Question about 2000 Isuzu Trooper

1 Answer

1993 isuzu bighorn fwd indicator blinks in 2H

The fwd indicator on my jdm 1993 bighorn blinks when the transfer case is in 2H. i have repeatedly tried the procedure to disengage four wheel drive by putting it in 4H, driving a few meters before shifting to 2H and reversing to no avail. i had read in itoc.uk that it could be a vacum leak in the front diff. drive line system. checked the electrical and vacum connections but could not find anything wrong. how do i correct the situation.

Posted by on

  • Anonymous Mar 13, 2014

    Just bought a Myvi Ezi 2009 from used car. My car OD meter keep blnking after I took home the car and the car automaticaly in the OD mode. Had to shut off the blinking by disengaged the battery. Keep on blinking again when drive. Solution please.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have 3L diesel manual gear 2000. Happened once after the FWD vaccumed operated fork mechanism in the front axle got a very small kick and bent very little. This happened by some sand that entered between the front plate protection and theFWD mechanism. I had to opeb and ground the shaft end. Vaccum was OK.

Posted on Feb 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transfer cases


move to dirt,sand,gravel, grass, select 2H and it will now come out.
this is called wide up, on all part time 4wd, and wind up, locks the shifter rails. (never use 4H on dry (no ice) pavement
are you on pavement , you never said, as it is and offroad car.)

Mar 31, 2014 | Isuzu Trooper Cars & Trucks

1 Answer

1993 isuzu bighorn diesel engine holds revs to 3000 rpm for about 30 seconds and then dies


Do you think the primary fuel filter under the tank could be blocked or water is in the fuel?

Mar 25, 2014 | 1993 Isuzu Trooper

1 Answer

1995 Dodge Dakota V8 4x4 transfer stuck in neutral


hi i have a problem with my 2003 dodge Dakota i have it in 2h but it switches into fwd on its own can anyone help me with this problem

Sep 16, 2012 | 1995 Dodge Dakota

2 Answers

Isuzu bighorn transmission light keeps blinking


When this light blinks it indicates a problem exists with the electronically controlled transmission, have it scanned for the fault code that is store in the control module.

Feb 20, 2012 | Isuzu Ascender Cars & Trucks

1 Answer

1993 Isuzu Bighorn starting problems


The breakdown service in Nz says it is a problem with the auto transmission being a switch which is not acknowledging it is fully engaged in park, therefore, wont start. I have similar problem, he says to start it in Neutral when this happens. Not sure if this will work for you, but worth a try.

May 09, 2010 | 1993 Isuzu Trooper

1 Answer

Speedo stopped working


check wire/wiring connector on right rear section of transfer case.
disconnect wire connector and remove and inspect gear drive for worn teeth including gear inside case.

Jul 29, 2009 | 1992 Isuzu Trooper

1 Answer

Canadian standard replacement headlight for '93 isuzu bighorn


it is more than impossible to find them used, you may have to buy them new from the dealer, tell them what you are doing and they can sell you the correct assembly.

Nov 26, 2008 | 1993 Isuzu Trooper

1 Answer

Transfer case shifting


2H is neutral because only 2 wheels driven....the rear ones.....transfer case is free-spinning with non-driven front wheels now....maybe the light bulb burned out?

May 21, 2008 | 2002 GMC Sierra 2500HD

Not finding what you are looking for?
2000 Isuzu Trooper Logo

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...