Question about 1991 Plymouth Acclaim

2 Answers

1994 Plymouth acclaim

None of my lights work but the hazards

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

I had this same problem with my 91, i had to replace the ignition swich it was about $40 dallors at autozone i replaced the key tumbler too it was another $20. To replace it disconect your battery remove the tilt handle on the colum by unscrewing it by hand. then your going to need a torx t20 bit to remove the five screws on the bottom of the colum and to remove the ignition swich. you have to disconect the two wire conecters to the swich as well. if you decide to remove your tumbler turn the key to off press in on the retaining pin on turn the key to on then back to off and it should slide rite out.

Posted on Feb 19, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 188 Answers

Check your fuse panel first. If not no problem there. Then need to check your dimer switch. That will make your light stop working. If not that, it has to be the main light switch.

Posted on Feb 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do 1994 Plymouth Acclaims have reverse light switches? The reverse lights stopped working on mine.


there should be reverse light switches but it may activate through the TCM unit or light control module.

Aug 12, 2015 | 1994 Plymouth Acclaim

1 Answer

1994 plymouth acclaim wont start


maybe the starter ...check fuse ..try to start on nutral

Apr 19, 2012 | 1994 Plymouth Acclaim

1 Answer

Need diagram for belt routing on 1994 plymouth acclaim my email is


The diagram for belt routing on 1994 Plymouth Acclaim.


3048038.jpg

Aug 17, 2010 | 1994 Plymouth Acclaim

1 Answer

Hazard light stays on and wont turn off plymouth acclaim 94. can you help. just replaced battery and problem happened


there is a switch for them to turn on and off. I think it's a push button. do you have a owners manual? it will tell you where it is.

Feb 25, 2010 | 1993 Plymouth Acclaim

1 Answer

94 Plymouth acclaim speedometer and dash lights wont work


Try replacing light bulbs and flasher which may correct the turn signals. Check all fuses, however as for the speedometer, the plastic clogs or wheels have run their course, If you intend to replace these, suggest you purchase a repair manual for your vehicle.

Aug 22, 2009 | 1994 Plymouth Acclaim

1 Answer

I need belt routing for 1994 plymouth acclaim alternator


This is the best I can do for you because there were a few different assemblies

Link is here

Mar 07, 2009 | 1994 Plymouth Acclaim

2 Answers

Turn signal lights not working at all


change signal flasher your car has a flasher for hazard and another for signal open fuse panel put for ways on you will hear it clicking the opposite one not flashing will be the one good luck!

Dec 22, 2008 | 1995 Plymouth Acclaim

Not finding what you are looking for?
1991 Plymouth Acclaim Logo

Related Topics:

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...