Question about 1991 Chevrolet Lumina

1 Answer

Want crank back up after its hot just spins over wait as long as 45min before crank

New fuel tank and pump.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

I had a z24 that did just that.It was the coil packs on it.

Posted on Oct 24, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

cadman000
  • 607 Answers

SOURCE: 2003 chev cavalier turns over wolnt start

sounds like afaulty in tank electric fuel pump

Posted on Mar 28, 2009

jeffbvegas1
  • 520 Answers

SOURCE: turn key, cranks but no fuel still after new pump.

every key cycle(5 secs appart) will turn pump on for 3 seconds.This is done to insure pressure at the injector when cranking,otherwise hard starting would insue.The engine computer drives a relay in the underhood junction box which sends 12 volts to the pump.An audible click of that relay and the pump can be heard key on/engine off for 3 secs via the ignition signal to the ecm which drives the fuel pump relay.

Posted on Jul 16, 2009

heavymetal77
  • 721 Answers

SOURCE: spinning but no fire or fuel to crank

Ok,well need a little more info,but here it goes. Is there power to the pump with the key on for 5 sec. or so is all it will stay on unless cranking. Check the fuel pressure. If there's no power anywhere but the starter then it's a bad fusible link. There's basically a wire that acts like a fuse & they're bolted to the main post on the starter. There could be some in the fuse box under the hood also. If the fuse link is bad,you can either use an ohm meter of just wiggle them with the key on until something lights up, then be sure to use the proper fuse link wire not just any wire type works safely. Make sure it's roughly the same length when you splice it in,longer it is the more resistence it handles,fire hazard. The under the hood fuses are just plug in. Write back if you need more help.

Posted on Jun 27, 2009

  • 574 Answers

SOURCE: 95 Z28, is hard starting especially when low on

pickup valve or fuel pump

Posted on Aug 25, 2009

  • 97 Answers

SOURCE: 1994 Chevy Diesel just quits

The P,T pump is likely the problem . The pump is inside the engine and is really expensive to replace.

Posted on Jan 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

1992 Ford Ranger cranks and cranks then starts


possibly the fuel system is getting weak change filter and when first trying to start wait for 15 seconds on the system to load fuel .key on but do not crank .

Aug 06, 2016 | 1992 Ford Ranger

2 Answers

Its cold and engine will crank but wont start, could the fuel pump went out ?


It could be the fuel pump, but try the battery first, it is less expensive and if that's not the problem you can normally take it back. Then maybe try tune-up if you have not had one recently. These are least expensive options as opposed to replacing a fuel pump.

Nov 28, 2010 | 2001 Mercury Mountaineer

1 Answer

2000 ford explorer cranks & cranks &


check fuse first in fuse box if not that then you will probably have to drop the fuel tank and change the fuel sending unit: Note check it first before installing new one because if for some reason thats not it you can just take it back without to much extra effort of having to drop tank again also check the old one by simple hot wiring it.

Oct 25, 2009 | 1999 Ford Explorer

2 Answers

How do I replace a fuel pump on a 2003 escape? Engine not getting enough fuel so when starting car, I get crank but cannot get engine to turn over. Perhaps the pump can wait if someone has other...


Check to see if the inertia switch is tripped first. Read your owner manual for location and how to reset. Just push the button. It usually only trips in an accident to shut off the fule pump in case there is a leak.

here is how to replace the pump. It's good because you don't have to drop the tank!
  1. Relieve the fuel pressure. For additional information, refer to Section 310-00 . (I disconnect inertia switch and crank engine for 10 seconds to revilve pressure).
  1. Disconnect the battery ground cable. (I don't do this myself).For additional information, refer to Section 414-01 .
  1. Lift the LH rear seat cushion.
  1. Position the carpet aside.
  1. Remove the screws and the fuel pump module access cover.
  1. Disconnect the electrical connectors.
  1. Disconnect the fuel and vapor lines from the fuel tank. For additional information, refer to Section 310-00 .
  1. s3k~us~en~file=ani_caut.gif~gen~ref.gif WARNING: The fuel tank may be pressurized. Remove the fuel tank filler cap slowly. If a hissing sound is heard, wait until the condition stops before removing the fuel tank filler cap. If these precautions are not followed, fuel may spray and cause personal injury.
    Remove the gas cap.
  1. Using the special tool, remove the fuel pump module. (If you don't have tool, use a chisel or screwdriver and tap counterclockwise to rotate the ring).
46cace5.gif
  1. NOTE: Install a new fuel pump mounting gasket.
    To install, reverse the removal procedure.
    • Start the engine and visually inspect for leaks.

Not a bad job. buy pump on ebay or new at discount at tascafordparts.com

Jun 21, 2009 | 2003 Ford Escape

4 Answers

2000 chevy surburban 1500 will crank but no start. waited one day then started. Ran for a week. Stopped again. Waited one day no start. Waited three days started again. Any suggestions??


more than likely your fuel pump went out. it's in the tank. you can try spraying carb cleaner in your throttle body and have someone crank it. spray small amount of carb cleaner beware of backfire. do not acclerate while cranking. if vehicle turns on its your fuel pump

May 05, 2009 | 1999 Chevrolet Suburban

1 Answer

I have a 1992 buick roadmaster and if i leave my car off 4 certain hours, itll take forever to crank back up. i purchased a new battery and that doesnt seem like the problem..now it wont start at all. what...


You may have a leak in the fuel system, where the gas is leaking back down into the tank over time. Then, you have to wait until the fuel pump pumps it back up to the carburetor or injection system.

Feb 24, 2009 | 1992 Buick Roadmaster

2 Answers

Car won"t start. starter turns. Happened once before. started after 30-45min.


I would start by banging the bottom of the gas tank while you are cranking it over. If this causes it to start, replace the fuel pump. If it still doesn't start, there is a valve on the fuel rail on the top of the engine (you may have to remove plastic cover). Remove the plastic cap on the valve, and while you have someone cycle the ignition to the run position from the off position, depress the center tab on the valve and see if gas comes out. If it doesn't, replace the fuel pump. If it does, let me know and I will help you further. (note: replace fuel filer at same time.)

Oct 19, 2008 | 1999 Oldsmobile Bravada

Not finding what you are looking for?
1991 Chevrolet Lumina Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...