Question about 2007 Hyundai Tiburon

1 Answer

Difference between hyundai 2.7v6 and hyundai 3.3 v6

Can the hyundai 2.7 v6 be upgraded to a hyundai 3.3 v6

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 69 Answers

It is the same block, different bore and stroke. You can switch them, but the internals aren't as strong in the 3.3L and the time/money/trouble you would go through to do the swap would not be worth it.

Posted on May 27, 2009

  • Christian Fobian Olsen Sep 26, 2013

    How much do you need to change in order to do the swap?

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2004 Hyundai Santa Fe with very low gas mileage.


The Fuel Economy of the 2004 Hyundai Santa Fe is listed as being 16 mpg in the city and 22 mpg on the highway.----------------------------------------------------------------------------------
Digiprog3 Odometer Correction Tool

Feb 21, 2013 | 2004 Hyundai Santa Fe

1 Answer

2004 Hyundai Sante Fe difficulty starting after fill up bulletin boards indicate that it may be a purge valve do you agree and where is this part located on the vehicle.. Thank You


Yes, the PCSV (Purge Control Solenoid Valve) is usually the cause of difficulty in starting the engine after refueling. The 2004 Santa Fe came with three different engines and this valve is located in different places on each engine (2.4 (4 Cylinder), 2.7 V6 and the 3.5 V6). Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop & owner manuals, service bulletins, campaigns, illustrations and procedures, etc

Sep 11, 2011 | Hyundai Santa Fe Cars & Trucks

1 Answer

Where is the egr vacuum solenoid located on a 2002 sante fe


The 2002 Santa Fe came with three (3) different engines - 2.4 4cyllinder, 2..7 V6 and the 3.5 V6.
Only the 2.4 lit 4 cylinder and the 3.5 lit V6 have EGR systems. The 2.7 lit V6 does NOT.
Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, illustrations and procedures, etc.

Sep 02, 2011 | Hyundai Santa Fe Cars & Trucks

1 Answer

WHERE IS THE CRANK SHAFT SENSOR LOCATED


The 2002 Santa Fe came with three (3) possible powertrains (engines). The 4 cylinder, and two different V6 engines - i.e. 2.4L 4 cylinder, the 2.7L V6 and the 3.5L V6.

The crankshaft position sensor on the 4 cylinder and the 3.5L V6 are in the same place - Front Crank Shaft behind the pully (behind the timing belt cover.

On the 2.7L V6, the Cranshaft Position Sensor is located in the engine block (Left Hand Side)
near the flywheel (adjacent to the LH (Bank 2) exhaust manifold.

Note: Left Hand Side means the radiator side (front) Bank 1 is the firewall side.

Jun 30, 2011 | 2002 Hyundai Santa Fe

1 Answer

How can I changed the timing belt


Depends on which ENGINE you have (three different engines in the 2001 Santa Fe)... I4 (four cylinder), 2.7L (V6) and the 3.5 (V6). Each has different (exact) procedures for replacing the timing belt.

Mar 24, 2011 | 2001 Hyundai Santa Fe

1 Answer

Crankshaft sensor is going bad how do i access it top change it


Which engine is it? 2.7 Lit V6? 2.4 I4 - 4 cylinder? or the 3.5 V6? Each one is different.

1. 2.4 I4, 4 cylinder - located at the front of the engine at the crankshaft (behind timing belt cover)
2. 2.7 Lit V6 - Near transmission on the left hand side in the engine block behind the right edge of the exhaust manifold
3. 3.5 lit V6 - located at the front of the engine at the crankshaft (behind timing belt cover)

Feb 07, 2011 | 2004 Hyundai Santa Fe

1 Answer

I cant take the alternator off of a 2005 hyundai sonata. i try to take off the bolt, it gets halfway off and hits the motor mount


Not possible. The 2005 Sonata came with two different engines - the 2.4 I4 and the 2.7 V6. On the 2.4 I4, the alternator is near the firewall and on the 2.7 V6 it's in the front near the radiator. Neither one is near any motor mounts. The four (4) motor mounts are located on either side of the transmission and at the engine front top and the transmission rear. Something else is in your way, perhaps the right side engine compartment side rail.

Oct 04, 2009 | 2005 Hyundai Sonata

1 Answer

Where is the computer box of the 2006 hyundai starex crdi located?


If it's anything like the Tiburon, there are two different locations, depending on which engine you have. The 2.0 liter 4 cylinder computer is located under the dash, driver's side, near the steering column shaft...



c2bde3d.jpg
On the 2.7 V6, it's located on the passenger side, front A pillar near the glove box..


10c4e45.jpg

Oct 04, 2009 | Hyundai Tiburon Cars & Trucks

1 Answer

Location of the Purge Control Valve for 2003 Hyundai Tiburon


There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:
22c99c7.jpg

And the 2.7 Liter V6:
cb31feb.jpg

Jun 06, 2009 | 2003 Hyundai Tiburon

1 Answer

Tranny upgrade - 2000 tiburon


To my knowledge, there is NOT. You'd have to swap out the entire Powertrain (a later MY 2.7 V6) and wire harness and PCM (Powertrain Control Module).

May 16, 2009 | 2001 Hyundai Tiburon

Not finding what you are looking for?
2007 Hyundai Tiburon Logo

Related Topics:

941 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...