Question about 2004 Ford Freestar

Open Question

Ford freestar front washer fluid and wipers inop

Ses

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

gregstobbe
  • 56 Answers

SOURCE: I have a1992 ford explorer the front and rear wipers quit workin

check for power at the wiper motor. If power at the wiper motor but no wiper action then replace the motor. if no power at the motor then use a jumper wire and put power to the motor. Does motor run? if so check for open circuit in the wire someplace.

Posted on Dec 27, 2008

  • 4369 Answers

SOURCE: Front Windsheild Wipers

I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal

  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Posted on Apr 10, 2009

  • 8404 Answers

SOURCE: 1997 Ford Ranger windshield washer will not spray.

Pump running? You can take it out and see if it will run with 12 volts or you can apply 12 volts directly to the motor if you unplug the wires. If the pump will not run ... no spray. Get a new pump at any full service Auto Parts place. Is it possible you have water in the tank and the motor is currently stuck due to frozen water?

Posted on Feb 12, 2010

Testimonial: "Great and timely response. "

honeymokey
  • 3113 Answers

SOURCE: 2001 Ford Focus SES EVAC Leak and Periodic Wiper Problem

Check the hose that comes out of the intake manifold to the pipe that goes to the PCV valve. It gets soft, leaks and will collapse. It has a clamp on it at the manifold be careful as the manifold is plastic. Check while it is running. Common problem.

Posted on Feb 17, 2010

Testimonial: "Thanks for the assistance. Fix'd the problem. You rock!"

bbbman78
  • 680 Answers

SOURCE: The windshield washer fluid isnt coming out for

Yes there are two pumps located in the wiper fluid reservoir. If your in a bind, you can switch the plugs and small hose that go to them because they are both the same. The upper pump operates the back, and the lower pump operates the front. The back won't work until it gets replaced, but it beats driving backwards.

Posted on Feb 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I push the wash button for the front windshield and nothing happens if I turn the wippers on they work this is on 2012 Acadia


GMC Acadia Forum: Front washer fluid not working. Help?

www.acadiaforum.net > ... > Problems, Recalls, TSBs, FAQs & Links

Dec 3, 2010 - 17 posts - ‎12 authors
I had my 2007 Acadia in for the heated washer fluid recall a few months ago. ... bad in the Midwest, I just noticed the front washer fluid not working. ..... the fuse finally seated properly and my windshield washer now works. Front Windshield Washer Spray
20 posts
Aug 26, 2012
Inoperative Rear Driver's Side Power Window
16 posts
Apr 21, 2012
Heated washer fluid
20 posts
Jan 29, 2012
Front Windshield Wiper Motor burning out??
20 posts
Feb 3, 2011
More results from www.acadiaforum.net

Nov 28, 2015 | Cars & Trucks

1 Answer

Rear washer on 2004 Freestar doesn't squirt


The hole where the windshield wiper fluid comes out must be plugged with debris. Get yourself a couple toothpicks and wet them - then widen the hole with them. Be careful not to break one off in the hole. That should solve your problem.

May 03, 2011 | 2004 Ford Freestar

1 Answer

2004 ford freestar 4.2L engine...high pitched


this sounds odd but mine did this when i replaced the wipers. it seems the design of the wiper frame was making a whistle at higher speeds. the freestar wipers are exposed on the window cowl and not hidden so they endure the winds at high speed. it is worth a shot.

Apr 27, 2010 | 2004 Ford Freestar

1 Answer

2001 Ford Focus SES EVAC Leak and Periodic Wiper Problem


Check the hose that comes out of the intake manifold to the pipe that goes to the PCV valve. It gets soft, leaks and will collapse. It has a clamp on it at the manifold be careful as the manifold is plastic. Check while it is running. Common problem.

Feb 14, 2010 | 2001 Ford Focus

1 Answer

How/where do I access the Cabin Air Filter on my


under the hood on the passenger side there is a little black access panel on the area by the wiper arm. this pops off and the filter is right behind it.the hose for your washer fluid runs right past it.

Aug 02, 2009 | 2004 Ford Freestar

2 Answers

The rear wiper on my '99 model exped isnt working ,ford global says its the motor and it will cost me P13k . any one who can help me find a mechanic do some repair on this?


what is P13K?

check the fuse first. dealer can hook up NGS Tester and get fault codes to see what is wrong.

Principles of Operation
NOTE: The generic electronic module (GEM) will not activate the rear wiper system if either the liftgate or the liftgate glass is ajar. If either the liftgate or the liftgate glass becomes ajar while the rear wiper is in operation, the GEM will park the rear wiper motor.
There are two distinct modes of wiper operation:
  • Off Mode: In this mode, there is no rear wiper activity, and the wiper motor will be in the PARK position.
  • Interval Mode: This mode is selected when the rear wiper switch is in either the Interval 1 or 2 position. When this mode is selected, the rear wiper motor is driven up onto the glass by activating the rear wiper UP relay. When the wiper motor HIGH/LOW/PARK position input reaches the high position, the UP relay is deactivated and the DOWN relay is activated to reverse the wiper motor direction. When the wiper motor reaches the LOW position, as determined by the HIGH/LOW/PARK position input, the GEM deactivates the DOWN relay and will begin a new wiper cycle 1 to 10 seconds later, depending on the interval position selected.
To engage the rear window washer, rotate the rear window washer selector downward to the WASH position. The rear window wiper will run as long as the WASH position is selected. When the rear window washer selector returns to the OFF, INT 1 or INT 2 position, the washer will stop immediately, but the rear window wiper will continue for two to three sweeps and then return to its previous mode of operation.
The low washer fluid indicator chime warns that the washer fluid level is low. The low washer fluid indicator chime is a single tone with a duration of one second. The chime will sound when the low washer fluid indicator is initially activated.
The low washer fluid indicator warns that the fluid level in the washer reservoir is low. The low washer fluid indicator will illuminate when the washer fluid level is low and the ignition switch is in the RUN position.
The low washer fluid indicator will deactivate when the washer fluid reservoir is filled and the ignition switch has been cycled from RUN to OFF, then to RUN.
Inspection and Verification
  1. The wiper/washer system is a generic electronic module (GEM) controlled system; refer to Section 419-10 .
  1. Verify the customer concern by operating the wiper/washer system.
  1. Visually inspect for obvious signs of mechanical and electrical damage.


Visual Inspection Chart Mechanical Electrical
  • Hoses to windshield washer pump
  • Wiper linkage
  • Fuses 6 (5A), 8 (5A), 15 (5A), and 20 (5A)
  • Wiring harness
  • Loose or corroded connector(s)
  • Relays
  • Motors
  • Multifunction switch
  • Washer fluid level switch


----------------------------------------
  • The wipers are inoperative — rear
  • Fuses 6 (5A), 8 (5A), 15 (5A), and 20 (5A).
  • Circuitry.
  • GEM.
  • Multifunction switch (wiper/washer switch).
  • Rear wiper up relay.
  • Rear wiper down relay.
  • Rear wiper motor.

May 12, 2009 | 1999 Ford Expedition

1 Answer

2005 ford expedition rear wiper


Sounds like a problem within the wiper motor not turning off at rest or not reaching it's rest point to be able to turn itself off, probably needs a new motor. Disconnecting it should have no relation to the front washer operation, you can confirm this by reconnecting the wiper motor to try.

Apr 12, 2009 | 2005 Ford Expedition

2 Answers

Front Windsheild Wipers


I have 2007 only. please rate as solved if this is what you needed. good luck.

SECTION 501-16: Wipers and Washers 2007 Freestar/Monterey Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 04/27/2006
Wiper Motor — Windshield s7w~us~en~file=adobe.gif~gen~ref.gif Printable View (104 KB) Removal
  1. Remove the windshield wiper arms.
  1. NOTE: Disconnect the washer hose before removing the cowl panel grille.
    Remove the pushpin-type retainers and the cowl panel grille.
  1. Remove the washer hose grommet from the cowl panel and position aside the washer hose.
  1. If equipped, remove the A/C air inlet filter.
  1. Remove the 9 cowl panel bolts and position aside the cowl panel.
  1. Disconnect the windshield wiper motor electrical connector.
  1. Remove the cowl panel from the vehicle.
  1. Remove the 4 bolts and the windshield wiper motor.
    s7w~us~en~file=n0001518.gif~gen~ref.gif
Installation
  1. Position the wiper pivot arms on the windshield wiper motor and install the bolt.
    • Tighten to 15 Nm (11 lb-ft).
  1. Install the 3 windshield wiper-to-cowl panel bolts.
    • Tighten to 15 Nm (11 lb-ft).
  1. Position the cowl panel in the vehicle and connect the windshield wiper motor electrical connector.
  1. Install the washer hose and grommet in the cowl panel.
  1. Install the 9 cowl panel bolts.
    • Tighten to 6 Nm (53 lb-in).
  1. If equipped, install the A/C air inlet filter.
  1. Position the cowl panel grille in the vehicle and connect the washer hose.
  1. Install the pushpins.
  1. Install the windshield arms and nuts.
    • Tighten to 27 Nm (20 lb-ft).
  1. Cycle and park the windshield wipers to check for correct alignment.
3c6f4d5.gif
b8a2ebf.gif

Apr 09, 2009 | 2006 Ford Freestar

2 Answers

Wiper fluid motor?


washer pump located in washer jar. Either washer pump is inop, or possibly a clogged water line or nozzles.

Mar 29, 2009 | 1999 Pontiac Grand Prix

Not finding what you are looking for?
2004 Ford Freestar Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...