Question about 1997 Mercury Cougar XR7

1 Answer

1995 Crown Vic. Heater blowing cold air

I just got a 1995 Crown Vic. I had the radator coolent flushed and now the heater blows cold air? It was working fine before this service. Can anyone help?

Posted by on

  • New CV Jan 05, 2009

    Outstanding outcome, I took the car back to the shop and explain the problem. They made the statement that there was air in the system and they repeated the service at no cost to me. The heater works just fine now. I really like my Crown Vic. its not the best looking car however the performance and ride on these cars are outstanding.

  • Anonymous Mar 24, 2014

    heater blowing cold air

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 152 Answers

They radiator flush has created a blockage in the heater core that creates the heat. you dont want to replace this part because it can get $$$$. i would take it back to the shop and have them try the service again( at no charge) to see if it can remove the block

Posted on Jan 02, 2009

  • lee r
    lee r Jan 05, 2009

    im glad that it worked for you, but yea crown vics are good car, thats why the police use them for there duribilty

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater not blowing hot air


Flush out heater hoses.Could get clogged up after a while.If you don't use coolent in the cooling system.

Jan 06, 2014 | Chevrolet Tahoe Cars & Trucks

1 Answer

Heater blows warm at an idle but cold when driving


Does it take a long time to warm up the engine?

Apr 11, 2013 | 2002 Ford Crown Victoria

3 Answers

Heater blows cold


To troubleshoot this types of problem,click the link below :----http://howtobyme.blogspot.in/2012/02/heater-blows-only-from-defrost.html
--------Go through the procedure to confirm the issue.------
Engine Overheats and heater blowing cold? http://howtobyme.blogspot.com/2011/11/engine-overheats-and-heater-blowing.html
---------Heat blows cold on drivers side and hot on passenger side? http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html
-----------
This will help.Thanks.

Feb 15, 2012 | 2003 Buick LeSabre

1 Answer

Heater blows cold air


ok so the heater draws heat from the engine and if the engine dose not heat up anuff it will only blow cold air the reason the engine may not be getting worm is because the thermostat may be stuck open

Jan 27, 2011 | 1995 Ford Crown Victoria

1 Answer

My 99 pontiac montana has a heater problem.after engine is warm the heater blows warm air for a few minutes and then blows cold for a few minutes and then warm again. sometimes it blows warm for a few...


I would change the Thermostat. if that doesn't fix it? I would buy a Radiator flush and follow the directions exactly you will be surprised how much junk comes out. That should fix all your heat problems.

Jan 07, 2011 | 1999 Pontiac Montana

1 Answer

The heater in my 2002 Expedition quit blowing out hot air. We flushed & filled the radiator, took the hoses off and ran water through the heater core and finally changed the thermostat. Still after...


two things that I have seen cause that problem is the blend door get stuck or stop working and the Heater Control Valve go bad and stop the hot coolent from going to the heater core. I hope this info helps

Dec 10, 2010 | 2002 Ford Expedition

1 Answer

I just got a 1995 Crown Vic. I had the radator coolent flushed and now the heater blows cold air? It was working fine before this service. Can anyone help?


Take cap off rad when cool enough to do so. Start the car with cap off & heater turned on,(not defrost) and let it run for a while, as in wait for rad fan to come on 2 or 3 times. Add coolant/mix as needed while doing so. My guess is that you have an air lock in cooling/heating system that hasn't been bled out yet. Once in a while just rev engine a little, for about 30-second to 1 minute to increase flow through system, to help bleed & circulation. You should start to feel heat coming. Only put rad cap back on after rad fan has come on after 2nd or 3rd time. Check return bottle & fill it to mark as specified. If that doesn't do it, take it back to guy who flushed it, he should know what he did wrong.

Jan 02, 2009 | Ford Crown Victoria Cars & Trucks

2 Answers

Heater blows cold on 02 chevy silverado 1500 4.3 V6


i had the same problem with my 2000 chevy truck!! i took both hoses off engine and flushed the heater core with water and air frome air compresser,added new coolent and it works perfect!!!! so try flushing your system............

Nov 17, 2008 | 2002 Chevrolet Silverado 1500HD

2 Answers

Heater blows cold air


possible stopped up heater core. disconnect hoses to core and backflush core.flush out radiator and engine block also.

Jul 27, 2008 | 2002 Toyota Celica

Not finding what you are looking for?
1997 Mercury Cougar XR7 Logo

290 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...