Question about 1984 Nissan Pickup

1 Answer

The timing is off

84 nissan pick up 24z

Posted by on

  • 1 more comment 
  • jake_goodson Jan 02, 2009

    i just know, how do you adjust the timing?

  • jake_goodson Jan 02, 2009

    **** u then

  • Mike Butler
    Mike Butler May 11, 2010

    How do you know, what is it doing?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Nissan Master
  • 6,674 Answers

Have you tried loosening hold down bolt & rotating the distributor?

Posted on Jan 02, 2009

  • Mike Butler
    Mike Butler Jan 02, 2009

    ? what is **** u then ? What did I say wrong?



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I have an 84 nissan pick up and my dash lights are all blown. what or how can i fix this?

A quick check of the obvious. Check fuses. On lots of cars the dash lights a tail lights are on the same fuse. I like to check fuses with a test light. A fuse could look good but not be , with the test light you should have power on both sides of the fuses when that circuit is activated. Other than that look for loose wires or bad connections. I hate electrical problems...

Jun 05, 2016 | Nissan Cars & Trucks

1 Answer

How do I remove the engine from my 86 Nissan 4x4 truck?

hi,I have a 85 nissan 720 4x4,had it for over 20 years,here's a link to the engine removal guide,here's my truck. Repair Guides Engine Mechanical Engine AutoZone com Here's a video,i did,have more. 85 nissan 720 4x4 silverbullet

Oct 04, 2014 | 1986 Nissan Pickup 4WD 1986

1 Answer

When do I change the timing belt of a 2004 nissan quest

Nissan recommends replacement of the timing belt and water pump at 84 months or 105K miles whichever comes first. ALWAYS replace the water pump at the same time as the timing belt or you will be out the same amount of labor in 2-3 months when the pump goes bad after the timing belt replacement.

Dec 03, 2013 | 1993 Nissan Quest

2 Answers

I need to know how to set the timing marks on the distributor for a 85 z24

I'm showing the first Cavalier Z24 being sold in 1988 with a 2.8 engine.
I'm not sure what you mean by marks, normally you would like up the marks on the crank pulley and turn the distributor to the point where the rotor is pointing to the number one cylinder plug wire.
If the distributor has been out of the engine, you will be on or 180 degrees off.
Once you get the engine started, you would use a timing light to set base timing.

Feb 07, 2013 | 1985 Nissan Pickup

1 Answer

Does a 1986 24z nissan pickup fire from the intake or exhaust?

easy bring the no 1 piston up to thed top then with the rotor arm pointing at the no lead it willl go then once it starts move distributor till it sounds right with no pinking ,i can do this by ear but it takes a lot of years experiance to do this so borrow a timing light

Jun 06, 2012 | 1986 Nissan Pickup 4WD 1986

1 Answer

Hard time keeping started once it gets hot and dies at every stop and hard to start again

ive had 3 84 nissans and all ended up with the same problem....most of the time its the carb on that truck...not sure why but i put a weber carb and fixed all 3

Sep 20, 2010 | 1984 Nissan Pickup

1 Answer

My daughter just bought an 84 4x4 pick up. It needs a battery. What size/type does it require or what info do we need to make sure we get the right battery at the parts store??

get a battery that fits the tray snugly and with the right posts, the only other option you will have is to decide how many cold cranking amps you want, the person at the parts store can help you with that

Jul 21, 2010 | 1984 Nissan Pickup

1 Answer

84 Nissan Pickup 24z

Burnt wires going into alternator

Dec 15, 2008 | 1984 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

77169 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides