2007 Toyota camry push button. Lights on are VSC, Warning, and stability
Whenever
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults and others) as long as the light is on. You must
now have the dealer hook up a special electronic diagnostic tool and
"scan" the system for the fault code that is stored for the
problem(s) Legend
of Abbreviations. ABS Antilock brake system.TCS Traction control
system, TCM Transmission control module, SRS Supplemental restraint
system, BCM Body control module
SOURCE: Why is the vsc light check engine light and trac
to reset for a momentany malfuntion,disconnect the negative battery terminal few minutes, reconnect,start engine and drive to check
SOURCE: VSC and engine light on
The Trac light comes on automatically, in conjuction with the Check Engine Light. You need your vehicle scanned for DTC codes.
SOURCE: My 2007 Toyota Tundra 4.7l shows VSC OFF lights
check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me
SOURCE: 2004 Toyota 4Runner, Regarding The VSC TRAC and VSC OFF lights
Check your switches for the VSC, some get bumped on (due to their location) and some get stuck in the "on"position.
SOURCE: 2001 Toyota Sequoia VSC and TRAC OFF lights are on
I did research on line and all indicates that is caused by the YAW RATE SENSOR. It nedds to be replace and adjust. I have the same problem but havent find the time to get to it. When I do I will post it. If you do it before I do please email me with the result at [email protected]
Good luck
1,187 views
Usually answered in minutes!
×