Question about Hyundai Accent

Open Question

Hand brake adjustment on 1.4hyundai getzhow do i fix there is to much travel.

Posted by on

4 Suggested Answers

mosesclive
  • 191 Answers

SOURCE: Handbrake Adjustment

Refer to this site

http://www.fordscorpio.co.uk/adjhandbrake.htm

Posted on Jul 25, 2008

  • 3 Answers

SOURCE: chrysler voyager drum brakes excess hand brake travel no adjuster how can a take up slack

yes there are brake shoes in the hub. we have just replaced ours also links and still there is travel. mot just hours away, as failed last time. My hubby is now in pouring rain trying to adjust. Also the lever now only has a few clicks as adjusted cable at lever but still no handbrake at wheels.

Posted on Sep 05, 2008

  • 1 Answer

SOURCE: hand brake requires adjusting

Hi
how do i adjustthe hand break cable on my peugeot 405
thanks
P.S my e-mail mrs1342@yahoo.com

Posted on Feb 04, 2010

mgomez0824
  • 351 Answers

SOURCE: I have a Mistubushi Diamante

go in reverse and slam the brakes on should adjust them..

Posted on Jan 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is wrong with the hand brake on my vauxhall vectra C 1.9 fitted new pads and handbrake cable still comes up too high


Hello David, there will be an adjuster but (depending on the age of the vehicle) it might be self adjusting or manual.
Contact customer service : Ask Question Get an Answer ASAP

Jun 15, 2016 | Vauxhall Cars & Trucks

4 Answers

Handbrake Adjustment


site for handbrake adjustment
www.fancyacar.co.uk/car-maintenance/handbrake-adjustment/
goodluck!!!

Jul 25, 2008 | 2003 Toyota Camry

1 Answer

1.9vauxhall vectra C fitted new pads and hand brake cable now handbrake has too much travel same as before items were fitted


it looks like a common flaw in design
it can fail an mot if handbrake wont hold
with both wheel of the ground and hand brake fully applied do the wheels spin

handbrake cable system on a
1.9vauxhall vectra C says self adjusting

but this picture implys there is an adjustment point
source
Thread Handbrake adjust


you tube vectra handbrake system in action

Opel vectra handbreak



26219124-ygof5331xb1wvnadk5rotqyb-1-1.jpg

Jun 15, 2016 | Cars & Trucks

2 Answers

Noticing a little more travel on brake pedal and handbrake lever and wonder whether some adjustment can be made to reduce this travel on brake pedal


your rear brakes are worn or the self adjusters are rusted, assuming you have drum rear brakes & not disc pads in the rear.
Try backing up several times with very hard stops to activate the self adjusters. If you don't back up much, the self adjusters can not work. Parking brake will be adjusted at the same time.

please rate.

Feb 16, 2011 | Mazda Tribute Cars & Trucks

2 Answers

How do i adjust the handbrake


TO ADJUST HAND BRAKE YOU HAVE TO REMOVE THE CONSOLE.TO ADJUST HANDBRAKE CABLE.ONCE CONSOLE REMOVE YOU WILL SEE A LOCKNUT.LOOSEN LOCK NUT WHILE HOLDING THE ADJUSTING NUT WITH A WRENCH TIGHTEN THE ADJUSTING NUT UNTIL THE DESIRED TRAVEL IS ATTAINED.THEN TIGHTEN THE LOCKNUT.

Oct 01, 2010 | 2001 Kia Rio

1 Answer

How to set up new brake shoes on volvo 850,they keep jamming when traveling forward but not reverse,


removedisc/drum check to make sure linings are secure on shoes bonding can fail this will cause brake to lock make sure shoes are secure on backplates hold down clips can go weak also make sure pull off springs are not weak loosen hand brake adjuster fit drum adjust up shoes on adjuster wheel till brake locked then back off so wheel spins freely re-set hand brake cable

Jan 24, 2010 | 1996 Volvo 850

2 Answers

How do I adjust the parking brake cable on a 1991


If the car has a center console between the seats, and the e-brake lever is there, remove the console there should be a bolt to tighten or loosen. Loosen it with the lever DOWN, pull the cable as tight as it will go with your hand and a pair of pliers. Holding the cable in place tighten the bolt or nut that secures the cable. If this doesn't fix it, have your rear brakes inspected and/or adjusted.

Oct 03, 2009 | 1991 Mercury Tracer

1 Answer

How do you adjust a 2003 honda crv hand brake i have replaced the back pads but the hand brake has too much travell and it appears the hand brake does not have a cable going to the back brakes so how does...


It should have e-brake cables going to the rear,and to adjust the handle there is an adjuster on the bottom of the handle under the console it will take a four way screw driver and a 12mm wrench to fix your problem hope this helps you!

Apr 22, 2009 | 2003 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

664 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...