Question about 1993 Jeep Grand Cherokee

1 Answer

Replace neutral safety switch 1993 Jeep 4.0 ltr

Where is it located

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 104 Answers

See if this information helps you any. If not post back up.
http://www.automotivenotebook.com/thread-13.html

Posted on Jan 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of neutral safety switch


a/t (automatic)
is the PRNDL switch on the side of the trans. the N part, does that.

Sep 15, 2014 | 2004 Jeep Grand Cherokee

1 Answer

I need to replace the neutral safety switch on a 1989 Jeep Comanche 5 speed manual transmission


I think you are referring to the clutch pedal safety switch. If so it is located behind the clutch pedal under the dash.

Aug 29, 2012 | 1989 Jeep Comanche

1 Answer

My jeep wont start unless i jump the solenoid on the starter all other electronics work


could be a bad neutral safety switch. did you try to start the truck in neutral ?

Aug 11, 2011 | 1993 Jeep Grand Cherokee

1 Answer

My 93 jeep cherokee does not start sometimes, I have to play with shifter to engage it, when it does engage I hear a click. Have to put it in neutral sometimes to start.


The neutral safety switch is faulty which would explain why sometimes you have to position it in neutral for it to start.The switch is located on side of the transmission,It has a long wiring harness that runs up near the transmission dipstick tube.U can purchase that switch at advance auto.

Jan 29, 2010 | 1993 Jeep Cherokee Country

1 Answer

My car won't shift out of park, 1993 ford crown victoria i need to know the location of the sclu switch and/or the park sense switch


Check to make sure your brake lights are functioning properly. The crowns vics of that year have a neutral safety switch that links the shifter to the brake lights.

If the brake lights don't turn on = it won't come out of gear

If they do turn on = it could be that the neutral safety switch is out of place or malfunctioning.

I do believe that the neutral safety switch in that model should be located near the firewall attached to the upper side of your steering column.

You can easily get a manual for your car or look it up at the library to find it's exact location. Or try asking at your local auto parts store.

Nov 11, 2009 | 1993 Ford Crown Victoria

1 Answer

Neutral safety switch


I would recommend going to the autozone.com website and registering the vehicle. It doesn't cost anything and will give you access to an online repair manual for the vehicle. The steps for replacing the neutral safety switch can be found there. (I checked). Hope this helped and best wishes.

Aug 27, 2009 | 1995 Jeep Cherokee

1 Answer

I need a fuse diagram for a jeep Grand cherokke larado


A very common issue with that particular transmission is the "Neutral Safety Switch". Check fuses of course. But if that is ok then try this. The neutral safety switch is located on the drivers side of the transmission case just above the trans pan. Pull off the three wire connector and jump to two out board terminels (a paper clip will do). Turn on the key and your backup lites should be on. FYI: By the way the center terminel is the neutral safety part (it grounds to the trans). Replacing it is a matter of unscrewing it . Be aware you will get some trans fluid leakage and this switch has a gasket that may or may not stick to the case. Make sure the gasket is there or you will have a leak. (new one would be good but they can be reused) There have also been issues with the rear lighting harness connector located in the rear corners by the tail lites. (usually those create lamp outage warnings with the Vehicle Information Center) Good luck

Mar 29, 2009 | 1993 Jeep Grand Cherokee

2 Answers

2004 Jeep Grand Chrokee Neutral Safety Switch Location


The switch is on the transmission..It is usually a dealer item but you can get one from Rockauto.com for about 1/4 of what the dealers charge.

Mar 26, 2009 | 2004 Jeep Grand Cherokee

2 Answers

Where is Neutral safty sensor switch located on Grand Cherokee


OK then the switch is part of the gear selector switch on the side of the trans where the shift linkage hooks up. here is a picture and part number.
ACDELCO Part # C2241 $233.89

673ffc9.jpg

Feb 17, 2009 | 1996 Jeep Cherokee Country

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

Related Topics:

256 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...