s type 2001, wont go beyond 3000 Revs and it' in limp ... Question about 2002 X-Type ... My jaguar xjr8 year 2000 battery went dead started car went for short drive back ...

Jaguar engine cuts 3000 rpm Questions & Answers - Fixya

www.fixya.com > Forum > Tags > engine cuts 3000 rpm
1998 Jaguar XJ8 won't rev over 3000 rpm ... engine cuts out and shudders at 3000 rpm won't accelerateobd code p0332 2002 jaguar x type 3.0 l P0332 - Knock ... Car is boging out in park and will not go over ... driving, don't worry about it.

Rev Won't go up

www.jaguarforum.com/showthread.php?t=14662

Dec 15, 2015 | Jaguar Cars & Trucks

1 Answer

Wont rev 3000 rpm


You can continue replacing parts at random or have a competent diagnosis made to identify probable causes of the problem(s).

Mar 24, 2014 | 1997 Nissan Pickup

1 Answer

Erratic idle audi


see the diagram attached and proceed and fix it. God bless you
dea71140-af7c-491a-8097-25ebfefe9ded.jpg5c25fb23-cca2-42cd-b743-69d69c9cd50c.gif

Jul 10, 2013 | Cars & Trucks

1 Answer

My1991 mazda 626 will not rev up over 3000 rpm


DO YOU MEAN WHEN YOU ARE ACCELERATING? Or do you mean sitting and reving the engine? If you are just reving the engine in park then the rev limiter is kicking in.

Feb 07, 2012 | 1991 Mazda 626

1 Answer

89 Chevy Sprint takes about 5 minutes to warm up to be able to drive away or it stalls when I give it gas. The engine will rev up for 3-4 seconds then drop down and almost stall and then rev again during...


Plug the vacuum line you unplugged and the idle should come back. Change your air filter and the map sensor. check for correct coolant level and replace the coolant temp. sensor. This sensor affects cold starting and idle through the ECU (open loop mode, rich fuel mapping and 1200 rpm idle) It should go to closed loop mode in the ECU once engine warm up is achieved ( lean fuel mapping and normal 900 rpm idle). Do not unplug anything else till you perform an OBDII scan of the stored fault history

Jun 14, 2017 | Chevrolet Sprint Cars & Trucks

1 Answer

Problems accelerating


the engine tickover is too slow when the engine is cold its running on cold start, ie:choke,, after it warms up the engine slows down this is what is causing it to stall in gear,, get some one to hold the brakes hard on and with the engine running in gear ajust the tick over till its reving at 750 - 850 rpm the revs will go up a bit when its out of gear,, before you pick a gear to go into push the foot brake down to stop the car lurching,,,

Feb 19, 2010 | 1997 Cadillac DeVille

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...