Question about 1995 BMW 3 Series

1 Answer

ABS and ASC+T lights are on in my 1995 BMW 325i

The lights are off for a short period of time . After driving for a short period maybe 10 miles they come on. After shuting car off they go out until you drive again.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 3 Answers

Try cleaning the abs sensors on the wheel hubs! there magnetic and can collect foreign metal fragments and confuse the cars ecu! also clean the abs rings whilst your there

Posted on Oct 24, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 580 Answers

SOURCE: bmw 520i 1999 abs/asc lights on diagnostic

Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

Posted on Jul 08, 2009

Dvljay878
  • 20 Answers

SOURCE: ABS / ASC light comes on after a short drive

Check/replace all sensors .. ECU

Posted on Jul 07, 2009

  • 636 Answers

SOURCE: 2001 BMW 325i problem: Car runs very rough, but no warning lights

Sounds like a fuel problem , have you changed the fuel filter in a while ? could be the knock sensor or the knock sensor module needs to be replaced.

Posted on Jul 28, 2009

  • 580 Answers

SOURCE: bmw 325i 2003 stall

Sounds like you have a small bit of dirt or grit in the fuel system when accelerating it is drawn with enough force to cut off the fuel supply then is released when engine at Idle.
1 run liquid fuel line/injector cleaner in 1 tank
2 check fuel lines for debris
3 change fuel filters
4 have fuel tank flushed
here is trouble shooting order less expense to greater.

Posted on Aug 23, 2009

  • 977 Answers

SOURCE: '94 BMW 325i temperature light comes on after 10min of driving!

the warning light is controlled by a temperature sensor,maybe this sensor is faulty & needs to be replaced.....hope this helps.....cheers

Posted on Jul 15, 2010

Testimonial: "Thanks, hopefully that is all it is too... I was trying to read up on this (because it's a common problem in these BMWs, but I don't understand what the articles mean)"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1995 325i BMW has been parked for about 5 months. It was running fine before that time. I was driving it on short routes to keep things operating. About 3 months ago I tried to drive it and it had to...


have a load test done on the battery as it may have sulphated up the plates and now will not hold a charge.. A long time stationary and short runs do help the situation.

Oct 08, 2013 | 1995 BMW 3 Series

2 Answers

Have replaced ABS module on bmw 525 E39 and ABS now ok, but the ASC lamp will not go off on the dash and fault code 23 (incorrect coding) will not clear from system? Everyone told us the ABS ecu does not...


ABS/ASC module is faulty
CLASSIC ABS FAILURE SYMPTOMS:
- Most of the time, the problem is the ABS module or one of the 4 wheel speed sensors (& sometimes the brake pressure sensor)
- In my 2002 BMW E39 DSC, three orange (warning) cluster display lights lit, ABS, Brake, & DSC
- The 3 warning lights reset when the ignition is turned off, only to repeatedly reappear within minutes of normal driving
- The fault is often intermittent leading you to falsely believe you've resolved the problem (proper diagnosis is important)
- Sometimes the fault only appears when the engine is hot; other times only at speeds over 40 mph
- Carsoft may erroneously show a rear speed sensor failure; but just replacing the speed sensor may make no difference.
- All the work is in correct diagnosis of the problem; parts replacement is trivial (from 1 to six bolts in a few minutes)
- Hence, this BMW E39 ABS 3-warning light DIY will concentrate on understanding and diagnosis of the problem

Oct 23, 2009 | 2001 BMW 5 Series

1 Answer

BMW (e39 1999) eml and asc lights and in limp mode


Check the ABS brake sensors in your wheels, if they are not functioning properly. It will trigger the computer to engage the ASC auto stability control light as the asc uses the brakes to assist in control. I will also engage the EML engine management light to slow the rev point to limp mode

Aug 21, 2009 | 2007 BMW 525xi Sedan

1 Answer

ABS and ASC warning lights stay on 2000 530d


Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

Jul 06, 2009 | 1999 BMW 5 Series

1 Answer

Bmw 520i 1999 abs/asc lights on diagnostic


Check to see if your brake pads and rotors are in good condition. Or if you have replaced the pads yourself and have not reset the wheel sensors this would cause the ABS Antilock Brake System light and the ASC Automatic Stability Control light to stay on as the ASC uses the ABS brakes with computer assistance to control the car

Jul 05, 2009 | 1999 BMW 323 Series

1 Answer

My ASC+T Indicator Lamp lights and car can't move...


When your ASC light is on this is to let you know your Automatic Stability Control system is switched off press the ASC button Till light is off /ASC is on this works with your rev limiter and should stabilized your idle. If the problem persists have your throttle control unit checked as this can trigger the ASC light as well and may also activate the ABS light if not fixed

Jun 06, 2009 | 1996 BMW 3 Series

1 Answer

Asc light comes on and engine cuts out


When your ASC light is on this is to let you know your Automatic Stability Control system is switched off press the ASC button Till light is off /ASC is on this works with your rev limiter and should stabilized your idle. If the problem persists have your throttle control unit checked as thi can trigger the ASC light as well and may also activate the ABS light if not fixed

Nov 11, 2008 | 1997 BMW 318

Not finding what you are looking for?
1995 BMW 3 Series Logo

278 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...