What do I need to tune up my 2004 Toyota sequoia other than plugs and wires?

SOURCE: The oil gauge in my

have you changed the oil sending unit, this is the most probable cause.

SOURCE: auto speaker wire diagram

FYI - I just took our 2004 Sequoia in because of speaker rattle coming from the front door speakers. Before I could tell them the problem, they guessed what it was. They see loads of Sequoias and Tundras with JBL systems due to the front door 8in speaker, basically, coming apart. His suggestion was to replace only the bottom 8in speaker, because the top tweeters usually are in good working condition. There is a minimal failure rate on the tweeters.

SOURCE: I'm changing the spark plugs on my 2004 Toyota

First get a Autorepair manual from either Chiltons or Haynes for your toyota and look up tuneups -replacing spark plugs, this should detail everything required ,even to the firing order for the spark plugs. make sure you follow the book to the letter Or you'll be sorry.

Good luck

SOURCE: I need to remove 2004 toyota sequoia tailgate door

Slide the plastic cover off the tailgate ******** the passenger side to reveal a 10mm bolt.

Remove the bolt and the strap/

Using a flat prying instrument, remove the center trim section one the inside of the tailgate above the window.

Grab the top edges of the side trim sections on the inside of the tailgate and pull down to remove.

Using a flat instrument, pry at the bottom edge of the tailgate main trim panel, it is held on with about 12 plastic pop-in fasteners so it will take several 'pops' before it is released.

Behind that there is a metal access cover the width of the tailgate, held on by ~5x pop in fasteners and ~10x 10 mm bolts. Remove the bolts and pop the panel loose, it will hang by the wiring so support it while you do your camera work :)

The license plate trim panel, should you need to remove it, requires remoaval of the license plate.

Then remove ~3x 10mm bolts from the top of the panel, accessed from the inside.

Using long needle nose pliers compress the pop-fasteners holding the lower corners of the license plate trim panel on, being careful not to let it drop and slide down the vehicle, scratching the paint :)

Testimonial: "Very helpful. thanks"

SOURCE: I need a fusebox diagram for the inside fusebox on

its not on the inside of the fuse box cover?