So after you push the button and then press the set button in the steering wheel it does not get into cruise control ? It sounds like a minor electrical problem. If you have warranty still I think the dealership should fix it for free.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The following is from 2002 Honda Odyssey factory manual page 20-70: Driver's switch panel removal. (This is the switch panel to the left of the steering wheel with TCS, cruise control, mirror, and sliding door switches.) Gently pull on the driver's switch panel bottom right corner to release the (2) right side clips, then detach the remaining (2) clips on the left side and the single top center clip. If equipped, disconnect the cruise control main switch connector, TCS switch connector, power mirror switch connector, and power sliding door connector, then remove the panel. Once the panel is removed, you can push out the switch from the rear. The switch has two bulbs in it, one is the cruise switch backlight bulb and the other is the cruise control function bulb.
check all your fuses first then take a look at the brake switch and there is a criuse cancel switch also, i think there may be a problem with the switch,even if the cancel switch was bad i think the power would still stay on but cruise would just stop and power would stay on. check fuses and switches anyway to be sure then take a look at the power switch.
Should be a operater manual with car, if not, the left side of steering wheel is a small handle. On the end is a button. In the middle is a "resume" switch that is pussed with your thumb. While driving push the end button, the car should engage and power without your foot on the peddle. To go faster push the middle switch with your thumb toward steering wheel and that will increase the speed. When you put on the brake the cruise control should dis-engage. Need to practice with this on a safe road. You may need to go at least 40mph for it to operate. When the cruise is engaged a dash light should come on saying "cruise" - Good luck
Look for the obvious. Check for the cable that goes to the throttle to see if it came off or broke. Also look for any leaks in the vacuum system. A small leak will cause it not to work. The unit may be engaging but with one of these problems, it just won't work.
most likely the clock spring is not the problem because when u push the button the dash light cruise comes on.wich means that you do not have an open circuit.with a light tester check to see if you are getting power to the cruise control servo.if you are then replace it.if no power you will need a new cruise control stick on the steering column.
Pull up on the brake pedal. If that does not work check your brake light bulbs (LED brake lights will also keep your cruise control form working). Finally check all of the fuses. This system needs at least 3 different fuses to work properly.
Yes, it probably is the brake switch. It must be working properly for the cruise control to work. If the part you got did not come from a car with cruise control, it will only have two electrical posts and not the four that you need.
If it is the right part, it must be turned in until the button is pushed completely, but not so far that it begins to actuate the master cylinder. Please report your results.