Question about 2006 Honda Accord

Open Question

2006 Honda Accord, Left turn signal does not work, Hazards both work. Bulbs are good front and back. Please help

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
jpetrovic06
  • 8 Answers

SOURCE: 88 Honda Accord left front turn signal assembly

*The Turn signal on the Side of the car next to the headlight*
1. Open the retractable headlights.
2. Remove the plastic shroud around the headlight: two screws in front and one on each side.
3. Look to the outside of the headlight and you will see a single screw in a small plastic cover on the front inside edge of the signal light assembly. The headlight prevents you from getting at the screw straight-on. I broke it loose with an offset phillips screwdriver, and then backed it out with a regular phillips.
4. Remove the plastic cover, and you will see two screws. Remove them.
5. Now you can pull the turn signal assembly forward and out.
6. To remove the bulb holders from the assembly, twist counterclockwise and pull out.
7. Pull straight outward to remove the bulbs. To assemble, follow the steps in reverse. Note that there are two plastic rods on the back end of the turn signal assembly that you will insert into two holes in the channel of the fender

*The turn signal in the bumper*
1. You will need a phillips head And Flat head screw driver, right below the turn signal there is a panel that you can pop out, (or its allready gone, Looks like a Fog light can go in there.)
2. once u find that, (Pretty easy to find) Look directly up in there., there is styrofoam up there and u will also notice a little hole,
3. Stick the Phillips head screw driver in that hole and turn it counter clockwize, The screw will not fall out,
4.once it feels like the screw is loose put the flat head in between the turn signal lense and bumper, the side where you unscrewed it and SLOWLY pry it out,
4. once out, just twist the plug and replace light bulb
to replace just reverse instructions

Posted on Jun 30, 2008

Ad
justuscc
  • 360 Answers

SOURCE: 1992 honda accord LX Blinkers

check the hazard switch ive seen them stick or wear out and nothing works. good luck also look for a bulb with only one prong on the end of the bulb it will short the dash lights to keep signal on

Posted on Sep 17, 2008

  • 740 Answers

SOURCE: 97 honda accord turn signal problem

Flasher unit is bad. Replace flasher

Posted on Dec 28, 2008

bitchn65cuda
  • 70 Answers

SOURCE: directional signal won't turn off

check your hazard switch aka emergency switch. 

Posted on Apr 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

03 Honda Accord v6 left turn signals not working. So I try another flasher relay. Now no turn signals, hazards, or radio/ac lights. ???


It probably blew a fuse.

Flasher unit would not cause one side only to stop working but instead check the switch, wiring, connections and both bulbs.

A little used hazard warning switch is often the cause of strange or unusual flasher behaviour. A couple of minutes of rapid operation often works.

Jun 01, 2016 | Honda Cars & Trucks

2 Answers

My turnsignals dont work on my 1987 honda accord flashers do work


flashers and turn signals have separate flasher and separate fuse.

Mar 14, 2016 | Honda Cars & Trucks

1 Answer

Hi, I have a 2006 Honda accord EX V4. the right side turn signal and hazards are not working. Changed the bulbs an still not working. Left side works find. Could this be a flasher relay problem? I hear...


There could be many things that can cause this. Could be the bulb sockets or fuse box.Hondas typically have a light module located behind the glove box . As well could be as simple as a ground cable or bad alarm or command start if applicable to your vehichle.

Dec 26, 2014 | Honda Cars & Trucks

1 Answer

Honda Accord 2006 turning signal not functioning


First check both front and rear lft side bulbs. Then, I would check the signal relay. I think it is under the dash one the left side. Here is want your are looking for. A new one cost about $12-$15 at most parts stores. Last I would suspect the signal switch assembly on the column. (Perchance you have a trailer hitch plug? If so look there too)

j
uploadswith image12_12_2013_2_15_10_am.jpg

Dec 12, 2013 | 2006 Honda Accord

1 Answer

Just got a 92 Honda Accord and turn signals do not work at all. However, when I turn on the hazards, the left side only blinks. Any ideas?


A few. First, check the condition of the bulbs, sounds stupid, but it's a first start. Basics first, all else later. After a bulb check, go to fuses. From there, use a digital multi meter and backprobe the bulb sockets to see if you're getting good power/ground at the bulb sockets. If none, back probe further up the wiring. Check all ground connections. If still no power but you have a good ground, go to the combination switch and check output/position on the combination switch. (aka, the "self cancelling trafficator", or turn signal switch) If you're there and havn't found the issue yet, start over. Start at the bulb, head to the switch. If you check everything in between, you'll find it.

Dec 10, 2009 | 1992 Honda Accord

1 Answer

Turn signals and hazards dont turn on


The turn signals run through the hazard switch, I have replaced hazard switches for this problem.

Apr 22, 2009 | 1996 Honda Accord

1 Answer

1992 honda accord LX Blinkers


check the hazard switch ive seen them stick or wear out and nothing works. good luck also look for a bulb with only one prong on the end of the bulb it will short the dash lights to keep signal on

Sep 14, 2008 | 1992 Honda Accord

1 Answer

2000 Accord turn signal problem


either the front or the rear turn signal bulb is blown, that is why the flash frequency is high. replace the bulb and the problem will be solved. best to replace both the front and rear turn signal bulbs. good luck.

Aug 29, 2008 | 2000 Honda Accord

3 Answers

Turn Signals/blinkers


Did you double-check to be sure the fuses are intact and not blown? If they are OK, it could be a turn signal relay or the switch itself (I have firsthand experience with the switch failing with respect to headlight operation, so there's no reason to believe that it couldn't fail for turn signal operation as well).

If you find that it's the switch, reply here and I can walk you through its replacement - it's about a five minute job.

Aug 10, 2008 | 1992 Honda Accord

1 Answer

1990 Honda Accord EX; Right-Rear, Left-Rear, and Rear- Window (midlle of rear passenger seat) Tail Lights came on and will not turn off?


1990 Honda Accord tail lights are not working.I have checked all the fuses and the bulbs.Everything is good.Front headlights are working,same with the signal lights.what do I need to check next.

Jul 27, 2008 | 1994 Honda Accord

Not finding what you are looking for?
2006 Honda Accord Logo

Related Topics:

312 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...