Question about 2004 Chevrolet TrailBlazer

3 Answers

2006 Chevy Trailblazer - winding noise

I have a 2006 Chevy Trailblazer and over the last few months I have been hearing a winding noise similar to a power steering noise. It gets lauder when I press the accelerator regardless if I am in gear or sitting in neutral.

Would you suggest replacing the power steering fluid?

Posted by on

  • 2 more comments 
  • jones9413 Feb 09, 2009

    I have a 2006 with the same problem.

  • Anonymous Feb 20, 2009

    Wining noise from engine that has benn getting louder. Noise will increase when engine rpms are increased. Suspect pully or alternator.

  • Anonymous Mar 17, 2014

    04 trailblazer, leaking power steering fluid badn near drivers tire

  • Anonymous Mar 20, 2014

    it has a humming noise and the check engine light is on

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I went to the dealer to check on the price for the idle pulley and they said that was waht the problem was. The quote from them was $99 for Labor and $38 for the pulley..Solution $18.00 at the parts store and 20 min from my hubby and it is fixed. The only problem with the pulley form the auto parts is that the original washer won't fit in the hole so we had to but a seperate washer. Runs great now I just have to find a solution to the gas gauge and fuel sensor.

Posted on Mar 05, 2009

  • ZURVITA73 Nov 10, 2010

    This is great news for me! I have a 2006 Trailblazer, and it has had this same noise for a while now, and i was thinking it was coming from the transmission. This site is AWESOME ! !

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,450 Answers

You probably have a idler pulley or alternator with a bearing going bad. remove belt and spin the pulleys and see if you see one that feels rough

Posted on Jan 02, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I HAD THE SAME PROBLEM A FEW WEEKS AGO, AND IT WAS THE LITTLE ROUND WHEEL LIKE THING THAT THE BELT GOES AROUNG.

Posted on Mar 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Abslight stays on. How to fix? This is a2007trailblazer?


First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit

Dec 30, 2016 | 2007 Chevrolet Trailblazer

1 Answer

I have a 06 Chevy trailblazer and the 4wd/auto switch is gone and it has been jumping from 4wd to auto . What do I do to fix it, I don't think a new switch is the fix


Most likely the control module assembly is the problem. It can be located under the dash and sometimes behind the passenger kick panel cover. You will normally hear a click noise when you engage the 4x4 and this click noise will indicate the location of the controller. You may not be able to access 4x4 hi if the lights are flashing but 4x4lo usually works.

Apr 25, 2015 | 2006 Chevrolet Trailblazer

1 Answer

I have a 2006 Chevy trailblazer in the last few months everytime I drive and get odd expressway and make a complete start like at a stop sign when I hit the gas to go the car jerks. We got a new...


I am new at this but it sounds as if the fuel filter or pressure is off, but it also could be the catalytic converter in the exhaust

Jan 24, 2015 | Cars & Trucks

1 Answer

2006 Chevy Trailblazer...the top "third"


Brake light problem - if bulbs and fuses (#34 and #43 in rear fuse panel) are good, then only other possibility are the circuit boards where all the tail lights are located.

Noise coming from rear is the mode control actuator in the rear HVAC unit, it is trying to move a stuck blend door.

Aug 06, 2011 | 2006 Chevrolet Trailblazer

1 Answer

2006 Chevy Trailblazer makes THUD when accelerating


Check your coolant level, low coolant or air in your cooling system will make a "thud"noise in your heater core when the engine is under load from acceleration. The coolant rushes in to the heater core where the air pocket is trapped and then your hear the noise.
Start with the simple and make sure your coolant level is correct and then try to purge the system to remove the air out for your coolant system.
Thank you for using fixya and good luck

Jun 15, 2010 | 2006 Chevrolet Trailblazer

1 Answer

Need 3 point front seat, sensored seatbelts for '06 Trailblazer


for starters seatbelts do not have abs,you just need to get seatbelts that fit the anchorages so if chevy also make a trailblazer for another badge chances it will also fit(chevrolet in the uk sourced from korea)

Mar 20, 2010 | 2006 Chevrolet Trailblazer

1 Answer

I have a 2006 Chevy Trailblazer and the electrical system in my car is acting up badly. Sometimes the window will work and sometimes they won't, my dash boardlight all came on at once, the locks have a...


You've got a ground problem (lack thereof) somewhere. Will be a lot of wire tracing/test for your average Joe, should probably just see a mechanic.

Sep 29, 2009 | 2006 Chevrolet Trailblazer

1 Answer

Metal noise when reversing front driver side tire chevy trailblazer 2006/


One common reason is a loose heat shield. Weld may have broken. You may be able to bend it enough to stop it rattling against whatever it's coming in contact with.

May 06, 2009 | 2006 Chevrolet Trailblazer

1 Answer

Wind noise


I would check all window and door seals.

Mar 31, 2009 | 2006 GMC Envoy

1 Answer

2002 Chevy TrailBlazer Service Engine light is on. The car gives off a loud wind sound when pressing the accelerator. The engine runs smooth but less power.


This one is easy. The clutch fan is not disengaging. Mine does the same thing after it has idled a while but then will release (wind noise stops) after getting up to speed.

Jul 21, 2008 | 2002 Chevrolet TrailBlazer

Not finding what you are looking for?
2004 Chevrolet TrailBlazer Logo

1,424 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

71338 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7018 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...