Question about 2007 Dodge Charger SRT8 Sedan

1 Answer

How do you adjust the parking brake on a 2007 Charger SRT8 (rear disc brakes)

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 512 Answers

The ables are basically self adjusting. you can do a minor amount of adjustment to the e brake shoes that are contained inside the rotors by adjusting the star wheel that gotten to through an access hole in the backing plate

Posted on Jan 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Parking brake won't hold even after shoes adjusted


What type of rear brakes do you have?Disc or drum.

Dec 20, 2012 | 2007 Dodge Charger SE

1 Answer

Parking brake won't hold on 2007 dodge charger


Click here to see how to adjust your parking brake.

Dec 20, 2012 | 2007 Dodge Charger SE

1 Answer

2007 dodge charger is stuck in park


Your vehicle has a brake shift interlock which simply means that it will not move out of park unless the brake is pressed in. A common cause for this to cause your interlock to cause this problem is if your brake llights are out but there could be a number of reasons for this. It's most likely electrical and you may need to have it looked at but check your fuses before you take it somewhere. it may be that simple. Below are instructions on how to override this in order to be able to shift gears and be able to drive it as well. I hope this helps and good luck.


clifford224_846.gif

clifford224_847.gif

clifford224_848.gif
clifford224_849.gif

Jun 16, 2011 | 2007 Dodge Charger SRT8 Sedan

1 Answer

How to adjust the parking brake


If this vehicle has rear drum brakes then make sure the rear shoes are adjusted properly.If this vehicle has rear disc brakes then check for adjustment screw at park brake handle and adjust as required. MOE

Jun 22, 2010 | 2006 Toyota 4Runner

1 Answer

06 charger srt8 shifter will not come out of park


the shifter release solenoid is at fault located inside the console

Feb 28, 2010 | 2007 Dodge Magnum SRT8 Wagon

1 Answer

How to remove rear rotor after wheel is off


Disc Removal
  1. NOTE: When removing the rear brake disc (2C026) in this procedure it is not necessary to disconnect the hydraulic lines.
    Remove the rear disc brake caliper (2552).
1.Remove the brake caliper bolts (2W303).
2.Lift the rear disc brake caliper off the rear disc brake caliper anchor plate (2C220aca3301.gif
  1. NOTE: If the rear brake disc binds on the rear parking brake shoe and linings, remove the adjustment hole access plug and contract(push back to allow clearance) the parking brake shoe and lining.
  2. Remove the rear brake disc.

Feb 11, 2010 | 1998 Mercury Mountaineer

1 Answer

How do you adjust the rear brakes on a 05 kia spectra5 ? It has disc brake front and rear.


Disc brakes are not adjustable. You may have a parking brake that is like a mini- brake shoe in the middle of the rear rotor. Those are adjustable, but tough to get at, and they rust badly. Look to see if your "cable" goes either to an arm that actuates the shoes, or if it goes to the caliper. If it goes to the caliper, you have no parking brake shoes.

Jul 28, 2009 | 2007 Kia Spectra5

1 Answer

Adjusting Padking Brake with 4 wheel disc brakes.


Hope this helps. This is out of the factory manual. Let me know if this works for you.
PARKING BRAKE NOTE: Tensioner adjustment is only necessary when the tensioner, or a cable has been replaced or disconnected for service. When adjustment is necessary, perform adjustment only as described in the following procedure. This is necessary to avoid faulty park brake operation.
  1. Raise vehicle.
  2. Fully back off cable tensioner adjusting nut at equalizer to create slack in cables.
  3. Remove rear wheel/tire assemblies. Remove brake calipers and rotors.
  4. Verify park brakes are in good condition and operating properly.
  5. Verify park brake cables operate freely and are not binding, or seized.
  6. Check park brake shoe adjustment.
  7. Reinstall rotors and make sure rotors turn freely.
  8. Reinstall brake calipers. Tighten guide pin bolts to 41 n·m (30 ft.lbs.)
  9. Reinstall wheel/tire assemblies after brake shoe adjustment is complete.
  10. Lower vehicle enough for access to park brake foot pedal. Fully apply park brakes
NOTE: Leave park brakes applied until adjustment is complete.
  1. Raise vehicle again.
  2. Mark tensioner rod 6.35 mm (1/4 in.) from edge of tensioner bracket Adjustment Mark On Cable Tensioner Rod
  3. Tighten adjusting nut at equalizer until mark on tensioner rod moves into alignment with tensioner bracket
CAUTION: Do not loosen, or tighten the tensioner adjusting nut for any reason after completing adjustment.
  1. Lower vehicle until rear wheels are 15-20 cm (6-8 in.) off shop floor.
  2. Release park brake foot pedal and verify that rear wheels rotate freely without drag. Verify pedal returns to fully released position.
  3. Lower the vehicle

Mar 09, 2009 | 1999 Chrysler 300M

1 Answer

Park Brake Adjustment



Park Brake Adjustment (Disc Brake)

Tools Required

j 21177-A Drum-to-Brake Shoe Clearance Gage

Park Brake Shoe Adjustment

Caution: Refer to Brake Dust Caution.

Important: The park brake shoes must be adjusted before the park brake cable tension is adjusted.Set the J 21177-A so it contacts the inside diameter of the rotor
  1. Position the J 21177-A over the shoe and the lining at the widest point.
  2. Turn the adjuster nut until the lining just contacts the J 21177-A. Park brake shoe to brake rotor clearance: 0.6604 mm (0.026 in)
  3. Repeat steps 1-3 for the opposite side.
Park Brake Cable Tension Adjustment

Important: Before you adjust the park brake cable tension, verify that the park brake shoes are adjusted to provide a clearance of 0.6604 mm (0.026 in) and the rear disc brake rotors are installed.

  1. Verify the self adjuster lock-out pin has been removed.
  2. Fully apply and release the park brake pedal 3 times.

Feb 22, 2009 | 2007 GMC Sierra C/K2500

Not finding what you are looking for?
2007 Dodge Charger SRT8 Sedan Logo

420 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...