- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It means the power steering pump is no longer operating and so providing the required power assistance.
You either have a power steering fluid leak in the system and much of the fluid has been lost or the power steering pump itself has failed. You should not try and drive the car when you have this problem because the steering will be far too heavy to drive safely and because if a fluid leak has run the pump nearly dry you will cause damage to the PS pump.
The first thing to do is check the power steering fluid reservoir in the engine compartment. If it is low or empty you have a leak in the system. You can refill the system with new fluid but it will continue to leak until the leak is addressed and you will have to constantly add new PS fluid. In the case of a major leak the car will not be driveable as the PS fluid will be lost very rapidly. Without fluid you will quickly ruin the pump and you will also have no power assistance in your steering.
You must check the fluid level for overfill.... preferably with cold fluid (about 3 hours of no driving, or better, overnight) and see if the level is higher than the "cold level" mark. If you recently add fluid (and the reservoir was empty) you must purge air from the system (frequently this is made with preferably cold fluid, turning the steering wheel stop-to-stop, side-to-side, about 2 times). If the steering fluid is high, drain it to obtain the normal level and then do the purge sequence. Hope it helps.
YOU HAVE A RUPTURE PRESSURE LINE IF YOU HAVE NO POWER STEERING FLUID IN THE POWER STEERING RESERVOIR.LOCATE LEAK THEN BLEED POWER STEERING SYSTEM BY ADDING POWER STEERING TO RESERVOIR.DONT OVER FILL BY FULL COLD MARK ON POWER STEERING DIP STICK.ADD FLUID TO RESERVOIR WAIT A 2 MINUTES.CHECK FLUID LEVEL AGAIN.WHEN POWER STEERING FLUID LEVEL STOP DROPPING.START ENGINE LET IT RUN FOR 10 SECONDS.THEN TURN OFF ENGINE CHECK POWER STEERING FLUID ADD FLUID IF FLUID LEVEL DROPS. WHEN FLUID LEVEL STOP DROPPING.SAFELY RAISE SUPPORT VECHICLE FRONT WHEELS.START ENGINE.NOW TURN STEERING WHEEL GENTLY FROM STOP TO STOP MEANING LEFT TO RIGHT DONT HOLD IN POSITION.LET THE STOP TO STOP BE QUICK.CHECK POWER STEERING FLUID AFTER YOU HAVE TURN STEERING WHEEL ABOUT 7 STOP TO STOP.WHEN FLUID LEVEL STOP DROPPING YOU AT HOT MARK ON DIP STICK BLEEDING PROCESS COMPLETE.TURN OFF ENGINE LOWER VECHICLE BACK TO GROUND WAIT ABOUT 5 MINUTES CHECK YOUR FLUID LEVEL.IF FLUID LOOKS LIKE A TAN COLOR.YOUR POWER STEERING SYSTEM FULL OF AIR.TURN OFF VECHICLE LET VECHICLE SET A LONG WHILE TO AIR BUBBLES SETTLE DOWN LOOK FOR LEAKS AROUND POWER STEERING PUMP FRONT SEAL AND CHECK FOR LEAKS AROUND POWER STEERING LINES.
You will have to look where it is leaking from and get it fixed. Running without power steering fluid will eventually burn you power steering pump out and yes if you power steering is that hard to turn when out of fliud, it is dangerous.
if gets low definitely a leak foam is pump mixing fluid with air roar is pump cavitation check lines or pump for leak keep fluid at recommended level air bound unit can cause steering difficulty and or failure if need have trained mech look into problem