Question about Buick Regal

1 Answer

Door locks keep locking cant find the fuse to replace it

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Check under the hood.

Posted on Jan 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Jeep grand Cherokee 99. I replaced the starter & now the right side Windows,door locks & alarm aren't working! Remote locking & alarm not working.


I dough changing the starter has anything to do with it ! Unless you pulled on the wires an one broke Ground or a power wire ! I'd check wires in the door , the boot going from body to door . wires like to break inside ! would cause windows an locks not to work !

Aug 31, 2016 | 1999 Jeep Grand Cherokee

1 Answer

Fuse 129 keeps blowing x5


The warning light may not have been reset, door lock actuator bad creating a short - blowing fuse, or bad switch.

Dec 13, 2013 | BMW X5 Series Cars & Trucks

1 Answer

Door ajar light on and locks keep locking and unlocking


need to gain access to the BCM to see which door the module is seeing open. the locks won't lock with key in ignition and a door is "open"

Jun 09, 2012 | 1997 Chrysler Town & Country

2 Answers

2001 Mercedes 430 Doors won't lock-trunk won't unlock--OBDII reads 888 Sounds like fuse. Can you help?


Hi, if all of the locks on your Mercedes fail to open (or close) first check your key fob to make certain that its battery is working. Replace the worn out battery, if necessary. If key fob is working, you may have a faulty key fob, which can be repaired or replaced by taking it to your dealer.
If just one lock won't open on your Mercedes, then the problem may rest with broken wiring, a bad solenoid, or perhaps with a blown fuse. Check your fuse box first to determine if a blown fuse is keeping the lock from working. If so, replace the fuse.
You likely have a shorted door lock actuator, which you can replace with a new unit for the lock that is not working. If a door unlocks, but will not lock again, then replace the door switch.

Besides there is not OBD II 888 code, i have never heard or seen it before...

Feb 07, 2011 | 2003 Mercedes-Benz S-Class

2 Answers

I have a 2000 explorer xlt fuse keeps blowing on door locks


The same key should be the same for all doors.

May 12, 2010 | 2000 Ford Expedition

1 Answer

Power door locks stopped working


power windows will not work on driver side; what can i do to get the windor up until i find a replacement part

Dec 18, 2009 | 1998 GMC Yukon

1 Answer

Remote start function on remote doesn't work for a 2005 Pontiac G6.


Replace battery first and see if that help, if not then follow steps below, if you cant figure it out or it still doesn't work, or take it to the dealer, it could be remote module is faulty. Keep the windows open as a safety measure, then,

Remove the ignition key from the ignition lock cylinder.

Remove the BCM PRGRM fuse from the fuse panel. Refer to Fuse Block in Wiring Systems.

Close all of the doors.

Close the liftgate.

Turn the ignition lock cylinder to ACC.

Turn the ignition lock cylinder to OFF, & then back to ACC within 1 second.

Open & close any vehicle door. A chime will be heard when the system enters the BCM programming/diagnostic mode.

Important
After 7 seconds, a chime may be heard confirming successful synchronization. It is necessary to wait approximately 14 seconds for a second chime that will confirm successful programming.


Press & hold the transmitter LOCK & UNLOCK buttons simultaneously for 14 seconds.

Repeat the previous step on each additional transmitter to be programmed.

Remove the ignition key from the ignition lock cylinder.

Install the BCM PRGRM fuse back into the fuse panel. Refer to Fuse Block in Wiring Systems.

Oct 07, 2009 | 2005 Pontiac G6

1 Answer

Door lock dont work and remote lock does


Look under the Hood and Locate the Fuse Relay Box. Should be on the Drivers side torwards the Firewall. There is a Relay in it for the Door Locks. Replace this Relay and see if they will not work. Also check the Fuses in BOTH Boxes inside and under Hood with a Flashlight and Make for Sure that no Fuses are Blown. Please Rate My Response! Thanks!

Feb 06, 2009 | 2004 Pontiac Vibe

2 Answers

Keep blowing out auto door lock fuse


You have a short Somewhere. Check inside the Door where the Harness goes into the Doors. It is the Black Flex duct that looks like a Vacuum hose.

Jan 19, 2009 | 2004 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...