Question about 2003 Mazda Mazda6

1 Answer

Check Engine Light shows as "AT"

My Mazda 6i is driving sluggishly when driving on the highway. I think it needs to be reset

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

Check the speed sensor on the tranny.Have the car scanned for a DTC code. Tell the person about your problem So he will check the right place. They do it free at most car parts stores.

Posted on Jan 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My fuel emission light is showing on my mazda tribute 2003. Iam just about to trade it in and am wondering if there is cheap way to get it off before i trade it in


Search Results

    Failure of EGR Differential Pressure Sensor : Mazda Tribute ...

    repairpal.com > Problems > Mazda > Tribute
    Check Engine Light and Hesitation or Stumbling While Driving on Mazda Tribute ...this is my second egr valve and car is not picking up the right sped and when ... Mazda Tribute 2003, replacing burnt DPFE, connector bunrt, Need color pinout. ... Drivetrain · Electrical & Lights · Engine · Exhaust & Emissions · Heating & AC ...

    Check Engine Light Diagnosis Cost for Mazda Tribute ...

    repairpal.com > Estimator > Mazda > Tribute
    A Check Engine Light is turned on when the Mazda Tribute engine control module detects a fault in the emissions system. One or more diagnostic codes will be

Feb 05, 2016 | 2003 Mazda Tribute

1 Answer

How do I reset the flashing system charging light?


you have a shorted diode or internal voltage regulator problem ! Is the check engine light on ? This charging system is computer controlled ! Don't just change it have it checked !

Apr 09, 2015 | 2010 Mazda 6 2.2

1 Answer

Where is the freeze plug on a 2004 mazda 6i 4 cylinder?


Looks like Mazda and Ford used same engines on different models (Jaguar too) during your year. Try searching "xw4e-ba" (engine block code) in images. Might be just in front of oil filter.
/uploads/images/freeze-plug-2004-mazda-6i-4-cylinder-35061005-5-1.jpg

Feb 23, 2015 | 2004 Mazda 6

1 Answer

97 Mazda Protege dies while driving down the highway and will not start.


check fuel pressur, filter and fuel pump...sounds like it isnt getting fuel

Sep 23, 2012 | 1997 Mazda Protege

1 Answer

2001 Mazda MPV, 2.5L eng. During accelerating on to highway, van lost power. Van continued to operate but with little power available. I have no engine light and my code "checker" shows PASS (no...


looks like not enough fuel pressure, check the fuel filter.
and the fuel pump pressure.with car running 60 psi
the pump is located at the rear seat driver side you have to remove the carpet to access the cover. if the fuel pressure checked "OK" suspect defective maf sensor (sometimes defective maf sensor do not show errors codes)another way to test is disconecting the maf sensor and start the car (computer goes to limp in mode) and works little better,or check by scanner idle= low grams per seconds and increase when accelerate.

May 02, 2017 | 2001 Mazda MPV

1 Answer

Check engine light came on this morning, mazda 3 09', it has 14,500 miles, i just got an oil change at the dealership a few days ago, also i think the gas cap was a little bit loose i noticed the last time...


I would take it back to the dealer and tell them the check engine light came on not long after oil change. Have them run the code on their dime...it's a reasonable request!

A loose gas cap will defintely trigger the engine light, but in most cases, it will reset itself within one week. Some cars don't have a reset which forces you to have a mechanic reset it for you.

Aug 12, 2009 | Mazda MAZDA3 Cars & Trucks

1 Answer

Traction control light comes on while driving in good weather


My 2002 Millenia just started doing this the other day, while on the freeway when it started doing it i would shut engine off and restart it and it would be good for a while then it would do it again, i am still looking for solution, has any one found one?

Apr 23, 2009 | 2000 Mazda Millenia

Not finding what you are looking for?
2003 Mazda Mazda6 Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

71043 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6981 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...