Question about 2006 Pontiac G6

Open Question

How to replace catalytic converter on 2006 pontiac G6

Is it bolted in or do I have to change it all the way to the manifold

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

keemo68
  • 1263 Answers

SOURCE: power steering cap location Pontiac G6 3.5L

it is located on the passengerside under the altenator closest to the firewall. make sure the vehicle is turned off reach in under the altenator and you should feel the cap.

Posted on Sep 15, 2008

  • 2 Answers

SOURCE: engine light 2006 pontiac g6(reset)

first be sure that its the engine light and not the "service" light. the service light will usually illuminate if its time for an oil change. if its the service light ur owners manual should tell u how to reset it. if its ur engine light then try disconnecting ur positive battery cable for 1 minute. that should reset ur ecm and get rid of the engine light. if the engine light comes back on then have a diagnostic scan done to determine whats causing it. LJ

Posted on Dec 29, 2008

  • 1986 Answers

SOURCE: What is the tirck to change the headlights on a

  1. On the back of the assembly, unplug the harness that goes to the bulb.
  2. Then pull off the rubber sealer.
  3. There's a wire clip that goes along the bottom side of the bulb to hold it in place. Push that clip in (towards the front of the car) and down to release it.
  4. Pull out the old bulb.
  5. Insert the new bulb the same way (do not touch the bulb as that will cause it to exploded later on from the oil residue. Clean with rubbing alcohol if you touch the glass)
  6. Twist it back and forth to make sure it locks into place.
  7. Replace the clip by pushing in and up until it clicks into place.
  8. Replace the rubber sealer. Push around the entire edge until it snaps into place.
  9. Replace the wire harness.

Posted on Nov 20, 2009

  • 880 Answers

SOURCE: how do I expose the motor on a 2006 pontiac g6 to

Remove everything from the headliner and remove all of the trim holding it in place. Carefully pry the headliner out from one side and the rest will now be easily removed. Unless the car has been subject to abuse and intense heat the headliner will not come loose from the backing and can be reinstalled.

Posted on Mar 27, 2010

  • 11 Answers

SOURCE: changing rear brakes on 2006 pontiac G6 how do i

Ok! here is the solution ...
After changing the pad dont try to push back the piston the old fashioned way or you will broke the caliper casting.
This new kind of break should be only twisted clockwise to bring the piston back to its position you can use only long nose pliers to rotate the piston since there is two cavity on the piston for this use.
Also after setting the piston back to it's position take care of the seal around the piston be shure before replacing the caliper over the disk that the seal will not go between the disk and the pad...
slide the pads gently to it's position and that's it.

Posted on May 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How many O2 senor do a 2006 Pontiac G6 3.5 liter engine has


4 one after the cadilatic converter one before and one on each of the exhaust manifolds or in the pipe just coming out of the manifolds

Dec 01, 2016 | Pontiac Cars & Trucks

1 Answer

What else will pull a p420 on this car - see below.


Drive at least 100 miles on a new catalytic converter. Also, some aftermarket converter I have tried did not work and I ended up using a real GM converter.

Jan 15, 2015 | 2007 Pontiac G6 GT Convertible

1 Answer

How can I tell which catalytic converter is bad on my 2005 Pontiac g6


If its restricted there will be a loss of engine power. If exhaust has the rotten egg smell converter is over worked due to excessive fuel, check fuel system. Restriction can be checked with a vacuum gauge. Connect gauge to full manifold vacuum, speed engine to about 1800 rpm's vacuum should rise if vacuum decreases there is a restriction in the exhaust system.

May 18, 2014 | 2005 Pontiac G6

1 Answer

How do you unclog catalytic convertor?


To my knowledge there isnt a way to unclog them, you have to replace them. The catalytic converters on the G6, run about a thousand dollars a piece, and that without installation, and theres to converters. Go on ebay, I found both of my catalytic converters for around 300 apiece, and they were brand new, by a good manufacturer.

Mar 22, 2014 | 2006 Pontiac G6

1 Answer

Engine reduced power


Your catalytic converters may be plugged. They have had problems out of the converters on the G6s. Probably have to take it to a mechanic, but im going to forewarn you, a catalytic converter for a G6 is around $1,000.00 each, and if its a V6 theres two converters. What I did was went on ebay and I found 2 brand new converters, one was $227.00 and the other $238.00 free shipping on that one, and they also have remanufactures converters too.

Jan 08, 2014 | 2006 Pontiac G6

1 Answer

Multiple misfire 2006 pontiac g6


P0420 is a catalytic converter efficiency below threshold DTC. Are there any other DTCs pointing specific cylinder misfires?

Oct 12, 2012 | 2006 Pontiac G6

1 Answer

Gm just changed my catalytic converter now my o2 sensors went out a week later! what should ido?


You are supposed to always change the sensors with the catalytic converter to avoid this problem in the first place.

Feb 04, 2012 | 2006 Pontiac G6

1 Answer

Fix a whistle on a 2007 G6 3.9L Convertable from the exhaust


locate the whistle noise with a hose with one end to your ear, then probe the exhaust connections until the noise gets loud in your ear.

If it's near the catalytic converter and performance is down, it could be plugged.

May 13, 2010 | 2006 Pontiac G6

1 Answer

How to clean O2 sensor on a 2007 Pontiac G6?


O2 sensor are located before and after Catalytic Converter ( exhaust system of your car). If you car's engine is 4 cyl you have 2 O2 sensors and if you car's engine is 6 cyl then you have 4 O2 sensors ( for each bank, 2 for left bank and 2 for right bank). Hope it helps and comment if you need more advice. Please don't forget to rate the answer it helps with my ratings, thanks!

Apr 28, 2010 | 2006 Pontiac G6

1 Answer

Which is the bank two o2 sensor in a g6 gt


Bank 1 is always the cylinder bank that has piston/cylinder no. 1 in it; usually the left side in a rear wheel drive GM, or the front side in a front wheel drive GM. The O2 sensor will be located on either the exhaust manifold, engine exhaust pipe after the exhaust flange, or on the catalytic converter for the 2 bank.
If this helps you, please remember to vote/comment, and good luck.

Feb 17, 2010 | 2007 Pontiac G6 GT Convertible

Not finding what you are looking for?
2006 Pontiac G6 Logo

Related Topics:

384 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...