Question about 2008 Chrysler Pt Cruiser

1 Answer

Disable horn upon locking doors

I don't have an owners manual so can you tell me how to disable the horn sounding when you lock the doors with the key fob?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Optional settings under driver control? deepthink

Posted on Apr 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Can I disable OR remove the anti-theft device?


Do you have the remote keyless fob? Old contacts can cause this...replace the keyless fob...parts stores about $15....be sure to clean the circuit board on the chip...you will use this in the new shell that comes with new touch buttons...

Sep 30, 2015 | 2005 Buick Century

1 Answer

Can the 2005 Chrysler Crossfire chirp the siren on remote door lock?


yes you can disable this see the local auto leck buy or the dealer

Dec 04, 2014 | 2005 Chrysler Crossfire

1 Answer

How do we disable the central locking of doors in a 2006 Ford Transit van


If the system can be programmed to not lock it will be in the owners manual. If you don't have one go here and download one from Ford, it is free. I think it is a bad idea to disable this due to a family member being car jacked because the passenger's doors where unlocked.

Nov 05, 2012 | Ford Cars & Trucks

1 Answer

94 VW Golf horn stays on with fuse pulled, I just got this car and tried to install a new battery when I connect it the horn sounds.I checked the fuse panel and pulled # 13 that was for the horn and it...


What your hearing is the factory alarm not the horn. Connect the battery when the alarm sounds go to the drivers door lock with the key and lock and unlock the door until the alarm goes off . Then reinstall the fuse for the horn.,

Feb 15, 2011 | Volkswagen Golf Cars & Trucks

1 Answer

If I unlock car with key, horn blows. If I start vehicle, it starts okay but shuts off immediately afterward. I tried unlocking manually, then relocking manually. Batteries are NEW in remote and Reily's...


did you try doing that with other door?if not i would try then unlock doors then if horn don't blow put key in and cycle 3 times then turn off wait a few then start you may also find a reset procedure in the owner manual hope this works 4U if it dos please share it with us thank you

Mar 12, 2010 | Dodge Durango Cars & Trucks

1 Answer

REMOTE KEY LOCK DOES NOT WORK BATTERYS NEW BUT ALARM WILL NOT SHUT OFF WHEN FIRST START .HOW CAN I DISABLE ALARM


Synchronization
When
Key buttons operated repeatedly while vehicle out of range and system becomes inoperative.
How
Carry out the following within 1 minute: Press key lock or unlock button for approximately 1 second. Manually lock or unlock vehicle. System should now lock or unlock vehicle. If not, carry out programming procedure.
Programming
When
Key added or replaced. System malfunction.
How
Switch ignition ON. Insert key to be programmed into driver's door lock. Lock vehicle manually. Press lock or unlock button. Wait at least 1 second. Press lock or unlock button again. Vehicle horn sounds to indicate correct programming. Remote controls can also be programmed using diagnostic equipment.
NOTE: A maximum of 4 keys can be programmed

Feb 09, 2010 | 2000 Volkswagen Beetle

1 Answer

My horn used to honk when I locked my 1999 Jeep with the remote


If you have your owner's manual, there is a section that will tell you the exact sequence to press to enable/disable the horn bonk. It has three settings, chirp, honk, and off. The chirp is a really quick chirp of the horn. Honk is a longer honk. Off seems to be what you've set.

I hope this helps.

Aug 20, 2009 | 1999 Jeep Cherokee

2 Answers

Anti-theft system stuck triggered


Anti-theft does not disable the lock cylinder itself it only keeps vehicle from starting,lock cylinder will still turn and energize the electronics. Sounds like you have a stuck tumbler in the lock cylinder itself,some times turning steering wheel with one hand while trying to turn the key with the other will free it up.

Jan 31, 2009 | 2005 Mercury Mariner

1 Answer

2001 Ford Taurus auto locking door lock programming


CLICK HERE for the owners manual you require.

The instructions can be found on page 78.

There are 2 methods to enable/disable this feature. One through your
dealer and the second with a door lock sequence using the following
instructions:
1. Turn the ignition key to RUN, then press the door UNLOCK control
button 3 times.
2. Turn the ignition key to OFF, then press the door UNLOCK control
button 3 times.
3. Turn the ignition key to RUN, within five seconds press the door
UNLOCK control button 1 time.
The user should receive a horn chirp to indicate the system has been
altered.
Pressing the power door UNLOCK control button again will toggle the
Autolock/Relock states.
² Turn ignition to OFF to exit.


Thank you for using FixYa - A FixYa rating is appreciated!!

Jan 28, 2009 | 2001 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

553 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...