Question about 2001 GMC Sierra Crew Cab

1 Answer

I NEED TO KNOW WHERE THE KNOCK SENSOR IS LOCATED ON A 2001 GMC SIERRA 1500 6.O

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 180 Answers

Shold be on passenger side or behind distributer

Posted on Jan 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where's the knock sensors on a 2007 gmc serria 1500 5.3L


under the intake plentium right in the middle of the valley between the heads. bad for wires getting corroded and rusted. it holds water in the knock sensor holes, you can buy the harness

Mar 07, 2013 | 2007 GMC Sierra 1500

1 Answer

Trying to find knock sensor


The knock sensors are under the intake manifold.

Oct 12, 2012 | 2003 GMC Sierra 1500

1 Answer

How do you change a knock sensors on my 2001 gmc 1500hd


Changing knock sensors on 2001 GMC 1500hd
1. Remove the intake manifold.
2. There are 2 sensors located on a plate under the intake manifold. These are the knock sensors.
3. Remove the wiring harness assembly from the knock sensor.
4. Install the new rear bank knock sensor and tighten to 15 lb ft.

If you find that this is information was helpfulto you, please rate me and leave a comment as this will encourage me to do morefree work for you and others. And please let me know if there's anything else Icould help you with. Without any inputswe cannot proceed assisting... Thank you for using FIXYA! Best regards,
Junior

Sep 14, 2011 | 2001 GMC Sierra 1500HD

1 Answer

Where is the knock sensor located on a 2005 gmc sierra 1500 4x4 5.3 L


Do not replace with Autozone knock sensors unless you feel like doing the job twice as I found out the hard way. I replaced mine and a week later the check engine light came back on. Went to the dealer and was told they have seen this problem many times before and to use oem replacement parts only. The two sensors and harness ran me about $230 from the dealer but no more engine light and no more sputtering. Hopefully I can return them to Autozone as soon as I find the receipts.

Apr 09, 2011 | 2005 GMC Sierra 1500HD

2 Answers

I REPLACED MY KNOCK SENSORS ON MMY 03 GMC 6.0 AND NOW IT WONT IDLE AND IT DONT HAVE ANY POWER WHAT DO I NEED TO DO?


make sure they sold you the!! right 1 first off! and make sure the wire has continuity to the plug on each and and is securely fastened to the sensor also check to see if you knocked a wire off at the ignition module that controls the dwell

Jan 21, 2010 | 2003 GMC Sierra 1500

1 Answer

I have a 2002 gmc sierra 1500, need to change the oxygen sensor, where is it located?


There are several located within the exhaust system(PIPE)You need to know witch one.

Jan 12, 2010 | 2002 GMC Sierra

1 Answer

1999 GMC Sierra 5.3L knocking sound around Catalytic Conerters? ?


on my gmc i have 2 knock sensors and im not possitive if you have two or not under your intake mani but when i replaced both mine i got the same code of low input so i took the small needle out and wire brushed it clean and also traced and ran a new wire just to be safe and that solved my problem. as for bank 1,2 if it helps any my bank one is located engine side driverside and bank2 is engine side passenger side and 3 and 4 are underneath bed side. but you can see the sensors if you look real close near the headers. hope this helps
See less

Jun 27, 2009 | 2003 GMC Sierra 1500

2 Answers

2003 GMC Sierra Knock sensor and oil pressure??


the knock sensors are located below the intake plenum,or,upper intake manifold as some call it, they screw into the lower intake, the front one is sensor 1, the rear is sensor 2. it is wise to change both if you have some miles.since you are going to be buying a gasket set to do this job.the sensors are cheaper than the gaskets.

Jun 12, 2009 | 2004 GMC Sierra 1500 Crew Cab

1 Answer

01 sierra knocking


may need to replace shocks or leaf springs.

Apr 10, 2009 | 2001 GMC Sierra 1500HD

1 Answer

Need to know where sensor 1 (oxygen sensor) on bank 1 is located


It would be on the left header pipe as you sit in the truck. Its the sensor in front of the cat

Jan 16, 2009 | 1999 GMC Sierra

Not finding what you are looking for?
2001 GMC Sierra Crew Cab Logo

308 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...