Question about 1987 Dodge Aries

1 Answer

I have a 87 dodge aries k car 2.2 litter what does the code series of 1 5 2 2 5 5 mean

Posted by on

  • 1 more comment 
  • craig fuhs
    craig fuhs Jan 02, 2009

    its hard to start but that may be from the cold. once it starts it idles good but when im going like 45 i will push the gas all the way down and u can hear the motor like wanna go but i dont gain like any speed.

  • craig fuhs
    craig fuhs Jan 02, 2009

    its starts kinda bad but it way just be the cold. when i am going like 45 ill hit the gas all the way down and the motor will sounds like it is good and like it should be but i can hardly gain any speed

  • craig fuhs
    craig fuhs Jan 02, 2009

    ya thats sounds exactly right. thanks alot i will do that and let u know what happens

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 6,674 Answers

15- vehicle speed sensor. 22- coolant temperature sensor
55 -means end of message.
What's it doing?How's it running?

Posted on Jan 02, 2009

  • Mike Butler
    Mike Butler Jan 02, 2009

    I'd say the hard starting is because the coolant temperature sensor is telling computer the wrong coolant temperature, which in turn tells the injectors how much fuel to spray into engine. For example, it tells the computer your coolant is hot, indicating that it is already warmed up so it doesn't need as much fuel to start as if it was cold. Thus causes hard starting. Other side of that, it tells computer engine is cold all the time, thus injector sprays too much fuel, resulting in flooding, or excessive fuel usage/poor gas mileage. Change that sensor first, then see how it runs. The other (speed sensor) is probably what's giving you that holding back feeling It's telling the computer to adjust everything to one speed, when your going another. Don't think either sensor too expensive, as well as fairly easy to change in that year. Be sure when you change these parts, pull your battery terminals off (Negative first) for a couple of minutes to erase codes, then put back on, (positive first), and tighten. My guess is you'll feel like your driving a new car.

  • Mike Butler
    Mike Butler Jan 02, 2009

    One other thing, Just in case, pull your oil dipstick & smell it for gas smell. If it was sending too much fuel, it may have trickled past rings into oil pan, thus thining out your oil with gas. Not good at all, so if in doubt, when all's running well, change oil & filter, but don't go to far before you do. If you do smell or suspect gas in oil, change it before you go anywhere, and save your engine.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am currently working on a '87 Dodge Aries Le station wagon. It turns over but wont start unless you pour gas directly into the carburator but it dies seconds later. i have no idea what could be wron


I am currently working on the same car, the one im working on is a K though (wagon), but same engine. What I found the issue to be is a bad fuel line.

Dec 06, 2011 | 1987 Dodge Aries

1 Answer

Its actually a 87 dodge aries k car. My gear


I have an 87 aries wagon that it happened to. Spray lots of WD-40 on it. It is usually due to a rusty/corroded cable, and wd-40 should loosen it up. Take the cable off of the lever, and see if you can shift it out of "1st gear" if you can't or if it's tough, spray some WD-40 in/on the cable, and hold the clutch in, and shift to random gears a bunch of times. it may take a few sprayings, but if the cable isn't too far gone, you can do that. it wouldn't hurt to spray it on the lever where it pivots.

Jul 27, 2010 | 1988 Dodge Aries

2 Answers

My 87 dodge aries blower for the heater works but only has occasional heat, the heater core is not leaking


Whens the last time you checked the anti freeze /coolent level please check when COLD not hot you could get burned very badly

Dec 09, 2009 | 1987 Dodge Aries

1 Answer

Dodge aries stalls when stops


code 13 map sensor vacuum circuit. code 15 vechicle speed distance sensor circuit. code 37 transmission shift indicator light for lock up converter.

May 23, 2009 | 1988 Dodge Aries

1 Answer

87 dodge aries k car


15 is vehicle speed sensor. 22 is coolant temperature sensor.
55 is end of codes or end of message.

Jan 01, 2009 | 1987 Dodge Aries

1 Answer

Codes for 1988 dodge aries


The codes can be pulled from this car by turning the key to off on off on off on then on the forth time leave the key in the on position and observe the check engine light it will blink in two number codes for example 3 blinks then a pause and 2 more blinks would mean code #32. Here is a link to the codes table:

http://www.troublecodes.net/chrysler/95_25sfi.shtml

These codes for a 95 2.5 should be the same for your 88.

Sincerely,

JC

Nov 12, 2008 | 1988 Dodge Aries

1 Answer

1987 Dodge Aries K car


code 55 is the end code for the code test. In other words you have no codes stored in your computer.

Oct 02, 2008 | 1987 Dodge Aries

1 Answer

Wont stay running


its the map sensor 

Sep 28, 2008 | 1987 Dodge Aries

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

326 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...